Planet WGS-5225-8MT Users manual

WGS-5225-8MT

Industrial L2+ 8-Port 10/100/1000T M12 Wall-mount Managed Switch

Physical Port

• 8-port 10/100/1000BASE-T, vibration-proof and dustproof

M12 X-coded female connectors

Industrial Hardened Design

• 1 pair of bypass protection

• IP40-rated metal case

• Redundant power design

– 9 to 48V DC, redundant power with reverse polarity

Easily-deployed and Expanded Network

PLANET WGS-5225-8MT managed switch offers eight 10/100/1000BASE-T M12

ports and is housed in an IP40-rated enclosure with redundant 9-48 VDC power

inputs. Designed to be deployed in the industrial environments, the WGS-5225-

8MT offers wire-speed throughput, shock and vibration proong, and a wide -40° to

75°C operating temperature range.

protection

– Active-active redundant power failure protection

– Backup of catastrophic power failure on one supply

– Fault tolerance and resilience

• DIN-rail and wall-mount designs

• Supports 6000V DC Ethernet ESD protection

• -40 to 75 degrees C operating temperature

The WGS-5225-8MT offers IPv6/IPv4 dual stack management, intelligent Layer 2

management functions, and user-friendly interface. The WGS-5225-8MT is able

to operate reliably, stably and quietly in railway and other industrial applications

subject to shock, vibration and other extreme conditions without affecting its

performance. Besides, the WGS-5225-8MT with bypass relay ports ensure non-

stop data ow even in the event of a power outage.

Bypass Relay Prevents Link Failure During Power Loss

Bypass relay is set to bypass the failed switch to the next normal switch to

prevent the network from power loss. The WGS-5225-8MT supports the bypass

relay function on the one pair of Gigabit ports. When the switch is operating

normally, the Gigabit ports operate in the same way as the other ports, processing

and forwarding Ethernet packets. Bypass relay ports allow network traffic to

continue to ow in the event of a power outage. It also can go back to the normal

mode when power is back and the switch is completely booting up to avoid

another network loss.

Industrial Protocol

• Modbus TCP for real-time monitoring in SCADA system

• IEEE 1588v2 PTP (Precision Time Protocol)

Layer 3 IP Routing Features

• Supports maximum 32 static routes and route summarization

Layer 2 Features

• High performance of Store-and-Forward architecture, and

runt/CRC ltering that eliminates erroneous packets to

optimize the network bandwidth

• Storm control support

– Broadcast/Multicast/Unicast

• Supports VLAN

– IEEE 802.1Q tagged VLAN

– Provides Bridging (VLAN Q-in-Q) support (IEEE 802.1ad)

– Private VLAN Edge (PVE)

– Protocol-based VLAN

– MAC-based VLAN

– IP subnet-based VLAN

– Voice VLAN

– GVRP (GARP VLAN Registration Protocol)

• Supports Spanning Tree Protocol

– IEEE 802.1D Spanning Tree Protocol (STP)

– IEEE 802.1w Rapid Spanning Tree Protocol (RSTP)

– IEEE 802.1s Multiple Spanning Tree Protocol (MSTP),

Normal Mode

Power Normal

Power Failure

Power Normal

Power Failure

Bypass Relay

1000

Factory

Office

Control Center

E.R.P.S. Ring for Metropolitan Area Network Application

Recovery Time < 10ms

WGS-5225-8MT

Highway

PoE

Industrial 10G Switch

Industrial MAN Switch

8-Port MAN Switch

Link good

Alarm

PWR 2

V2V2V1

Ring

PWR 1

R.O.21436587

DC Input: 9V-48V

10001000

LNK/ACTLNK/ACT

10/10010/100

LNK/ACTLNK/ACT

2 4 6 8

PinCon

1 DA+ 2 DA 3 DB+

637

DD+

451

DC+

1 3 5 7

, 1.3A max.

WGS-5225-8MT

Alarm

PWR 2

Ring

PWR 1

R.O.21436587

ManagedBypass Relay Magnet Mounting

10001000

LNK/ACTLNK/ACT

WGS-5225-8MT

10/10010/100

LNK/ACTLNK/ACT

Bypass Relay

2 4 6 8

PinCon

1 DA+ 2 DA 3 DB+

637

DB4

DD+

451

DC+

Power

Normal

DC Input:

, 1.3A max.

