Philips HD762602 Service Manual

Coffee maker Essence

HD7626/02

Philips Domestic Appliances and Personal Care

Service Manual

PRODUCT INFORMATION

-This product meets the requirements regarding interference suppression on radio and TV.

-After the product has been repaired, it should function properly and has to meet the safety requirements as officially laid down at this moment.

TECHNICAL INFORMATION

-	Voltage	: 100 V, 120 V, 220 - 240 V
-	Frequency	: 50 - 60 Hz
-	Power consumption	: 1400 W
-	Coloursetting	: White / vapour dusk
-	Contents	: 1500 cc
- SAP coding		: HD7626/02

ASO switch

Thermostat

Element

1400 W

N Thermal

fuse

Published by Philips Domestic Appliances and Personal Care

Printed in the Netherlands

Subject to modification

04/01

DISASSEMBLYAND RE-ASSEMBLY ADVISE

- If the switch has to be replaced please follow the next steps:

•Remove bottom base plate.

•Pull the complete pump unit (including hose pieces) downwards until the hose pieces are loosened from the two water tank pipes. (hose pieces and wires must stay connected to the pump).

•Remove the complete top cover including the water tank. (see picture 1)

•Now it is possible to get

to the switch.

picture 1

•To replace the switch, first remove the switch cap from the switch by means of a small screwdriver. (The cap has to be loosened at the inner side of the housing by bending a little bit the plastic paw from the switch cap) (see picture 2)

START

POSITION 1

REMOVE THE

CAP IN THIS

DIRECTION

END

POSITION 2

HOUSING

PART

SMALL

DETENT

PIECE A

picture 2

•Place the new switch en connect the wires, push the plastic switch cap back on the switch.

•Insert the complete top cover assy including plastic tank gently back into the housing.

•Take the pump unit and attach the hose pieces to the water tank pipes of the previously inserted tank. (be sure that the hose pieces are well attached to the water tank pipes, otherwise leakage problems can occur)

•Assemble the base plate again.

HD7626/02

REPAIR INSTRUCTION

Colour code identification:

To determine which service manual is suitable for the appliance that has to repaired please check the following. Look at the type plate identiﬁcation from the appliance on the second row.

The ﬁrst sledge number is the colour code for that appliance. ( /99 )

(for example below the colour code is /01) Example of a type plate:

TYPE HD7624 /01 /A

…

At the service manual heading, the type and colour code are also mentioned for example HD7624/01

/01 is the colour code.

Descaling:

Regular de-scaling will prolong the life of your appliance and will guarantee optimal brewing results.

Follow below steps to de-scale the appliance.

1.Fill the water tank with white vinegar.

2.Let the appliance complete two runs.

3.Let the appliance complete two more ﬂushing cycles with clean water to rinse away all vinegar.

If the above procedure does not restore the function, then switch off the coffee maker when the acid passed through during appr. 3 min.

Keep the appliance in this condition overnight and continue the steps see above procedure.

Transportation lock:

To prevent damaging the dosing/weighting system in case the appliance has to be shipped/transported, It is possible to order a special transportation lock.

For the position of the transportation lock see picture 3.

4222 247 59510

picture 3

The code number transportation lock: 4222 247 59510

OPTIONAL (accessories)

- Commercial trade number jug + lid: HD7966/02 (vapour dusk)

2-4

+ 2 hidden pages