Mobilo |
Vacuum cleaner |
HR 8570
!Service ! Service Information Information
Philips Domestic Appliances and Personal Care
ServiceManual
PRODUCT INFORMATION
- |
Maximum air displacement |
: |
37 l/sec. |
- Maximum vacuum water column |
: |
310 cm |
|
- Power consumption (IEC) |
: |
1400 W |
|
- |
Dust storage capacity |
: |
3 litres |
- |
Cord length |
: |
6.3 metres |
- |
Filter system |
: |
Paper dustbag |
|
|
: |
Motor inlet filter |
|
|
: |
Exhaust air filter |
- |
Dimensions cleaner |
: |
44.5 x 29.5 x 25 cm |
- |
Weight cleaner |
: |
5.5 kg |
- |
Colour cleaner |
: |
Brown |
- |
Noise |
: |
77 dB |
OPTIONAL
Exhaust air filter |
HR 6932 (8836 932 01210) |
|
Active carbon filter |
HR 6949 (8836 949 01010) |
|
Active carbon filter replacem. set |
HR 6968 (items 12 + 13) |
|
S-class filter |
HR 6992 (8836 992 01010) |
|
S-class filter replacement set |
HR 6994 |
(items 19 + 20) |
Sydney cotton dustbag |
HR 6997 |
(8836 997 01010) |
Sydney closable pap. dustbag |
HR 6999 |
(8836 999 01010) |
Sydney 3-M dustbag |
HR 6999 |
(8836 999 90010) |
SERVICE INFORMATION
-The infrared remote control can adjust the suction power with 5 speeds. When switched on, the appliance always starts with the highest power, even without a connected hose.
Use LR03 batteries. Alkaline is advised.
-Component configuration on exploded view may differ in case of specific versions. However, the actual components are distinguished bij means of code numbers.
-The spare parts have been standardized as much as possible.
-Item 6, cotton dustbag, is used in those countries where paper dustbags are not available.
-Item 21 is provided with a long cord-winder spring; both long and short cords can be used in combination with this spring.
-Cordwinder spring has to be tensioned till maximum minus approx. 1,5 revolution.
-Depending on the original length of the cord, the spare cord must be shortened.
-To (dis)assemble the appliance use TORX screw driver no T15
=4822 395 10329, which is one of a set consisting of T20, T15, TI0, T9, T8, T7 and T6 = 4822 395 50145.
-Adjusting the PCB on the motor to 220V, 60Hz.
1. Make sure that the potentiometer (item 36) is set at min. position.
2. Adjust the potentiometer on the PCB item 45, on the motor to 220V/60Hz to allow the motor to run smoothly.
Please note: the standard setting of the spare PCB is 230V/50Hz.
There are open-circuit voltages on all wires.
This product meets the requirements regarding interference suppression on radio and TV.
After the product has been repaired, it should function properly and has to meet the safety requirements as officially laid down at this moment.
Published by Philips Domestic Appliances and Personal Care |
Printed in the Netherlands |
© Copyright reserved |
Subject to modification |
4322 277 00260 00/03
PCS 101 406
Pos. |
12 nc |
description |
|
Pos. |
12 nc |
description |
|
1 |
4322 003 16790 |
acc. cover |
|
30 |
4322 007 12020 |
cord Swiss l = 6.3m |
|
2 |
4322 000 67680 |
dust indicator spring |
|
|
4322 006 01280 |
cord Swiss l = 8.5m |
(opt.) |
3 |
4322 009 07380 |
dust cover brown |
|
31 |
4322 007 11950 |
cord Italy l = 6.3 m |
|
4 |
4322 001 94690 |
packing ring |
|
32 |
4322 003 12240 |
dustbag sealing |
|
5 |
4322 003 16760 |
front cover |
