NPX245
EN User Manual
FR Manuel utilisateur
DE Bedienungsanleitung
ES Manual del usuario
NeoPix Start+
Mini projector
IT Manuale d´uso
Register your product and get support at
www.philips.com/support
NeoPix Start+
Mini projector
User Manual
Register your product and get support at
www.philips.com/support
Table of contents
Introduction ..................................................3
Dear customer ................................................................3
About this user manual ............................................... 3
What’s in the box ........................................................... 3
1 General safety information .................4
Setting up the product ................................................4
Repairs ..............................................................................4
Power supply .................................................................. 5
2 Overview .................................................5
Top view ............................................................................ 5
Front view .........................................................................5
Side view ...........................................................................6
Rear view ..........................................................................6
Remote control...............................................................6
Access home menu ...................................................... 7
3 Initial operation .....................................7
Placing projector ............................................................ 7
Changing screen size ...................................................8
Connecting power supply ..........................................8
Preparing the remote control ....................................9
Power on and setup ...................................................10
4 Connect to playback devices ............10
Connecting to devices through HDMI ..................10
Connecting to devices through AV ........................ 10
Connecting to external speakers or headphones
............................................................................................. 11
5 Media playback .................................. 12
Movie playback .............................................................12
Music playback .............................................................12
Photo playback .............................................................13
6 Change settings ................................... 14
Picture settings ............................................................. 14
Sound settings .............................................................. 14
Language settings ....................................................... 14
Restore default settings ............................................ 14
Rotate/flip projection screen .................................. 14
Set sleep timer .............................................................. 14
Set auto sleep ............................................................... 14
7 Service ................................................... 15
Cleaning ...........................................................................15
Update software ...........................................................15
Troubleshooting ........................................................... 16
8 Appendix ............................................... 17
Technical data ...............................................................17
Introduction
Dear customer
Thank you for purchasing this projector.
We hope you enjoy this product and the many
functions it offers!
About this user manual
The quick start guide supplied with this product
allows you to start using this product quickly
and easily. Detailed descriptions can be found
in the following sections of this user manual.
Read the entire user manual carefully. Follow
all safety instructions in order to ensure proper
operation of this product (see General safety
information, page 4). The manufacturer
accepts no liability if these instructions are not
followed.
Symbols used
Notice
Troubleshooting
This symbol indicates tips that will help
you in using this product more effectively
and easily.
DANGER!
Danger of personal injury!
This symbol gives warning of danger
of personal injury. Physical injury or
damage can result from improper
handling.
What’s in the box
NeoPix Start+ projector (NPX245)
a
A/C power adapter
b
Remote control with 2 AAA batteries
c
Quick Start Guide
d
Power plugs (EU, UK, US)
e
cd
OK
Quick Start
Quick Start
Guide
Quick Start
Guide
Quick Start
Guide
Guide
a
b
e
CAUTION!
Damage to the product or loss of data!
This symbol gives warning of damage
to this product and possible loss of
data. Damage can result from improper
handling.
Introduction 3
1 General safety
information
Take note of all warning and safety notes
indicated. Do not make any changes or settings
that are not described in this user manual.
Incorrect operation, and improper handling can
lead to physical injury, damage to the product
or loss of data.
Setting up the product
This product is for indoor use only. Place the
product securely on a stable, flat surface.
To help avoid possible injuries to persons or
damage to the product itself, position all cables
in such a way that no one will trip over them.
Do not operate the product in damp rooms.
Never touch the mains cable or the mains
connection with wet hands.
The product must have sufficient ventilation
and must not be covered. Do not put the
product in closed cabinets, boxes, or other
enclosures when in use.
Protect the product from direct sunlight,
heat, intense temperature fluctuations and
moisture. Do not place the product in the
vicinity of heaters or air conditioners. Observe
the information on temperature listed in the
technical data (see Technical data, page 17).
Prolonged operation of the product causes the
surface to become hot. In case of overheating,
the product automatically switches to standby
mode.
Do not allow liquids to leak into the product.
Turn off the product and disconnect it from the
mains supply if liquids or foreign substances
leaked into the product. Have the product
inspected by an authorised service centre.
Always handle the product with care. Avoid
touching the lens. Never place heavy or sharp
objects on the product or on the power cable.
If the product gets too hot or emits smoke,
shut it down immediately and unplug the
power cable. Have your product checked by
an authorised service centre. Keep the product
away from open flames (e.g. candles).
The product has built-in battery. Do not
dissemble and modify. The built-in battery
should be replaced by qualified service staff
only.
Do not try to replace the built-in battery
yourself. Incorrect handling of the battery or
using the wrong type of battery can cause
damage to the product or cause injury.
DANGER!
Risk of explosion with incorrect type
of batteries!
There is a risk of explosion if the wrong
battery type is used.
Do not try to replace the built-in
battery yourself.
Do not expose the batteries (battery pack or
embedded batteries) to excessive heat such as
sunshine, or open fire.
Under the following conditions, a layer of
moisture can appear inside the product which
can lead to malfunctions:
• if the product is moved from a cold to a
warm area;
• after a cold room is heated;
• when the product is placed in a damp
room.
Proceed as follows to avoid any moisture
buildup:
1 Seal the product in a plastic bag before
moving it to another room, in order for it to
adapt to room conditions.
2 Wait one to two hours before you take the
product out of the plastic bag.
The product should not be used in a very dusty
environment. Dust particles and other foreign
objects may damage the product.
Do not expose the product to extreme
vibrations. This may damage the internal
components.
Do not allow children to handle the product
without supervision. The packing materials
should be kept out of the hands of children.
For your own safety, do not use the product
during thunderstorms with lightning.
Repairs
Do not repair the product yourself. Improper
maintenance can result in injuries or damage to
the product. The product must be repaired by
an authorised service centre.
Please find the details of authorised service
centres on the warranty card supplied with this
product.
Do not remove the type label from this product,
as this will void the warranty.
4 Philips · NeoPix Start+
Power supply
a cb
Use only a power adapter which is certified for
this product (see Technical data, page 17).
Check whether the mains voltage of the power
supply matches the mains voltage available at
the setup location. This product complies with
the voltage type specified on the product.
The power outlet shall be installed near the
product and shall be easily accessible.
The capacity of the built-in battery diminishes
with time. If the product functions only with AC
power supply, the built-in battery is defective.
Contact an authorised service centre to replace
the built-in battery.
CAUTION!
Always use the button to turn off
the projector.
Turn off the product and unplug from the
power outlet before cleaning the surface
(see Cleaning, page 15). Use a soft, lintfree cloth. Never use liquid, gaseous or easily
flammable cleaners (sprays, abrasives, polishes,
alcohol). Do not allow any moisture to reach
the interior of the product.
DANGER!
Risk of eye irritation!
This product is equipped with a high
power LED (Light Emitting Diode),
which emits very bright light. Do not
look directly into the projector lens
during operation. This could cause eye
irritation or damage.
2 Overview
Top view
NeoPix
Start+
e d c b a
a
• Switch the product on or to standby.
• When the product is switched on, the
LED turns green. When the product is in
standby, the LED turns red.
Navigation buttons
b
Navigate menu options.
c
Confirm a selection or entry.
d
Select an input source: AV, HDMI or Media
Player.
e
Return to a previous menu screen.
Front view
Vents
a
Projection lens
b
Focus adjustment knob
c
Adjust image sharpness.
Overview 5
Side view
a b c
Remote control
USBHDMIOFF/ON
a
Switch on or off the battery power supply.
HDMI
b
Connect to the HDMI output on a playback
device.
Standard USB port
c
• Connect to a USB storage device for
media play.
• Used for software update.
Rear view
abcde
MICRO SDAVDCDC5V
Micro USB port (DC 5V)
a
Used to charge the projector.
b
Connect to the power supply.
AV
c
3.5 mm audio/video input; connect to the
analogue audio jacks and/or composite
video jack on a playback device.
d
3.5 mm audio output; connect to external
speakers or headphones.
Micro SD card slot
e
Connect to a Micro SD card for media play.
h
g
OK
f
e
a
Select an input source: AV, HDMI or Media
Player.
b
Confirm a selection or entry.
c
Return to a previous menu screen.
/
d
Increase or decrease volume.
e
Mute or restore volume.
f
Access the home menu.
Navigation buttons
g
• Navigate menu options.
• Press / to change a selection.
h
• Switch the product on or to standby.
• When the product is switched on, the
LED turns green. When the product is in
standby, the LED turns red.
a
b
c
d
6 Philips · NeoPix Start+
Loading...