SDV-620
Subwoofer
Front / Surround
Center
S-DV620
SPEAKER SYSTEM
S-DV620 XTW/UC
ORDER NO.
RRV2666
65S
This service manual is intended for qualified service technicians; it is not meant
for the casual do-it-yourselfer. Qualified technicians have the necessary test
equipment and tools, and have been trained to properly and safely repair complex
products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability
of the product and may void the warranty. If you are not qualified to perform the
repair of this product properly and safely, you should not risk trying to do so and
refer the repair to a qualified service technician.
WARNING
This product contains lead in solder and certain electrical parts contain chemicals
which are known to the state of California to cause cancer, birth defects or other
reproductive harm.
Health & Safety Code Section 25249.6 – Proposition 65
FOR PRECAUTION OF
REASSEMBLY AND DISASSEMBLY
CS Assy ( Subwoofer )
The grille Assy is attached to the cabinet by press-fitting with
adhesive. To detach it, pry it open by inserting a flat blade
screwdriver into backside of it. To attach it, clean the pressfitting part and apply a bit of adhesive . Then press it to the
bafle.
The subwoofer is attached to the baffle by 4 external screws.
To detach it, unfasten those screws.
When attaching it, face its terminal upward.
CS Assy ( Front / Surround Speaker )
The grille Assy is attached to the cabinet by 4 screws. To detach
it, unfasten those screws.
The speaker unit is attached to the cabinet by 4 external screws
together with the grille Assy. To detach it, first unfasten those
screws. Next remove the cabinet. Then remove the speaker
wire. When attaching it, face its terminal toward the input terminal.
CS Assy ( Center Speaker )
The grille Assy is attached to the cabinet by 4 screws. To detach
it, unfasten those screws.
The speaker unit is attached to the grille Assy by 4 internal
screws.
To detach it, first unfasten those screws. Next remove the cabinet. Then remove the speaker wire. When attaching it, face its
terminal toward the input terminal.
PIONEER CORPORATION 4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan
PIONEER ELECTRONICS (USA) INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A.
PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION 2002
T – ZZM SEPT. 2002 Printed in Japan
Loading...