|
33 |
4322 005 10760 |
caster assy standard |
|
6 |
8836 999 01010 |
Sydney closable pap. dustbags (opt.) |
35 |
4322 009 07410 |
rear wheel + cover |
|
|
|
8836 999 90010 |
Sydney 3M dustbag |
|
36 |
4322 006 22370 |
speed control IR-receiver |
|
|
8836 997 01010 |
Sydney cotton dustbag |
(opt.) |
37 |
4322 003 12030 |
cord winder lever |
|
7 |
4322 009 06760 |
dustbag carrier |
|
41 |
4322 006 50580 |
push button switch |
|
8 |
4322 003 12280 |
clamp of dustbag carrier |
|
42 |
4322 003 12010 |
motor cover |
|
9 |
4322 003 12020 |
dust compartment sealing |
|
43 |
4322 001 72790 |
rear motor buffer |
|
10 |
4322 005 08650 |
lens |
|
44 |
4322 003 09720 |
suspension bracket |
|
11 |
4322 005 08720 |
back panel stamped |
|
45 |
4322 006 22460 |
motor print 230 V - 50 Hz / RMC |
|
12 |
4322 009 07040 |
inletgrill + trio filter |
|
46 |
4322 000 03700 |
PCB clamp |
|
|
4322 003 10950 |
active carbon filter grill |
(opt.) |
47 |
4322 009 06430 |
motor 220-240 V / 50-60 Hz |
|
13 |
4322 000 37300 |
trio filter |
|
48 |
4322 000 09750 |
spring switch knob |
|
|
8836 949 01010 |
active carbon filter |
(opt.) |
73 |
4322 006 20590 |
IR-RMC send unit |
|
14 |
4322 005 08670 |
pedal |
|
74 |
4322 007 16000 |
leafspring |
|
15 |
4322 001 72780 |
buffering motor |
|
75 |
4322 005 08310 |
hose and standard bend |
|
16 |
4322 003 12080 |
motor disc |
|
76 |
4322 003 16030 |
bend RMC |
|
17 |
4322 003 16770 |
cord outlet |
|
77 |
4322 003 16010 |
crevice nozzle 118 mm |
|
18 |
4322 009 07400 |
lower housing + wheels |
|
78 |
4322 004 00650 |
small nozzle |
|
19 |
8836 992 01010 |
S-class filter |
(opt.) |
81 |
4322 004 00590 |
plumeau |
|
|
8836 932 01210 |
AFS micro filter |
|
103 |
4322 009 05410 |
Tube clip assy 35 mm |
|
20 |
4322 005 08660 |
grill S-class filter |
(opt.) |
104 |
4322 004 22180 |
Telesc. tube + clamp |
|
|
4322 009 07160 |
grill AFS micro filter |
|
105 |
4322 004 22120 |
Nozzle RD 262 act. coupl. |
|
21 |
4322 009 05350 |
reel half spring unit |
|
114 |
4322 004 22130 |
Turbo nozzle HR 6988 |
|
23 |
4322 001 72360 |
brake tyre |
|
115 |
9965 000 03349 |
Coupling piece |
|
24 |
4322 009 04800 |
reel half contact unit |
|
116 |
4822 358 10205 |
Drive belt |
|
25 |
4322 009 05060 |
contact ring plate |
|
117 |
4822 479 20201 |
Brush assy |
|
26 |
4322 007 11960 |
cord Australia l = 6.3 m |
|
121 |
4322 001 99120 |
Coupling bush |
|
27 |
4322 007 12150 |
cord Japan / low voltage |
|
122 |
4322 007 45550 |
Coupling spring |
|
28 |
4322 007 12190 |
cord UK l = 6.3 m |
|
DFU |
4222 000 47250 |
direction for use vacuum cleaner |
|
29 |
4322 007 11930 |
cord Europe 4.8 mm l = 6.3 m |
|
||||
|
DFU |
4222 000 45620 |
direction for use turbo nozzle |
|
|||
|
4322 007 11920 |
cord Europe 4.8 mm l = 8.5 m |
(opt.) |
|
|||
|
|
|
|
|
MAIN
SWITCH
CORD WINDER
|
|
|
|
|
|
IR |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
PMT |
|
|
|
|
|
|
|
|
|
|
|||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
IR-TRANSMITTER
M
MOTOR |
|
|
|
|
IR-RECEIVER |
||||
POWER |
||||
MODULE |
+ |
|
||
|
|
CONTROL |
-To open the appliance, first remove the 2 screws of the control panel (item 11) then with a big screw driver disconnect the 2 snap locks of panel and lower housing (see drawing).
PCS 101 407