Plantronics CS60 DECT User Manual

WELCOME
CS60 DECT Wireless Headset System User Guide
Thank you for selecting the CS60 DECT™ Wireless Headset System from Plantronics.
The CS60 offers wireless, hands-free headset convenience and long range workspace mobility.
www.plantronics.com
1
DIAGRAM KEY
1
7
9
8
11
17
HEADSET
19
2
25
10
23
22
21
20
18
24
DIAGRAMS
BASE UNIT
12
13
15
16
14
6
INSTALLING A REPLACEMENT BATTERY
3
2
4
5
3
USAGE INSTRUCTIONS
UK
DIAGRAM KEY
BASE UNIT HEADSET
1 Tx Slide Switch (A-D) 2 Rx Slide Switch (1-4) 3 Speak Volume Adjust UP 4 Speak Volume Adjust DOWN 5 IntelliStandTMSwitch ON/OFF 6 Configuration Dial 7 AC Power Adapter 8 AC Power Adapter Port 9 Handset Cable Port 10 T elephone Cable Port 11 Accessory Port 12 Headset Docking Cradle 13 Charge contacts 14 Charge Indicator 15 T alk Indicator 16 Power Indicator 17 Handset Lifter (Optional)
18 Microphone 19 Speaker
20 T alk Button 21 Listen Volume Adjust UP/DOWN
22 Headset Mute Switch 23 On-line Indicator 24 Charge contacts 25 Battery Door
IMPORTANT SAFETY INFORMATION
Please read the following instructions before use: General:
Operating temperature +4C to +49C
Storage temperature +4C to +49C
The product is suitable for indoor use only
T o reduce the risk of electric shock, explosion or fire:
Use only the AC power adapter supplied part number 61634-02 (Euro) or 61635-02 (UK)
Ensure that the voltage rating (e.g. 230V 50Hz) corresponds to the local mains supply you intend
to use
Use only the correct battery type part number 62346-01
Do not disassemble the product
Keep all products, cords and cables away from operating machinery
Avoid contact with liquids
Connect the base unit only to a host terminal port explicitly designated for use with handsets or
headsets. Connection through other ports, such as data ports or line ports, may damage the product and could constitute a fire hazard. If in doubt, please contact your supplier or the supplier of the host equipment
If mains power fails, the base unit will switch to handset mode
Battery Safety:
Please observe these precautions to ensure continued safety . Misuse or mistreatment may result in fire, explosion or the release of corrosive chemicals
Battery storage temperature +4C to +49C
Battery operating temperature +4C to +49C
4
• Charge the headset battery as described in the Quickstart Guide and User Guide. Do not charge with any other AC power adapter or charger
• Do not incinerate, disassemble, bend, crush or short-circuit the battery
• Dispose of spent battery promptly and safely in accordance with local regulations. Keep battery away from children
• Exercise care when handling the battery, AC power adapter, the base and the headset. Do not short the metal contacts (on the plastic casing) with electrically conducting materials such as rings, bracelets, keys etc
• If liquid from the battery comes in contact with the eyes, skin or any other part of the body, immediately flush with fresh water and seek medical advice
• For battery replacement please refer to the diagrams on page 3 or the Quickstart Guide supplied with the product
INSTALLATION
Please install the CS60 DECT Wireless Headset System in accordance with the instructions detailed in the Quick Start Guide.
HEADSET/HANDSET SELECTION
Pressing the Talk Button (20) on the Headset selects Headset mode. The Talk Indicator (15) on the base unit will illuminate and the On-Line Indicator (23) on the headset will flash when in Headset mode. Both of the indicators are extinguished when in Handset mode.
UK
PLACING A CALL USING YOUR HEADSET
To place a call using the headset, the system must be in Headset mode. Take the handset off the hook and dial in the normal way. You will then be able to talk through your headset. When the call is complete, return the telephone handset to the cradle.
Tip: By selecting Handset mode after completing your call, you will conserve the headset battery power and extend the remaining available talktime. You can achieve this by pressing the Talk Button (20) immediately on conclusion of the call.
Note: If you have installed a Plantronics Handset Lifter (17) please refer to the section “Making a call using the Lifter” on page 7.
RECEIVING A CALL USING YOUR HEADSET
When your telephone rings take the handset off the hook. Ensure that your CS60 DECT Wireless Headset System is already in Headset mode. You will then be able to talk through your headset. When the call is complete, return the telephone handset to the cradle.
Note: If you have installed a Plantronics Handset Lifter (17) please refer to the section Receiving a call using the lifter on page 7.
5
Loading...
+ 10 hidden pages