Philips MX2500D/78 Quick Start Guide
QUICK USE GUIDE
First connect ...
... then play
(see next page)
FRONT R
A
FRONT L
B
CENTER
C
12nc : 8239 300 32901
Composite
video cable
D
D
MW loop antenna
E
MX2500D
Pr/Cr
Pb/C
b
Y
FM antenna
F
REAR R
J
Helpful Hints
To obtain a better picture quality effect, you can
choose to connect an extra video connection if
your TV has the same input connector: A or B.
Use this video
cable (not supplied)
A
B
If your TV has
this video input jack(s)
COMPONENT VIDEO IN
S-VIDEO
IN
FRONT
FRONT
FRONT
RIGHT
LEFT
CENTER
ANTENNA IN
modulator. The RF modulator
converts the video from the
DVD system so it can play
through the TV’s Antenna
connector. Refer to your
owner’s manual for proper
connection (refer to page 9 in
the owner’s manual).
SUBWOOFER
REAR
REAR
RIGHT
LEFT
If your TV has only
a single Antenna In
jack, you will need an
accessory RF
REAR L
H
H
G B
MW
G
Passive
Subwoofer
C
A
J
Do not switch the P-SCAN to ‘ON’ position, unless you have
P-SCAN
OFF ON
When listening to TV programmes, press TV button on the remote to
set the DVD system to TV mode in order for the sound to be heard.
For connecting to a VCR, see page 11 in the owner’s manual for more
details.
connected the DVD system to a Progressive Scan TV using the
Component (Y Pb/Cb Pr/Cr) video jacks.
ALL
Playing a disc
1
4
5
ALL
1
4
C
Make sure your DVD system and
3
TV are connected and turned on!
1 Press DISC on the remote control.
You can also press the SOURCE button on the front panel
until “DISC” appears on the display panel.
2 Turn on the TV and select the correct Video
In mode.
You should see the blue DVD background screen on the TV
(if no disc in the DVD system).
3 Press OPEN/CLOSE 0 on the front of the
DVD system and load a disc, then press
OPEN/CLOSE 0 again to close the disc tray.
Make sure the disc label is facing up. For double-sided discs,
load the side you want to play face up.
4 Press ÉÅ to start playback.
If a disc menu appears, use 3 4 1 2 buttons on the remote
to make the necessary selection, then press OK to confirm.
Or, use the numeric keypad on the remote to select features.
Follow the instructions given in the disc menu.
H
A
N
N
E
L
3
2
No picture?
Check the AV (Audio/Video)
mode on your TV.
* Usually this channel is between the
lowest and highest channels and may
be called FRONT, A/V IN, or VIDEO.
* Or, you may go to channel 1 on your
TV, then press the Channel down
button repeatedly until you see the
Video In channel.
* Or, your TV remote control may
have a button or switch that chooses
different video modes.
* Do not use channel 3 or 4 on the TV
unless you are using an RF modulator.
* See your TV manual for more details.
5 To stop playback, press STOPÇ.
Using the DVD setup menu
➠
1
2
TV SHAPE
TV SYSTEM
VIDEO OUT
SCR SAVER
DIGITAL OUT
NIGHT MODE
CNTR DELAY
REAR DELAY
TEST TONE
AUDIO
SUBTITLE
DISC MENU
➠➠
PARENTAL
PASSWORD
MENU LANG
DEFAULTS
Detailed playback features and additional functions are described in the
accompanying owner’s manual.
Loading...