Specifications and Main Features
- 4 rotary heads and helical scan system are the Video system.
- Tapes which were recorded in PAL-M and NTSC can be played in PAL-M.
- Recording feature enables NTSC in NTSC and PAL-M in PAL-M.
- 75 ohms is the external v/u antenna terminal.
- 75 ohm outputs Unbalanced for VHF Channel 3 or 4; these two can switch to each other.
- 50/60 Hz power supply enables 110 - 220 volts.
- Operating temperature for the device ranges between 19 watts.
- Operating Relative humidity for the device varies between 10% to 80%.
- Weight for the equipment_set is set as 4.1kg.
- The dimensions are rated as 360mm,94mm and 304mm.
- THE VHF 2-13, UHF 14-69 bands channels are The tuner.
- VHF 2 to 13, Uhf 14 to 69 are the Transmission channels, Supporting Weld and Superdew Band W. are The CATV channels.
- Infrared remote controller, AAA batteries, Coaxial RF cable and Power adapter cable are listed under Accessories.
Frequently Asked Questions
- Should I check which type of video tapes can this device be used with.
The Device has been labeled okay for T160, T120 and T60 video tapes.
- Q: What is the procedure for setting a recording duration using the One Touch Recording (OTR) functionality?
A: Initially, press the OTR button on the remote and subsequently press it again to set the desired recoding period which can be increased by intervals of thirty minutes on each pressing.
- Q: Is it possible to simultaneously record a specific channel and watch another?
A: With the device set to VCR mode and the channels selected suitably, it is now possible to watch one channel while recording another.
- Q: How do I connect the tape recorder to the television?
A: The connection should be made using an RF output to the VHF input of the television while adjusting the custom CH3/CH4 switch accordingly.
- Q: What is the procedure if the device I am using isn’t switching on?
A: You can verify if the AC cord is plugged properly and if the power outlet is functioning to ensure the device does power on.
- Q: Can I copy a video tape from a vcr to another vcr?
A: You can do that, you just need to connect two vcrs, and then follow the procedure of copying as explained in the manual.
- Q: What happens if there is a power failure while using the timer function?
A: You will have to reset the timer as the programmed ones will be lost whenever there is a power failure for more than a minute.
User Manual
Loading...