Philips MCM275 05 User Manual

Micro Hi-Fi System

User manual Manuel d'utilisation Manual del usuario Benutzerhandbuch Gebruikershandleiding Manuale per l'utente Användarhandböckerna Brugermanual

MCM275

Important notes for users in the U.K.

Mains plug

This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows:

1 Remove fuse cover and fuse. 2 Fix new fuse which should be a BS1362 3 Amp,

A.S.T.A. or BSI approved type.

3 Refit the fuse cover.

If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 3 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 3 Amp.

Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere.

How to connect a plug

The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L).

¶ As these colours may not correspond with the

colour markings identifying the terminals in your plug, proceed as follows: – Connect the blue wire to the terminal marked N or coloured black. – Connect the brown wire to the terminal marked L or coloured red. – Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow).

Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires.

Italia

DICHIARAZIONE DI CONFORMITA’

Si dichiara che l’apparecchio MCM275 Philips risponde alle prescrizioni dell’ar t. 2 comma 1 del D.M. 28 Agosto 1995 n. 548.

Fatto a Eindhoven

Philips Consumer Electronics

Philips, Glaslaan 2

5616 JB Eindhoven, The Netherlands

Norge

Typeskilt finnes på apparatens underside.

Observer: Nettbryteren er sekundert innkoplet. Den innebygde netdelen er derfor ikke frakoplet nettet så lenge apparatet er tilsluttet nettkontakten.

For å redusere faren for brann eller elektrisk støt, skal apparatet ikke utsettes for regn eller fuktighet.

Recording and playback of material may require consent. See Copyright Act 1956 and The Performer’s Protection Acts 1958 to 1972.

1 2

5 4

9 0 !

Advarsel: Usynlig laserstråling ved åbning når sikkerhedsafbrydere er ude af funktion. Undgå utsættelse for stråling.

Bemærk: Netafbryderen er sekundært indkoblet og ofbryder ikke strømmen fra nettet. Den indbyggede netdel er derfor tilsluttet til lysnettet så længe netstikket sidder i stikkontakten.

Klass 1 laseraparat Varning! Om apparaten används på annat sätt än i denna bruksanvisning specificerats, kan användaren utsättas för osynlig laserstrålning, som överskrider gränsen för laserklass 1.

Observera! Stömbrytaren är sekundärt kopplad och bryter inte strömmen från nätet. Den inbyggda nätdelen är därför ansluten till elnätet så länge stickproppen sitter i vägguttaget.

Luokan 1 laserlaite

Varoitus! Laitteen käyttäminen muulla kuin tässä käyttöohjeessa mainitulla tavalla saattaa altistaa käyttäjän turvallisuusluokan 1 ylittävälle näkymättömälle lasersäteilylle.

Oikeus muutoksiin varataan. Laite ei saa olla alttiina tippu-ja roiskevedelle.

Huom. Toiminnanvalitsin on kytketty toisiopuolelle, eikä se kytke laitetta irti sähköverkosta. Sisäänrakennettu verkkoosa on kytkettynä sähköverkkoon aina silloin, kun pistoke on pistorasiassa.

Index

English ------------------------------------------------ 6

Français -------------------------------------------- 31

Español --------------------------------------------- 56

Deutsch --------------------------------------------- 81

Nederlands -------------------------------------- 107

Italiano -------------------------------------------- 132

Svenska ------------------------------------------- 157

English

Français

EspañolDeutschNederlandsItalianoSvenskaDansk

Dansk --------------------------------------------- 181

Contents

English

General Information

Supplied accessories ............................................ 7

Environmental information ................................ 7

Safety information ................................................ 7

Controls

Controls on the set ............................................. 8

Remote control .............................................. 9-10

Installation

Placing MCM275 ................................................. 10

Mounting stand onto the set

Mounting MCM275 onto walls

Rear connections ......................................... 11-12

Speaker connections

Antenna connections

Connecting an additional appliance ............... 12-13

Connecting a USB device

Connecting a non-USB device

Using AC power .................................................. 13

Preparations

Using the remote control .......................................... 14

Setting the clock ................................................. 14

Basic Functions

Switching on/off the set and

selecting functions .............................................. 15

Switching between Standby and

ECO POWER mode.......................................... 15

Auto-standby ....................................................... 15

Volume control ................................................... 16

Volume adjustment

MUTE

Sound control ..................................................... 16

DSC

DBB

Displaying the clock ....................................................... 16

Discs for playback .............................................. 17

Playing discs ................................................... 17-18

Selecting and searching ..................................... 18

Selecting a different track

Finding a passage within a track during playback

Programming tracks ........................................... 19

Reviewing the program Erasing the program

Different play modes: REPEAT, SHUFFLE ...... 20

Display track information

(MP3/WMA only) ............................................... 20

Tuner

Tuning to radio stations .................................... 21

Programming radio stations ............................. 21

Autostore: Automatic programming Manual programming To listen to a preset station

RDS (Radio Data System) ................................ 22

Switching through RDS information

Tuning to a program type (PTY) Automatic clock setting via RDS

RDS News and Traffic Announcement (TA)

................................................................................ 23

Activating the NEWS function

Deactivating NEWS

USB

Using a USB mass storage device ............. 24-25

Playing a USB mass storage device

AUX

AUX (Listening to an external source) ......... 25

Timer

Setting the timer ................................................. 26

Activating and deactivating TIMER ................. 26

SLEEP

................................................................................ 26

Specifications ........................................... 27

Maintenance .............................................. 27

Troubleshooting .............................. 28-29

How to mount your MCM275

onto walls..................................................... 30

General Information

Supplied accessories

–2 speaker boxes including 2 speaker cables – remote control (with 1 x CR2025 battery) – MW loop antenna – FM wire antenna – stand – mounting kit

Environmental Information

All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).

Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

Disposal of your old product

Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.

When this crossedout wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC

Safety Information

● Place the system on a flat, hard and stable

surface.

● Place the system in a location with adequate

ventilation to prevent internal heat build-up in your system. Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches) from each side.

● The ventilation should not be impeded by

covering the ventilation openings with items, such as newspapers, table-cloths, cur tains, etc.

● Do not expose the system, batteries or discs to

excessive moisture, rain, sand or heat sources caused by heating equipment or direct sunlight.

● No naked flame sources, such as lighted candles,

should be placed on the apparatus.

● No objects filled with liquids, such as vases, shall

be placed on the apparatus.

● If the system is brought directly from a cold to a

warm location, or is placed in a very damp room, moisture may condense on the lens of the disc unit inside the system. Should this occur, the CD player would not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible.

● The mechanical par ts of the set contain self-

lubricating bearings and must not be oiled or lubricated.

● When the system is switched to Standby

mode, it is still consuming some power. To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.

English

Please inform yourself about the local separate collection system for electrical and electronic products.

Please act according to your local rules and do not dispose of your old products with your normal household waste. The correct disposal of your old product will help prevent potential negative consequences for the environment and human health.

Controls

English

Controls on the set (illustrations

on page 3)

1 STANDBY-ON/ ECO POWER

– press briefly to switch the set on or off (standby/

ECO POWER);

– In standby or Eco Power mode: press and

hold to toggle between Standby and ECO POWER mode (power-saving mode)

– Red indicator: lights up red when the set is

switched to ECO POWER mode

2 SOURCE

– selects sound source CD, USB, TUNER or

AUX

– In standby or Eco Power mode: switches the

set on and selects sound source CD, USB, TUNER or AUX

3 IR

– sensor for the infrared remote control Helpful hints: Always point the remote control

towards this sensor.

4 PUSH OPEN

– push to unfold or fold the control panel

5 CD OPEN • CLOSEç

– opens/closes the CD door

6 CD door 7 VOLUME

– adjusts the volume level – Clock/Timer: adjusts the hours and minutes

– 3.5 mm headphone socket

Helpful hints:

– Adjust the volume to a moderate level before you plug in the headphones. – Connecting headphones will switch off the speakers.

9 ALBUM/ PRESET + /-

– CD/USB: selects albums (for MP3/WMA only) – TUNER: selects a preset radio station

4 / ¢

– CD/USB: skips or searches CD tracks/titles

backwards/forwards

– Tuner: tunes to radio stations

ÉÅ

– CD/USB: starts or pauses playback

0 DBB (Dynamic Bass Boost)

– turns the bass enhancement on/off

! DSC (Digital Sound Control)

– selects predefined sound settings: ROCK,

JAZZ, POP, CLASSIC

@ PROGRAM

– CD/USB: programs tracks – Tuner: programs preset radio stations

# STOP

– CD/USB: stops playback; erase a program

$ AUX-IN

– connects to the AUDIO OUT jack on the

external appliance

– jack for the external USB mass storage device

Controls

Remote control

USB

# @

! 0 9

Notes for remote control: – First select the source you wish to control by pressing one of the source select keys on the remote control (for example CD, TUNER). – Then select the desired function (for example ÉÅ,

– press briefly to switch the set on or off (standby/

ECO POWER);

– In standby or Eco Power mode: press and

hold to toggle between Standby and ECO POWER mode (power-saving mode)

4 , ¢

6 7 8

2 Source buttons

USB

– selects USB source – In standby or Eco Power mode:: switches the

set on and selects USB source.

– selects CD source – In standby or Eco Power mode:: switches the

set on and selects CD source.

TUNER

– selects TUNER source and toggles between the

wavebands: FM and MW

– In standby or Eco Power mode:: switches the

set on and selects TUNER source

AUX

– selects the audio input from an additional

connected appliance

– In standby or Eco Power mode:: switches the

set on and selects the audio input from an additional connected appliance

3 VOLUME +/-

– adjusts the volume level

– Clock/Timer: adjusts the hours and minutes

4 TIMER

– displays the timer setting – switches the timer on/off – enters the timer setting mode (press and hold

for more than 2 seconds)

5 SLEEP

– set the sleep timer

6 MUTE

– switches the sound off temporarily

7 RDS/NEWS

– Tuner: selects RDS (Radio Data System)

information

– CD/USB/AUX: activates/deactivates news

8 SHUFFLE

– selects random playback

9 REPEAT

– selects continuous playback

0 DSC (Digital Sound Control)

– selects predefined sound settings: ROCK,

JAZZ, POP, CLASSIC

! DBB (Dynamic Bass Boost)

– turns the bass enhancement on/off

@ PROGRAM

– CD/USB: programs tracks

– Tuner: programs preset radio stations

# DISPLAY/CLOCK

– Clock: - displays the set time

- In standby mode: enters the clock setting mode (press and hold for more than 2 seconds)

– TUNER/Audio CD: switches between clock

display and playback display

– MP3/WMA files: displays disc information

during playback

English

+ 21 hidden pages

Philips MCM275 05 User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual