Plantronics CS530 User Manual
CS530™
Wireless Headset System
User Guide
ContentsContents
Welcome 3
What’s in the Box 4
Base and Headset Basics 5
Accessories 6
Customize Your Headset 7
Change the Eartip 7
Position Your Headset 7
Connect Your Desk Phone 9
Connect the Power 9
Charge the Headset 9
Connect and Configure Your Desk Phone 10
Desk Phone (standard) 10
Check Configuration and Make a Test Call 11
Desk Phone plus HL10 Lifter (sold separately) 12
Desk Phone plus EHS Cable 14
Position Your Base 15
Your Headset 16
Headset Controls 16
Talk Time 16
Low Battery Warning 17
Muting Your Headset During a Call 17
Adjusting Your Headset Volume 17
Out of Range Warning Tones 17
Your Base 18
Base Phone Button and Switches 18
Subscription Button 18
Wideband/Narrowband Audio Switch 19
Auto Answer Switch 19
Daily Use 20
Place an Outgoing Call 20
Answer an Incoming Call 20
Conference Up to Three Additional Headsets 20
Troubleshooting 21
Headset 21
Desk Phone 21
2
Welcome
Congratulations on purchasing your new Plantronics product. This guide contains instructions
for setting up and using your CS530 Wireless Headset System.
Please refer to the separate safety instructions for important product safety information prior to
installation or use of the product.
The enclosed DECT 6.0 wireless product uses restricted wireless radio frequencies which vary by
country. DECT 6.0 devices are generally authorized for use in The Americas. Use of this DECT 6.0
product in unauthorized countries is a violation of law, may disrupt telecommunications networks
and devices, and can subject you to fines and penalties by regulatory agencies. For specific
countries in which DECT 6.0 devices may be lawfully used, please consult the following:
http://www.dect.org/content.aspx?id=28
3
What’s in the Box
Base
Power supply
Headset
Eartips
Telephone interface cable
4
Base and Headset Basics
Base overview
FRONT
1
2
1 Call/mute LED
2 Power on/subscription LED
3 Charging LED
4 Subscription button
5 Narrowband/wideband audio switch
6 Power jack
7 Handset lifter/EHS cable jack
8 Telephone interface cable jack
9 Auto answer switch
10 Listening volume dial*
11 Speaking volume dial*
12 Configuration switch*
* For installation set up
3
4
BOTTOM
10
BACK
6
5
8 9
7
1211
Headset overview
1
2
1 Volume up button
2 Volume down button
3 Call control button
4 Indicator light
5 Microphone
3
4
5
5
Accessories
1
2
1 Electronic Hookswitch Cable (EHS) Electronically takes your desk phone handset off hook.
Enables remote call answer/end with your headset.
2 HL10™ Lifter Automatically lifts handset and returns it to the cradle. Enables remote call
answer/end with your headset
6
Customize Your Headset
Customize the headset by changing the eartip, wearing it on the right or left
and optimizing the position of the microphone.
Change the Eartip
1 The headset comes with a pre-installed eartip. To install a different eartip see the following:
Remove the pre-installed eartip by pushing in and turning the eartip CLOCKwise, then pull firmly.
2 Choose the size and style of eartip that fits most comfortably. Align eartip tabs with notches in
headset. Push in firmly and twist COUNTER clockwise.
NOTE When installing a gel tip ensure the raised part of the eartip is pointed toward the curved
section of the headset as shown.
Position Your Headset
When you wear the headset, the microphone should rest as close to your cheek as possible
without touching. The microphone can be adjusted inward by pivoting the earpiece to optimize
the position of the headset.
1 Slide the headset over and behind your ear, then press gently toward your ear.
7
Loading...