9V-48V

1 3 5 7

Failure

V2V2V1

Power good

Power

ManagedBypass Relay Magnet Mounting

Bypass Relay

Power

Normal

Failure

Power Normal

Alarm

PWR 2

Ring

PWR 1

R.O.21436587

ManagedBypass Relay Magnet Mounting

10001000

LNK/ACTLNK/ACT

WGS-5225-8MT

10/10010/100

LNK/ACTLNK/ACT

Bypass Relay

2 4 6 8

PinCon

1 DA+ 2 DA 3 DB+

637

DB4

DD+

451

DC DC+

Power

Normal

DC Input:

, 1.3A max.

9V-48V

1 3 5 7

Failure

V2V2V1

Bypass Mode

Bypass

Alarm

PWR 2

V2V2V1

Ring

PWR 1

R.O.21436587

DC Input: 9V-48V

10001000

LNK/ACTLNK/ACT

10/10010/100

LNK/ACTLNK/ACT

2 4 6 8

PinCon

1 DA+ 2 DA 3 DB+

637

DD+

451

DC+

1 3 5 7

, 1.3A max.

WGS-5225-8MT

Alarm

PWR 2

Ring

PWR 1

R.O.21436587

ManagedBypass Relay Magnet Mounting

10001000

LNK/ACTLNK/ACT

WGS-5225-8MT

10/10010/100

LNK/ACTLNK/ACT

Bypass Relay

2 4 6 8

PinCon

1 DA+ 2 DA 3 DB+

637

DB4

DD+

451

DC+

Power

Normal

DC Input:

, 1.3A max.

9V-48V

1 3 5 7

Failure

V2V2V1

Power outage

Power

ManagedBypass Relay Magnet Mounting

Bypass Relay

Power

Normal

Failure

Power Failure

Alarm

PWR 2

Ring

PWR 1

R.O.21436587

ManagedBypass Relay Magnet Mounting

10001000

LNK/ACTLNK/ACT

WGS-5225-8MT

10/10010/100

LNK/ACTLNK/ACT

Bypass Relay

2 4 6 8

PinCon

1 DA+ 2 DA 3 DB+

637

DB4

DD+

451

DC DC+

Power

Normal

DC Input:

, 1.3A max.

9V-48V

1 3 5 7

Failure

V2V2V1

Vibrationproof and Dustproof M12 Ethernet Connector

The WGS-5225-8MT is equipped with 8-port 10/100/1000BASE-T, auto-negotiation,

vibration-proof, waterproof and dustproof M12 connector. The M12 connector

provides tight and strong connection, and guarantees stable Ethernet operating

performance in a high vibration and shock environment. It comes with the industrial

protection rating of IP67 capable of withstanding humidity, dirt, dust, shock,

vibrations, heat and cold.

WGS-5225-8MT

spanning tree by VLAN

– BPDU Guard

• Supports Link Aggregation

– 802.3ad Link Aggregation Control Protocol (LACP)

– Cisco ether-channel (static trunk)

– Maximum 4 trunk groups, with 8 ports for each trunk

– Up to 16Gbps bandwidth (full duplex mode)

• Provides port mirror (many-to-1)

• Port mirroring monitors the incoming or outgoing trafc on a

particular port

• Loop protection to avoid broadcast loops

• Supports ITU-T G.8032 ERPS (Ethernet Ring Protection

Switching)

• Compatible with Cisco Uni-directional link detection (UDLD)

that monitors a link between two switches and blocks the

ports on both ends of the link if the link fails at any point

between the two devices

• Link Layer Discovery Protocol (LLDP)

Redundant Ring, Fast Recovery for Critical Network Applications

The WGS-5225-8MT supports redundant ring technology and features strong,

rapid self-recovery capability to prevent interruptions and external intrusions.

It incorporates advanced ITU-T G.8032 ERPS (Ethernet Ring Protection

Switching) technology, Spanning Tree Protocol (802.1s MSTP), and redundant

power input system into customer’s industrial automation network to enhance

system reliability and uptime in harsh factory environments. In a certain simple

Ring network, the recovery time of data link can be as fast as 10ms.

