Philips HD7811, HD7810 User Manual

www.philips.com

HD7811, HD7810

Coffee Machine

3 4 5

CLI

7 8

10 11 12

14 15 16

18 19 20

22 23 24

The purchase of the Philips Senseo coffee machine does not exhaust any of the rights of Sara Lee/Douwe Egberts or Philips under any of their patents nor does it confer upon the purchaser a licence under these patents.

HD7811, HD7810 Coffee Machine 4222001971922 ENGLISH

Introduction

With the Senseo\ coffee machine by Philips you can enjoy a perfect cup of

coffee - topped with a rich crema layer - whenever you feel like it. Each cup

is freshly brewed, so you're always sure of that pure, smooth taste. The

unique Senseo\ brewing system from Philips in combination with the

special Senseo\ coffee pods from Douwe Egberts make sure you get only

the very best in flavour and aroma from freshly roasted coffee.

The Douwe Egberts coffee in convenient Senseo\ coffee pods and Philips'

unique new Senseo\ brewing system are perfectly matched to ensure that

the best taste and aroma are extracted from the coffee.

To optimise the taste of the coffee, you should keep the following aspects in

mind:

Fresh water

Use fresh water every day. If you have not used the machine for some time,

rinse the water reservoir, fill it with fresh water and flush the machine before

you use it again (see 'Preparing the machine for use').

Fresh coffee pods

Use the Senseo\ coffee pods that have been specially developed by

Douwe Egberts for your Senseo\ coffee machine for a full, round taste.

The Douwe Egberts Senseo\ coffee pods will stay fresh longer if you close

the package by means of the keep-fresh seal after use or if you store them

in a storage container.

A clean machine

Clean and descale your Philips Senseo\ coffee machine regularly (see

'Cleaning' and 'Descaling'). Remove used coffee pods after brewing. If a

used pod has been left in the coffee machine and you have not used the

machine for some time, flush the machine before you use it again (see

'Preparing the machine for use').

General description (fig. 1)

A Water reservoir B Lid of water reservoir C 1-cup pod holder D 2-cup pod holder E Coffee outflow unit F Cover of coffee outlow unit G Drip tray H Cup tray I Water distribution plate J Sealing ring K Outflow valve L Pilot light

HD7811, HD7810 Coffee Machine3 ENGLISH 422200197192

Important

Read these instructions for use carefully before using the machine and save

them for future reference.

◗ Check if the voltage indicated on the bottom of the machine

corresponds to the local mains voltage before you connect the

machine.

◗ Do not use the machine if the plug, the cord or the machine itself is

damaged. The mains cord may only be replaced and other repairs

may only be carried out by Philips or a service centre authorised by

Philips in order to avoid hazardous situations.

◗ To prevent unexpected contact with hot water, always make sure the

lid of the Senseo\ machine is properly locked before you start using

the machine.

◗ Do not use the machine in combination with a transformer, as this

could cause hazardous situations.

◗ Put the machine on a flat, stable surface outside the reach of children

and make sure children do not play with the machine. Never let the

machine operate unattended.

◗ Do not use the machine at altitudes higher than 1500 metres above

sea level.

◗ The machine does not work at temperatures below 10cC. ◗ Flush the coffee machine with fresh water before using it for the first

time (See 'Preparing the machine for use'). This will cause the boiler

to fill with water, which is essential for the machine to work properly.

◗ Do not use the Senseo\ machine in combination with water

softeners based on sodium exchange.

Preparing the machine for use

NB: YOU CANNOT BREW COFFEE IF YOU HAVE NOT

FLUSHED THE SENSEO® COFFEE MACHINE FIRST!

The flushing cycle causes the boiler to be filled with water. After this the

coffee machine is ready for use.

Flush the machine in the following way:

1 Remove the water reservoir (fig. 2).

2 Fill the water reservoir with cold water up to the MAX indication and

put it back into the machine (fig. 3).

3 Release the lid by moving the lever upwards (fig. 4).

4 Open the lid (fig. 5).

5 Put the 1-cup or 2-cup pod holder in the machine without pod(s) (fig. 6).

6 Close the lid and lock the lever (fig. 7).

Make sure the lever is properly locked by pushing it down until it snaps

home with a click.

Never flush the machine with the lid open. The lid must be properly locked.

7 Put the plug in an earthed wall socket.

8 Put a bowl (with a capacity of at least 1500 ml) under the coffee

outflow openings to collect the water (fig. 8).

+ 6 hidden pages