Pioneer SIC-671-A, SIC-871-A Service manual
IN-CEILING SPEAKER
ORDER NO.
RRV4039
S-IC871A
S-IC871A
S-IC671A
This service manual is intended for qualified service technicians; it is not meant for the casual
do-it-yourselfer. Qualified technicians have the necessary test equipment and tools, and have been
trained to properly and safely repair complex products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability of the product and may
void the warranty. If you are not qualified to perform the repair of this product properly and safely,
you should not risk trying to do so and refer the repair to a qualified service technician.
WARNING
This product may contain a chemical known to the State of California to cause cancer, or birth defects or other reproductive
harm.
/XTWWL5
Health & Safety Code Section 25249.6 - Proposition 65
/XTWWL5
PIONEER CORPORATION 1-1, Shin-ogura, Saiwai-ku, Kawasaki-shi, Kanagawa 212-0031, Japan
PIONEER ELECTRONICS (USA) INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A.
PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION 2010
K-ZZZ JAN. 2010 Printerd in Japan
1
23
1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
1.1 REMOVAL FROM THE CEILING
A
Note : Be sure to carefully remove the speaker with two
people, as the speaker may fall.
To remove the speaker from the ceiling, remove the grill
first.
(The grill is press-fit into the frame, with pieces of butyl
tape used together.)
To remove the grill, hook the special tool for removing the
grill to the holes located at the periphery of the grill, pull
the tool down so that the grill is displaced from the frame,
then remove the grill.
B
Ensure that the entire periphery of the grill is pulled
down evenly with the same force. If you pull only a
certain location forcibly, the grill may be deformed.
If butyl tape trails down from the frame, detach it from
the frame, crumple it into a ball, and attach it to the
place with a marking inside the raised part of the grill.
While one person is holding the speaker, loosen the 4
screws that secure the speaker to the ceiling until the
fixation claws fall inwards.
If a screw is completely removed, it can be returned to its
original position.
If the fixation claws get stuck and do not fall inwards,
waggle the speaker as if turning it, by holding its frame,
then remove it from the ceiling.
As the speaker is retained to a beam, etc. with a safety
belt, remove it.
4
Stud/beam
Safety belt
(not supplied)
C
Grille removal tool
Fixing bracket
Be sure to note the combination of colors of the speaker
cables and input terminals so that the cables can be
connected to the proper terminals during reattachment.
Item Grille removal tool
Model No. GGP1135
Purpose To remove the grille out
Disconnect the speaker cables from the input terminals.
(For removal, while pushing the button of an input
terminal, pull out the speaker cable.)
Grille removal tool
D
Be sure to note the location of the Pioneer logo for
confirmation of the orientation of the speaker for later
reattachment.
Rotating clamp
E
Speaker frame
Screw
F
2
1234
S-IC871A
Loading...