PLANET PL-702 User Manual

PL-702 PL-702

PLANET Technology Corporation

Tel: [phone] Fax: [phone]
Email: [e-mail] www.planet.com.tw

Quick Installation Guide

PL-702 (Twin pack x 2)

Ethe rnet Cable (Twin pack x 2)

CD-ROM

VERIFY THE CONTENTS INSIDE PACKAGE BOX

The package should contain the items plus PL-702/PL-702-KIT. If any item is missing or damaged, please contact the seller immediately.

Internet

Cable/xDSL

Modem

PL-702-A

001101010

Power Line

PL-702-A PL-702-B

Laptop

PL-702-B

Step.1 Connect one Powerline Ethernet bridge to your

ADSL or Cable modem’s Ethernet port and plug it

into the nearest power socket.

Step. 2 Plug in the second Powerline Ethernet bridge in

your room or office.

Follow the steps below to install PL-702 in the house

Step. 3 Connect the PC via the network cable to the

Powerline Ethernet bridge.

Quick GuideQuick Guide

2011-AE0340-000

PLANET Technology Corporation

Tel: [phone] Fax: [phone]
Email: [e-mail] www.planet.com.tw

11F., No.96, Minquan Rd., Xindian Dist., New Taipei City 231, Taiwan (R.O.C.)

PLANET reserves the right to change specications without prior notice. All brand names and trademarks are property of
their respective owners. Copyright © 2012 PLANET Technology Corp. All rights reserved.

The installation procedure for the Powerline Configuration utility will vary depending on which operating system you are using on your computer.

The following procedure is for installation under Windows XP. Installation on other operation system is similar.

1. Insert the CD into the CD-ROM drive to initiate the Autorun program. Once completed, a menu screen will appear.

2. Click on the “Powerline Configuration Utility” hyperlink in PL-702 field to start the installation. If the menu screen is not shown, you can start

the installation as follows.

 Click on Start Menu/Run.

 Enter “E:\Utility\setup.exe” in the appeared box, where “E” is the letter of your CD-ROM drive.

 Click on “OK” button.

3. The utility will be installed into your computer and a new icon called “Power Packet Utility” will appear on your desktop.

Further Configuration

If you want to configure more detail settings of PL-702, please refer to user’s manual on the bundled CD.

If you have any difficulty on resolving the problem while installing or using the PL-702, please contact the dealer where you purchased this product

or you can contact PLANET directly at the following email address: [e-mail]

NOTE : This utility is only for Windows 2000, 2003, XP, Vista and Windows 7.

Utility Installation for Windows

Power Packet

Utility

LED Definition

LED Status Description

On Steady on indicate the Powerline device connect to the power outlet.

Power Off Power off

Green Device in standby mode

Ethernet

Off Ethernet Link not active

Green Steady on indicates the RJ-45 port has correctly connected to the network card of your PC or the Ethernet network

Off This HomePlug Ethernet Bridge is not connected

Data

Red Minimum connection indicates weak signal and slower network speed: less than 50Mbps

Orange Normal signal with standard network speed: 50-99Mbps

Green Excellent signal with optimal network speed: 100Mbps+

Button Definition

Button Description

Reset Hold the Reset button until the status lights begin to flash.

Security

Press security button during 1~3 seconds. Join a another HomePlug AV network

Press security button more than 10 seconds Set its security to random value