Philips HQ100/01, HQ100/02 User Manual

Action Clean

Razor Head

Cleaner

HQ100

Instructions for use

IMPORTANT SAFEGUARDS

When using your Action Clean Razor Head Cleaner, basic safety precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.

1. Close supervision is necessary for any appliance being used by or near children or the disabled.

2. Use this Razor Head Cleaner for its intended household use as described in this manual. Do not use attachments or other cleaning solutions not recommended by Philips Electronics North America Corporation.

3. Never place this appliance on a soft surface, such as a bed or a sofa, where solution may spill. Do not tilt the unit.

4. Do not overfill chamber with liquid.

5. Do not rinse with water.

6. Never operate this unit if it is not working properly or if it has been dropped or damaged. Return Razor Head Cleaner to an Authorized Norelco Service Location for examination and repair.

SAVE THESE INSTRUCTIONS

If you need help, answers or

service, please call us at

1-800-243-3050

Features

• For assistance or the Authorized Norelco

Service Location nearest you, call toll free:

1-800-243-3050

Authorized Service Location information is available 24 hours a day, 7 days a week.

Before using your new Action Clean Razor Head Cleaner, it is important to follow the instructions below:

• You do not need to remove cutters and combs

from Razor Head Assembly to clean them in the Action Clean Razor Head Cleaner. The whole assembly piece can be cleaned as a complete unit. If you do remove cutters and combs be careful not to interchange them as they are matched sets. If you do interchange cutters and

combs, the shaving performance may be adversely affected for the next few shaves until the blades reseat themselves.

• Three Head Holder

• Two Head Holder

• Top

• Action Cleaning

Chamber

For Assistance

Important

• Base

1. Turn the top of the Action Clean unit counterclockwise and pull top from Cleaning Chamber. (Fig. 1)

2. Remove the filter unit from the Cleaning Chamber. (Fig. 2)

3. Depending on your razor model, select either the two or three head holder. Place it on top of filter unit, ensuring that the three notches of the holder fit in the slots of the filter unit. Replace the filter unit into the Action Cleaning Chamber, making sure that the filter unit clicks down into place. (Fig. 3)

How to use your Action Clean Razor Head Cleaner

8. When finished, remove top from Action Cleaning Chamber and remove Razor Head Assembly. (Fig. 8) Place Razor Head Assembly on a paper towel to air dry. Make sure Razor Head Assembly is completely dry before placing it back on your razor.

9. DO NOT RINSE WITH WATER.

10. After each cleaning, spread one drop of lubricating oil from the tube included, Norelco Razor Lubricant Model AL80, or one drop of mineral oil over each razor head using your finger.

11. For consistently close and comfortable shaves, you should clean your razor heads every 4 - 6 weeks or when the display on your razor tells you to do so. If your shave is still not close enough, you may need new replacement heads.

12. Change the filter and Action Clean Cleaning Solution at least once a year. (Fig. 9,10,11)

13. Use only Norelco Action Clean Cleaning Solution with filter, model HQ101, with this unit.

4. Empty the contents of the Action Cleaning Solution into the Cleaning Chamber. (Fig. 4)

5. Place Razor Head Assembly from razor (with heads in place) onto Head Holder. (Fig.5)

6. Replace top on Cleaning Chamber, making sure that it locks into place by turning clockwise until it “clicks” into place. (Fig. 6)

7. Clean heads by pumping the top on the Action Cleaning Chamber for about 30 seconds. (Fig.7)

+ 1 hidden pages