Quality of Service

• Ingress shaper and egress rate limit per port bandwidth

control

• 8 priority queues on all switch ports

• Trafc classication

– IEEE 802.1p CoS

– ToS/DSCP/IP precedence of IPv4/IPv6 packets

– IP TCP/UDP port number

– Typical network application

• Strict priority and Weighted Round Robin (WRR) CoS policies

• Trafc-policing on the switch port

• DSCP remarking

Multicast

• Supports IPv4 IGMP snooping v1, v2 and v3

• Supports IPv6 MLD snooping v1 and v2

• Querier mode support

• IPv4 IGMP snooping port ltering

• IPv6 MLD snooping port ltering

• MVR (Multicast VLAN Registration)

Security

• Authentication

– IEEE 802.1x port-based/MAC-based network access

authentication

– IEEE 802.1x authentication with guest VLAN

WGS-5225-8MT

IPv4 Network

IPv6 Network

Application

IPv6

Stack

IPv4

Stack

Transport Layer

TELNET

WEB

SSHSNMP

ICMPTLS

DHCPNTP

IPv6 Management HostIPv4 Management Host

WGS-5225-8MT

LACPMSTP

Q-in-Q LLDPQoS

MLD

IGMP

L2/L4 Managed Switch

Network with Cybersecurity Helps Minimize Security Risks

The WGS-5225-8MT comes with enhanced cybersecurity to fend off cyberthreats

and cyberattacks. It supports SSHv2 and TLSv1.2 protocols to provide strong

protection against advanced threats. Served as a key point to transmit data to

customer's critical equipment in a business network, the cybersecurity feature of

the WGS-5225-8MT protects the switch management and enhances the security of

the mission-critical network without any extra deployment cost and effort.

Layer 3 IPv4 and IPv6 Software VLAN Routing for Secure and Flexible

Management

To help customers stay on top of their businesses, the WGS-5225-8MT not only

provides high transmission performance and excellent Layer 2 technologies, but

also IPv4/IPv6 software VLAN routing feature which allows to cross over different

VLANs and different IP addresses for the purpose of having a highly-secure,

exible management and simpler networking application.

IPv6/IPv4 Dual Stack Management

Supporting both IPv6 and IPv4 protocols, the WGS-5225-8MT helps the SMBs to

step in the IPv6 era with the lowest investment as its network facilities need not be

replaced or overhauled if the IPv6 edge network is set up.

Robust Layer 2 Features

The WGS-5225-8MT can be programmed for advanced switch management

functions such as dynamic port link aggregation, 802.1Q VLAN, Q-in-Q VLAN,

Multiple Spanning Tree Protocol (MSTP), Loop and BPDU Guard, IGMP

Snooping, and MLD Snooping. Via the link aggregation, the WGS-5225-8MT

allows the operation of a high-speed trunk to combine with multiple ports such as

a 4Gbps fat pipe, and supports fail-over as well. Also, the Link Layer Discovery

Protocol (LLDP) is the Layer 2 protocol included to help discover basic information

about neighboring devices on the local broadcast domain.

– Built-in RADIUS client to cooperate with the RADIUS

servers

– RADIUS/TACACS+ users access authentication

• Access Control List

– IP-based Access Control List (ACL)

– MAC-based Access Control List (ACL)

• Source MAC/IP address binding

• DHCP Snooping to lter distrusted DHCP messages

• Dynamic ARP Inspection discards ARP packets with invalid

MAC address to IP address binding

• IP Source Guard prevents IP spoong attacks

• IP address access management to prevent unauthorized

intruder

Management

• IPv4 and IPv6 dual stack management

• Switch Management Interfaces

– Telnet command line interface

– Web switch management

– SNMP v1, v2c, and v3 switch management

– SSHv2 and TLSv1.2 secure access

• SNMP Management

– Four RMON groups (history, statistics, alarms, and events)

– SNMP trap for interface Link Up and Link Down notication

• IPv6 address/NTP management

• Built-in Trivial File Transfer Protocol (TFTP) client

• BOOTP and DHCP for IP address assignment

• System Maintenance

– Firmware upload/download via HTTP/TFTP

– Reset button for system reboot or reset to factory default

– Dual images

• DHCP relay and option 82

• DHCP server

• User privilege levels control

• NTP (Network Time Protocol)

• Link Layer Discovery Protocol (LLDP) and LLDP-MED

• Network diagnostic

– Cable diagnostic technology provides the mechanism to

detect and report potential cabling issues

– ICMPv6/ICMPv4 remote ping

• SMTP, Syslog and SNMP trap remote alarm

• System Log

• PLANET UNI-NMS (Universal Network Management) and

Smart Discovery Utility for deployment management

+ 7 hidden pages