– 1 – – 3 – – 5 – – 7 –
– 2 – – 4 – – 6 – – 8 –
Thank you for purchasing PLANET PCI Express Gigabit
Ethernet adapter. It is a 1000Mbps Ethernet adapter
for x1 PCI Express bus-compliant PCs. Supports AutoNegotiation for Ethernet connection. The Gigabit
Ethernet adapter provides a highly cost-effective solution
to upgrading to the Gigabit network with your existing
Ethernet infrastructures.
Package Content
1 x ENW-9700
1 x Quick Installation Guide
1 x CD-ROM
Hardware Installation
Step 1: Please turn off your PC.
Step 2: Remove any metal decorations from your
hands and wrists.
Step 3: Remove the cover from your PC.
Step 4: Locate an empty PCI Express slot and remove
the corresponding back plate. Save the screw
for use in Step 6.
Step 5: Carefully insert the Gigabit Ethernet Adapter
into the chosen slot and press rmly with
proper push to ensure it is fully seated in the
slot.
Step 6: Secure the Gigabit Ethernet Adapter with the
screw you saved in step 4.
Step 7: Replace the PC cover.
Step 8: Power on your PC and refer to next section to
install driver.
Installation on Windows 2000
1. After insert ENW-9700 into your PC and boot up.
Windows will detect it and show a dialog box below,
press “Next”.
2. Please select the rst option and click “Next” to continue.
3. Select “Specify a location” and click “Next”.
4. Please click “Browse” to nd the driver location. (Assume “E” is your CD-ROM drive, the driver can be
found in E:\Drivers\Win2K). After nd out the driver,
please click “OK” to continue.
5. Please click “Next” to continue.
6. You can see the device name in this dialog box. If
the device name is correct, please press ”Yes” to continue.