Philips HR8569 Service Manual

Mobilo Vacuum cleaner

HR 8569

Service
Information

!

Philips Domestic Appliances and Personal Care

Service Manual

PRODUCT INFORMATION

- Maximum air displacement : 37 l/sec.

- Maximum vacuum water column : 310 cm

- Power consumption (IEC) : 1400 W

- Dust storage capacity : 3 litres

- Cord length : 6.3 metres

- Filter system : Paper dustbag
: Motor inlet fi lter
: Exhaust air fi lter

- Dimensions cleaner : 44.5 x 29.5 x 25 cm

- Weight cleaner : 5.5 kg

- Colour cleaner : Green

- Noise : 77 dB

OPTIONAL

Exhaust air fi lter HR 6932 (8836 932 01210)
Active carbon fi lter HR 6949 (8836 949 01010)
Active carbon fi lter replacem. set HR 6968 (items 12 + 13)
S-class fi lter HR 6992 (8836 992 01010)
S-class fi lter replacement set HR 6994 (items 19 + 20)
Sydney cotton dustbag HR 6997 (8836 997 01010)
Sydney closable pap. dustbag HR 6999 (8836 999 01010)
Sydney 3-M dustbag HR 6999 (8836 999 90010)

SERVICE INFORMATION

- To open the appliance, fi rst
remove the 2 screws of the
control panel (item 11) then
with a big screw driver dis­connect the 2 snap locks
of panel and lower housing
(see drawing).

- Component confi guration on exploded view may differ in case
of specifi c versions. However, the actual components are distin-
guished bij means of code numbers.

- The spare parts have been standardized as much as possible.

- Item 6, cotton dustbag, is used in those countries where paper
dustbags are not available.

- Item 21 is provided with a long cord-winder spring; both long and
short cords can be used in combination with this spring.

- Cordwinder spring has to be tensioned till maximum minus approx.
1,5 revolution.

- Depending on the original length of the cord, the spare cord must
be shortened.

- To (dis)assemble the appliance use TORX screw driver no T15
= 4822 395 10329, which is one of a set consisting of T20, T15,
TI0, T9, T8, T7 and T6 = 4822 395 50145.

- Adjusting the PCB on the motor to 220V, 60Hz.

1. Make sure that the potentiometer (item 36) is set at min.

position.

2. Adjust the potentiometer on the PCB item 45, on the motor to

220V/60Hz to allow the motor to run smoothly.

Please note: the standard setting of the spare PCB is

230V/50Hz.
There are open-circuit voltages on all wires.

This product meets the requirements regard­ing interference suppression on radio and TV.

After the product has been repaired, it should
function properly and has to meet the safety
requirements as offi cially laid down at this
moment.

Published by Philips Domestic Appliances and Personal Care Printed in the Netherlands © Copyright reserved Subject to modification

4322 277 00259
00/03

PCS 101 398

Pos. 12 nc description

1 4322 003 16870 acc. cover
2 4322 000 67680 dust indicator spring
3 4322 009 07390 dust cover green
4 4322 001 94690 packing ring
5 4322 003 16900 front cover

6 8836 999 01010 Sydney closable pap. dustbags
8836 999 90010 Sydney 3M dustbag (opt.)
8836 997 01010 Sydney cotton dustbag (opt.)
7 4322 009 06760 dustbag carrier
8 4322 003 12280 clamp of dustbag carrier

9 4322 003 12020 dust compartment sealing
10 4322 005 11480 turn knob
11 4322 003 16930 back panel
12 4322 009 07040 inletgrill + trio fi lter
4322 003 10950 active carbon fi lter grill (opt.)

13 4322 000 37300 trio fi lter
8836 949 01010 active carbon fi lter (opt.)
14 4322 005 11490 pedal
15 4322 001 72780 buffering motor
16 4322 003 12080 motor disc

17 4322 003 16770 cord outlet
18 4322 009 07400 lower housing + wheels
19 8836 992 01010 S-class fi lter (opt.)
8836 932 01210 AFS micro fi lter
20 4322 005 08660 grill S-class fi lter (opt.)

4322 003 16950 grill AFS micro fi lter
21 4322 009 05350 reel half spring unit
23 4322 001 72360 brake tyre
24 4322 009 04800 reel half contact unit
25 4322 009 05060 contact ring plate

26 4322 007 11960 cord Australia l = 6.3 m
27 4322 007 12150 cord Japan / low voltage
28 4322 007 12190 cord UK l = 6.3 m
29 4322 007 11930 cord Europe 4.8 mm l = 6.3 m
4322 007 11920 cord Europe 4.8 mm l = 8.5 m (opt.)

Pos. 12 nc description

30 4322 007 12020 cord Swiss l = 6.3m
4322 006 01280 cord Swiss l = 8.5m (opt.)
31 4322 007 11950 cord Italy l = 6.3 m
32 4322 003 12240 dustbag sealing
33 4322 005 10760 caster assy standard

35 4322 009 07420 rear wheel + cover
36 4322 006 07220 speed control 220 - 240 V
37 4322 003 12030 cord winder lever
41 4322 006 50580 push button switch
42 4322 003 12010 motor cover

43 4322 001 72790 rear motor buffer
44 4322 003 09720 suspension bracket
45 4322 006 20720 motor print 230 V - 50 Hz
46 4322 000 03700 PCB clamp
47 4322 009 06430 motor 220-240 V / 50-60 Hz

48 4322 000 09750 spring switch knob
74 4322 007 16000 leafspring
75 4322 005 08310 bend and hose
76 4322 003 16020 bend
77 4322 003 16010 crevice nozzle 118 mm

78 4322 004 00650 small nozzle
81 4322 004 00590 plumeau
103 4322 009 05410 tube clip assy 35 mm
104 4322 004 22180 telescopic tube + clamp
105 4322 004 22120 nozzle RD 262 active coupling

111 4322 004 22330 polishing nozzle HR 8040
112 4322 005 11040 polishing disc
113 8838 041 01010 polishing brushes HR 8041
121 4322 001 99120 coupling bush
122 4322 007 45550 coupling spring

DFU 4222 000 47250 direction for use

M

PCS 101 399

MOTOR
POWER

MODULE

MAIN

SWITCH

CORD WINDER

ROTARY
POTMETER