Pioneer DVR-X122 User Manual

(This page intentionally left blank.)

1

En

Thank you for buying this Pioneer product. The User Manual for this product is on the enclosed
CD-ROM. Before using this product, be sure to read and fully understand all warnings, cautions,
notices and other important safety information contained in the User Manual. Also, be sure to
read the entire User Manual before using this product for other important information, such as
operating information, regulatory information, software license agreement(s), product registration
information, service information and the manufacturer's limited warranty. If for any reason you
cannot access the User Manual on the enclosed CD-ROM, please contact Pioneer at

[e-mail] for a free replacement CD-ROM or a free paper copy of

the User Manual.

WARNING:

This product is not waterproof. To prevent
a fire or shock hazard, do not place a
container filled with liquid near this unit or
expose it to other sources of moisture.

This product complies with the Low Voltage Directive (73/23/EEC, amended by 93/68/EEC), EMC Directives
(89/336/EEC, amended by 92/31/EEC and 93/68/ECC).

Precautions Regarding Use

• Pioneer may not be held liable for the loss of any data or any other direct or indirect damage suffered
as the result of the use or breakdown of this product. It is strongly recommended to regularly back up
all critical data.

• Care must be taken not to infringe copyright restrictions under the laws of each country. If this device is
used to record copyrighted materials, approval must be obtained from the respective copyright holders.
The recording of copyrighted materials without the express approval of the respective copyright holders
may result in legal penalties. Pioneer disclaims any and all responsibility for any legal damages
resulting from the use of this device in the unauthorized copying of copyrighted materials.

• All names of corporations, products, and systems listed herein, even when the (™) or (®) symbols are
omitted, are considered the registered trademarks of the respective owners.

CAUTION

This product is a Class 1 laser product but
this product contains a laser diode higher

WARNING: Handling the product’s cord or cords

associated with accessories sold with the unit can expose
you to lead, a chemical known by the State of California
and other governmental entities to cause cancer and birth
defects or other reproductive harm.

Wash Hands After Handling Cords.

CLASS 1 LASER PRODUCT

than Class 1. To ensure continued safety,
do not remove any covers or attempt to
gain access to the inside of this product.
Refer all servicing to qualified personnel.
The caution label shown to the right
appears on top of internal drive unit.

IMPORTANT

CAUTION

RISK OF ELECTRICAL SHOCK

The lightening flash with arrowhead
symbol within an equilateral triangle is
intended to alert the user to the
presence of un-insulated “dangerous
voltage” with the product’s enclosure
that may be of sufficient magnitude to
constitute a risk of electrical shock to
individuals.

DO NOT OPEN

CAUTION:

TO PREVENT THE POSSIBLE RISK
OF ELECTRICAL SHOCK OR
INJURY, DO NOT REMOVE THE
COVER (FRONT, BACK, OR TOP).
NO USER-SERVICABLE PARTS ARE
INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.

The exclamation mark within an
equilateral triangle is intended to alert the
user to the presence of important
operating and maintenance (servicing)
instructions in the literature accompanying
the product.

2

En

Information to User:

Alteration or modifications carried out without appropriate authorization may invalidate the user’s right to operate
the equipment.

Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by
qualified service personnel.

[For Canadian Model]

This Class B apparatus complies with Canadian ICES-003.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiver or receiving antenna.
 Increase the separation between the equipment and the receiver.
 Plug the equipment into an outlet on a circuit different from the receiver.

 Consult the dealer or an experienced technician for assistance.

DANGER – VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN. AVOID DIRECT EXPOSURE TO
BEAM.

CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein

may result in hazardous radiation exposure.

CAUTION: The use of optical instruments with this product will increase eye hazard.

Federal Communications Commission Declaration or Conformity

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause un-desired operation:

Product Name: External DVD / CD Writer
Model Numbers: DVR-X122
Responsible Party Name: PIONEER ELECTRONICS SERVICE INC.
Address: 1925 E. Dominguez Street, Long Beach, CA 90810 U.S.A.

Caution: This product satisfies FCC regulations when shielded cables and connectors are used to join the unit
to other equipment. To prevent electromagnetic interference with electrical appliances such as radios and
televisions, use shielded cables and connectors.

Operating Environment

Operating environment temperature and humidity:
+41ºF – +95 ºF (+5ºC – +35 ºC); less than 85% RH (cooling vents not blocked)

Do not install in the following locations:

• Exposed to high humidity or poor ventilation

IMPORTANT NOTICE – RECORD THE MODEL NUMBER AND SERIAL NUMBER OF THIS

UNIT BELOW. THE NUMBERS ARE ON THE REAR PANEL.

MODEL #: DVR-X122

SERIAL #:

KEEP THESE NUMBERS FOR FUTURE REFERENCE.

3

En

is a trademark of the DVD Format / Logo Licensing Corporation.

SAFETY INSTRUCTIONS

To ensure your personal safety and to maximize the full operating potential of your unit, read and follow these
safety instructions.

Read & Retain Instructions – Read all operating and user information provided with this drive.
Cleaning – Use a damp cloth to clean the exterior housing. Avoid using any fluids including

liquid, aerosol or alcohol-based cleaning products.

Water or Moisture – Avoid operating or locating this drive near water or other sources of fluid.
Accessories – Do not place this product on an unstable cart, stand, or table. The product may

fall and be seriously damaged.
Ventilation – Slots and openings in the chassis are for cooling and proper operation of the unit.

Do NOT block or cover the openings. Do NOT place this unit on a bed, rug, etc. as this can block
the openings. This unit should not be placed in a built-in installation unless properly ventilated.

Environment – Avoid installing this drive in a location with exposure to large quantities of dust,
high temperatures, high humidity, or subject to excessive vibrations or shocks.

