![](/html/42/425d/425dcaf17c7b07bedc306ec45651d9ba825dae374e7b0e615bd64accde5871fd/bg1.png)
Stand and Bowl Mixer
R
I7200/00
R
I7200/01
HR7200/00
HR1576/00
Philips Consumer Lifestyle Version A
Service Manual
PRODUCT INFORMATION
Safety
• This product meets the requirements regarding
interference suppression on radio and TV.
• After the product has been repaired, it should function
properly and has to meet the safety requirements as
officially laid down at this moment.
TECHNICAL INFORMATION
• Voltage : 220 V
• Frequency : 50 Hz - 60 Hz
• Power : 400 W
• Cord length : 1,25 m
• Colour appliance : White
• Motor : Serles wound
Statically and dynamically
balanced
Self lubricated
• Transmission ratio
between rotor spindle
and gearwheel : 21½ : 1
• Speeds beaters : Switch position 1 - 545 rpm
Switch position 2 - 600 rpm
Switch position 3 - 710 rpm
Switch position 4 - 810 rpm
Switch position 5 - 900 rpm
Turbo position - 1010 rpm
Dimensions
• Length : 350 mm
• Width : 370 mm
• Height : 165 mm, 370 mm (incl. Mixer)
• Weight : 1660 g (without Beaters)
Published by Philips Consumer Lifestyle Printed in the Netherlands © Copyright reserved Subject to modification
12/11
![](/html/42/425d/425dcaf17c7b07bedc306ec45651d9ba825dae374e7b0e615bd64accde5871fd/bg2.png)
STAND:
DISASSEMBLY- AND RE-ASSEMBLY ADVISE
• Push with a small screwdriver the 2 hooks inside the
stand.
RI7200/00
R
I7200/01
HR7200/00
HR1576/00
REPAIR INSTRUCTION
Mounting gearwheels
When mounting the gearwheels make sure that the cams
of the gearwheels are situated at the front of the beaters.
The angle between the beaters must be 45°.
So when carrying out a repair be sure that the gearwheels
are mounted correctly (see Fig. 1).
90
°
Fig. 1
45
°
• Press both arm-flaps like shown, that you can remove the
arm from the stand.
Circuit diagram
Motor assy
RedGreenBlack
Orange
Max speed
Lubrication
Use graphite grease code no. 4822 390 20004 to grease the
appliance on the following points:
1. Spaces between the teeth of the wormwheels.
2. Both sides of the wormwheel shaft.
Motor
The motor cannot operate properly, when, due to
contamination, carbon brush is unable to move freely in
guide bush and consequently cannot be pressed against the
commutator.
OPTIONAL (accessories)
• No specific issues.
2
3
1
4
5
Brown Blue
MAINS
2-5