Philips TAS4405N Owner's Manual
Wireless Speaker
4000 series
TAS4405
User manual
Register your p roduct and get s upport at
www.philips.com/support
Contents
1 Important 2
Safety 2
2 Your wireless speaker 3
Introduction 3
What's in the box 3
Overview 3
3 Get started 4
Charge the built-in battery 4
Install batteries for the microphone 4
Install a micro-SD card 5
4 Power on/off 5
5 Use Bluetooth devices 6
6 Micro-SD card mode 7
7 Mix your sound with an audio source 7
Record 7
8 Product information 8
10 Notice 8
Compliance 8
Care of the environment 8
FCC Statement 9
Trademark notice 9
EN
1
1 Important
• Do not use this product near water.
• Install in accordance with the
manufacturer’s instructions.
• Do not install near any heat sources wuch
as radiators, heat registers, stoves, or
Safety
Warning
• Never remove the casing of this product.
• Never lubricate any part of this product.
• Never place this product on other
electrical equipment.
• Keep this product away from direct
sunlight, naked fames or heat.
• Read and follow these instructions.
• Make sure that there is enough space
around the product for ventilation.
•
personnel. Servicing is required when the
product has been damaged in any way, such
as power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen
into the product, the product has been
exposed to rain or mositure, does not
operate normally, or has been dropped.
•
by the manufacturer.
• Use only power supplies listed in this user
manual.
• Unplug this product during lightning stroms
or when unused for long periods of time.
• This product should not be exposed to
dripping or splashing.
• Do not place any sources of danger on the
candles).
• Where the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.
2 EN
produce heat.
This device contains licence-exempt
transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference,
including interference that may cause
undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu
dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
TAS4405/37-MIC
This device operates on a no-protection,
no-interference basis. Should the user seek to
obtain protection from other radio services
operating in the same TV bands, a radio licence
is required. For further details, consult Innovation,
Science and Economic Development Canada’s
document Client Procedures Circular CPC-2-1-28,
Voluntary Licensing of Licence-Exempt Low-Power
Radio Apparatus in the TV Bands.
TAS4405/37-MIC
Ce dispositif fonctionne sur une base de nonprotection, sans interférence. Si l'utilisateur cherche à
obtenir la protection d'autres services de radio
opérant dans les mêmes bandes de télévision, une
licence de radio est requise. Pour plus de détails,
consultez le document de Innovation, Science et
Développement économique Canada Intitulé La
circulaire CPC-2-1-28 sur les procédures clients,
licence volontaire d'apparatus radio à faible puissance
exempté de licence dans les bandes de télévision.
2 Your wireless
1
4
5
2
6
7
8
9
speaker
Congratulations on your purchase, and
ZHOFRPHWR3KLOLSV7RIXOO\EHQHÀWIURPWKH
support that Philips offers, register your product
at www.philips.com/welcome.
Introduction
With this speaker and microphone, you can
• enjoy audio from a Bluetooth device,
• enjoy audio from a micro-SD card,
• one touch recording to micro-SD card.
What's in the box
Please check and identify the contents of your
package:
• Wireless speaker
• Wireless microphone
• USB cable
• Quick start guide
• Safety sheet
Overview
a
• Press and hold for 2 seconds to
power on or off.
b
• Press to start or stop the recording
of audio from both the wireless
microphone and the speaker.
c
• Press to select Bluetooth or micro-SD
card source.
d
/
• Press to adjust the volume.
e
• Press to play or pause.
• Press twice to skip to the next track.
f Micro-USB charging port
g Micro-SD card slot
h Battery compartment lid
i Microphone power switch
TAPR802
AAA x 2
*%
Quick start guide
EN
3
Loading...