Power Sources – Operate this drive only from the recommended power sources. If you are
unsure of the power source, consult an authorized Pioneer representative.

Power-Cord Protection – When unplugging the unit, pull on the plug – not on the cord. Do not
handle the cord or plug with wet hands; doing so could cause an electric short or shock. Do not
allow anything to pinch or rest on the power cord and do not place in a walkway.

Power – Turn OFF the system before installing this or any other hardware device.
Overloading – Avoid connecting too many devices to a single wall socket or power source as

this can cause fires or short circuits.
Object & Liquid Entry – Never push inappropriate objects in to the device. Avoid spilling any

liquids in to or on the outside of the drive.
Condensation – Moisture can form in the operating section of the product if the drive is taken

from cool surroundings to a room with a warmer temperature. Let the drive stand for one to two
hours in the new location before turning it ON.

Servicing – Opening or removing the cover exposes you to possible electrical shock or other
danger. Contact a Pioneer authorized service representative for repairing this drive (refer to the
enclosed Service & Support Card).

Damage Requiring Service – Unplug the unit and refer servicing to qualified service personnel
in the following situations:

 When the power cord, plug, or chassis is damaged
 If liquid has been spilled, or objects have fallen into the video product
 If the product has been exposed to rain or water
 If the product does not operate normally when the operating instructions are followed.

Adjust only those controls that are covered by the operating instructions. Improper
adjustment of other controls may result in damage and can require extensive work by a
qualified technician to restore the unit to its normal operation.

 When the product exhibits a distinct change in performance – this indicates a need for

service

4

En

About DualDisc Playback – DualDisc is a new two-sided disc with one side containing DVD
video / audio / etc. content and the opposite side containing non-DVD content such as digital
audio material. The non-DVD audio side is not compliant with the CD Audio Specification;
therefore, may not play. The DVD side of DualDisc media plays in this unit. For more details
about the DualDisc specification, please refer to the disc manufacturer or your retailer.

Note: Some discs may not be playable due to different recording formats or the physical

condition of the disc at the time of recording or playback.

5

En

FEATURES

 Interface: USB 2.0
 Write Speed (*:CAV, **CLV)

DVD-R 1X, 2X, 4X, 6X, 8X**, 12X**, 16X*, 18X*
DVD-R (DL) 2X, 4X, 6X, 8X**, 10X**
DVD-RW 1X, 2X, 4X, 6X
DVD+R 2.4X, 4X, 6X, 8X**, 12X**, 16X*, 18X*
DVD+R (DL) 2.4X, 4X, 6X, 8X**, 10X**
DVD+RW 2.4X, 3.3X, 4X, 6X, 8X**
DVD-RAM 2X, 3X, 5X, 6X, 8X, 12X
CD-R 4X, 10X, 16X, 24X**, 32X**, 40X*
CD-RW 4X, 10X, 16X, 20X**, 24X**, 32X**

 Maximum Read Speed

DVD-ROM (single) 16X DVD-ROM (DL) 12X
DVD-R, DVD+R 12X DVD-R (DL) 8X
DVD-RW, DVD+RW 8X DVD+R (DL) 8X
CD-ROM, CD-R 40X CD-RW 32X
DVD-RAM 12X
DualDisc

 Buffer Size 2 MBytes (Read/Write)
 LCD Tilt-Servo Mechanism
 Horizontal orientation
 Low vibration mechanism by DRA System
 Disc Format (Read/Write)

DVD single layer/dual layer / 120mm / 80mm disc
DVD-R (when writing, use only 650nm – for General use – media)
DVD-R (4X, 8X, 16X, 18X write speed)
Dual Layer DVD-R and Double Layer DVD+R
DVD-RW (1X, 2X, 4X, 6X write speed)
DVD+R (2.4X, 4X, 8X, 16X, 18X write speed)
DVD+RW (2.4X, 4X, 8X write speed)
DVD-RAM (non-cartridge, Version 2.0, Version 2.1)
CD-ROM Mode 1
CD-R XA Mode 2 (form 1, form 2)
Photo CD (single and multiple sessions)
CD-DA
CD-Extra (CD PLUS)
Video-CD
CD Text
CD-R
CD-RW / High Speed CD-RW / Ultra Speed CD-RW

Note:

 A specific application program is necessary to write the formats listed above.
 Supported media required for specific DVD and CD writing speeds.
 When writing to DVD at 12X, 16X, and 18x use Pioneer-tested media. For media brand information, refer to the Pioneer

website: www.pioneerelectronics.com

(please refer to the previous page in this document)

6

En

INTERFACE

Front View

1) Forced Ejection Hole

If the tray fails to eject when the Eject button is pressed, insert a stiff rod into the hole and
push to eject the tray.

During normal operation, the eject button should be used to unload the tray. Turn the power
to the drive OFF then wait approximately one minute until the disc stops spinning before trying
to eject the tray using the Forced Ejection Hole.

2) BUSY Indicator

Operation status is indicated as follows:
During reading Lights
During writing Lights

3) Eject Button

Press the button to unload / load the disc.

4) Disc Tray

Press the Eject button to open the loading tray then place a CD or DVD disc onto the tray with
the label facing up. Press the Eject button again or gently push the tray to close and load.

Do not attempt to pull out the disc tray forcibly – use the Forced Ejection Hole (1).

ABOUT REGION CODES

The region code can only be changed five (5) times, including the initial setting. Please be aware
that the fifth change becomes PERMANENT. Therefore, avoid changing the region code unless
absolutely necessary.

 Region codes are part of the DVD Standard. However, region codes on DVD discs are

optional. DVD discs with no specified region code can be played on all compliant players.

7

En