Plantronics Legend UC User Manual

Virtual Communications Express

Plantronics Legend UC Bluetooth Headset

Pair Mobile Phone

1. Power on your headset, and then:

• Tap and say Pair Mode, or

• Press and hold until you hear Pairing. While the headset LEDs are flashing red and blue,

activate Bluetooth® on your phone and set it to search for new devices.

2. While the headset LEDs are flashing red and blue, activate Bluetooth® on your phone and set it to

search for new devices.

3. Select PLT_Legend.

4. Enter 0000 if prompted by your mobile phone for a passcode. Once successfully paired, the LEDs stop

flashing red and blue and you hear Pairing Successful. Some phones may prompt you to allow access
to contacts to enable caller name announcement.

5. Make a test call from your mobile phone.

6. Press Call to end the call. The call does not end when you remove your headset.

Virtual Communications Express

Plantronics Legend UC Bluetooth Headset

Pair another Phone

After pairing your headset to your phone, you may want to pair another or new phone.

1. Power on your headset, and then:

• Tap and say Pair Mode, or

• Press and hold until you hear Pairing.

2. While the headset LEDs are flashing red and blue, activate Bluetooth® on your phone and set it to

search for new devices.

3. Select PLT_Legend.

4. Once successfully paired, the LEDs stop flashing red and blue and you hear Pairing Successful.

NOTE: Some phones may prompt you to allow access to contacts to enable caller name announcement.

2

Virtual Communications Express

Plantronics Legend UC Bluetooth Headset

Connect PC

Connect

1. Power on your headset.

2. Insert the Bluetooth USB adapter in your PC’s USB port. The LED

flashes and then turn solid blue to indicate the headset is
connected to the USB adapter. You will hear PC connected. The
LED remains solid blue when not on an active call. NOTE: Your
Bluetooth USB adapter comes pre-paired to your headset.

3. Load Plantronics Spokes software by visiting

plantronics.com/software. Click Download. NOTE: Spokes software
allows you to customize your headset’s behavior through
advanced settings and options.

4. Check your audio settings. Confirm the speaker and microphone

settings for your PC softphone are set to Plantronics BT300.

Microsoft® Windows 7

Go to Control Panel -> Sound-> Playback and set the Plantronics BT300 device as the Default
Communications Device. If you plan to listen to streaming audio, set the Plantronics BT300 device as

the Default Audio Device. This is indicated by green check mark on the Playback tab.

Go to Control Panel -> Sound-> Recording and set the Plantronics BT300 device as the Default

Communications Device.

Microsoft Windows XP

Go to Control Panel -> Sounds and Audio Devices -> Audio and set the Plantronics BT300 as the
default device for Sound Playback and Sound Recording.

5. Place a call from your computer softphone. The Bluetooth USB adapter flashes blue during an active

call.

Re-Pair Your Bluetooth USB Adapter

If your headset and Bluetooth USB adapter become unpaired, perform the following steps:

1. Power on your headset.

2. Remove the USB adapter.

3. Power on your headset, and then:

• Tap and say Pair mode or,

• Press and hold until you hear Pairing.

4. Insert the Bluetooth USB adapter in your PC’s USB port. Once successfully paired, the LEDs stop

flashing red and blue and you hear PC connected.

3