Pitco I8 Installation Manual
SRTE & SRTG I8 to I12 Computer Water Cooker: Upgrade Kit Instructions
1.A
2
Part # B8703101-CL
Tools:
#2 Phillips screwdriver
3/8” nut driver
Wire cutter
I 12 Computer Upgrade kit
I 12 Computer Upgrade Kit consists of :
1. I 12 LJS computer (P/N 60153301)
2. Fr Pnl, Shtmtl bezel, Computer plate
3. Fr Pnl, Lower panel, Switch assy
4. Rocker switch, momentary on/fill
5. Fill Label
6. Relay Board New
7. Electrical Insulating Fish paper
8. Wiring, 4 pin jumper
9. Wiring, Control wire harness
10. Wiring, Jumper 10 pin
11. New schematic label (Gas & Elec)
D Disconnect the wire harness.
Disconnect wire from S2 manual fill
rocker Switch.
1.D
E Remove computer assembly.
2. Disconnect all wire connections on
the relay board and remove the relay
board.
Computer Upgrade Kit Parts
Instructions:
********IMPORTANT*******I
1. DISCONNECT POWER to the appliance.
A With a Phillips screwdriver, remove the
2 screws from the front panel.
B Screws are located along the top edge of
the bezel.
C Pull the top edge of bezel outward.
3. Install new relay board found in the parts
kit.
3
L80-048 Rev 0 (11/07) 1
SRTE & SRTG I8 to I12 Computer Water Cooker: Upgrade Kit Instructions
5
10
Part # B8703101-CL
8. Install new front panel bezel I12 controller
4. Connect the new harness and jumper to the
relay board as shown.
4
and connect the wire harness.
9. Lift computer / bezel assembly into place
5. Connect the red wire to the liquid level
board as shown to the normally open blade.
and reinstall the two screws at top of bezel .
10. Find the new Schematic for either the Gas or
Electric model being upgraded and install on
the inside of the door.
8
6. Remove the lower bezel on the front panel
by taking 2 screws out of the bottom. Install
the new lower bezel with manual fill rocker
switch.
7. Connect the three wires remaining on the
new wire harness to the manual fill rocker
switch as shown. Beginning from the left,
the wire sequence is Brown wire,
Black/White stripe, and Blue.
7
The Rethermalizer I12 Upgrade is complete.
L80-048 Rev 0 (11/07) 2
Loading...