Philips MX1050D, MX1060D Service Manual

Service
Service

MX1050D & MX1060D

A02 - 151

Service

Product Service Group CE Audio

Service Information

Already published Service Informations:

CORRECTION TO SERVICE MANUAL

Below are corrections that have to be made on the parts list

and circuit diagram:

* During production (around wk150) a new DVD Main

Board is introduced due to introduction of IC STi5519

which replaces IC STi5505. Due to this modification the

following changes must take place simultaneously:

a) New Instruction For Use ................. 9965 000 12051

b) Front Board's uProcessor U5 ......... 9965 000 12047

c) DVD Main Board (STi5519) ............ 9965 000 12052

The new DVD Main Board can be recognized by the print

mark "55-5938014-10-02" on the board.

Likewise if the DVD Main Board has to be replaced,

please ensure the correct uProcessor U5 is in placed.

A new Chapter 9A for the DVD Module is attached for

reference only. It is recommended to replace the defec-

tive board, therefore no parts list is included.

3139 785 300532002 - 02 - 04

9A-1

DVD MODULE

(For Information Only)

It is not recommended for component repair on this

Module but to replace the major assembly when it

becomes defective.

Therefore no service parts list are published in this

Chapter.

The Circuit & Layout diagrams are published for refer-

ence only. The repair assistance on DVD section is

given on Chapter 2.

9A-1

SERVICING THE DVD MODULE

The only service parts available for replacement are:

DVD Main Board (STi5519) ........................9965 000 12052

DVD Mechanical Loader TVM502T........... 9965 000 10185

Reprogramming of the DVD Main Board

Caution: This information is confidential and may not be distributed. Only a qualified service person should reprogram

the DVD Main Board.

After replacement of the DVD Main Board, the customer settings and also the region code will be lost. Reprogramming of the

DVD Main Board will put the player back in the state in which it has left the factory, ie. with the default settings and the allowed

region code

Reprogramming is done by way of the Remote Control as given below:

Message displayed on TV screen

1. With the unit on and no disc in the tray press DVD key

2. Press Menu key Setup Menu is displayed

3. Press numerical keys <1> <6> <7> "Key 1 - 6 for Region: is displayed

4. Press any one numerical keys between <1> and <6>

as per Region codes given in the table below Selected region code is displayed

5. Press Exit key.

Type/version Destination Region Code*

MX1015D/37 USA 1

MX1050D/22 Europe 2

MX1055D/37S USA 1

MX1060D/22S Europe 2

* Note: The Region code may differs in some countries, in

such case the Region code of the country should be

used.

Upgrading of DVD software by way of an Upgrade Disc and Remote Control as given below:

Message displayed on TV screen

1. With the unit on and no disc in the tray press DVD key

2. Press Eject key to open the tray

3. Press Menu key Setup Menu is displayed

4. Press numerical keys <7> <6> <0>"

5. Press numerical keys <1>"

6. Insert upgrade disc and press Eject key to close tray

7. The set starts reading upgrade disc "Color bars" is displayed when ready

8. Press Power key to bring the set into Standby mode.

9. Remove the upgrade disc by power-up the set & eject to open tray.

Update Software 1/Yes, 2/No
Yes

" is displayed briefly after which the message disappear

" is displayed

9A-29A-2

DVD MAIN BOARD - TOP VIEW

DVD MAIN BOARD - BOTTOM VIEW