S R - 1 1 0 C i n e m a S u r r o u n d L o u d s p e a k e r |
P r e l i m i n a r y S p e c i f i c a t i o n s |
|
|
Developed specifically for the unique requirements of professional motion picture playback, QSC extends its commitment to the cinema market with the introduction of the SR-110 Cinema Surround Loudspeaker. As a member of QSC’s DCS Digital Cinema Speaker Series, the SR-110 offers high-power handling, excellent sensitivity and extended bass response in a very compact enclosure.
The SR-110 Cinema Surround Loudspeaker features a high-power, long-throw 10" low frequency transducer coupled with a 1" mylar diaphragm compression driver. The system’s MDF enclosure features a 15-degree down angle baffle and Array Optimized Tuning (AOT) for optimum frequency
response. The 200 watt continuous power rating and
sophisticated protection circuit built into the
crossover provide absolute reliability.
The compact black enclosure with black grille blends
into any theatre decor. A new QuickMount bracket
design allows for fast, easy and secure installation.
The loudspeaker half of the bracket comes pre-
installed on each SR-110. The QuickMount wall bracket is purchased separately to allow shipment to
the job site ahead of the loudspeakers. A traditional
U-bracket is also available in lieu of the QuickMount bracket system.
Key Features:
Parallel outputs for feeding additional units
95˚ horizontal dispersion
QuickMount bracket for fast, easy and secure installation
High-power handling capability and rugged MDF enclosure optimized for digital soundtrack reproduction
SR-110
Specifications
Frequency Range [1] (-6dB, Half space) (-10dB, Half space)
Nominal Coverage
Directivity Index
Q
Maximum Output [2]
Calculated Peak at rated power Calculated Continuous
Impedance
Maximum Input Power [3]
(100 hours of 6db crest factor IEC 268 noise spectrum)
(2 hours of 6db crest factor pink noise, 50 - 20,000 Hz, AES method)
Recommended Amplifier Power
Crossover Frequency
Recommended Processing
Connectors
Transducers
Enclosure
Dimensions
Weight
SR-110
60-20,000 Hz
50-18,000 Hz
95° horizontal X 85° vertical
(averaged from 400 Hz to 12kHz, -6dB)
6.5 dB
4.5
123 dB
117 dB
8 ohms nominal
150 watts RMS
200 watts RMS
400 watts RMS maximum into 8 ohms
2.3 kHz
Subsonic filter at 50 Hz as provided by QSC DCA amplifiers
Barrier strip screw terminals accept up to #10 AWG stranded wire, four terminals two inputs, two parallel outputs
10" long throw low frequency transducer
1" mylar diaphragm compression driver on an elliptical horn
MDF, Baffle angle is 15° downward
15" wide X 20" high X 12" deep (285mm X 508mm X 364mm)
31 lbs. (15kg)
[1]All frequency ranges specified refer to measured free field response (half space, 2π ).
[2]Calculated SPL at 1m, (half space, 2π ), speaker operating at rated RMS power with pink noise within specified frequency range.
[3]Maximum input power tested in accordance with IEC 268-5 recommendations, 50 Hz - 20 kHz band limiting, 6 dB signal crest factor.
Loading...