Philips GC4250 Service Manual

Steam Iron Azur 4200
GC4250
Philips Domestic Appliances and Personal Care
Service Manual
PRODUCT INFORMATION
Features
- Color : Black
- Careeza soleplate
- Steam output (40 gram/min)
- Shot Of Steam, SOS (95 gram/min)
- Vertical SOS
- Spray feature
- Tank capacity (340 ml)
- Cord winder
- Cord length (2.4 m)
- Drip stop feature
- Anti-calc feature
- Self clean feature
- Auto-Shut-Off (ASO) feature
- Safety light
- Soleplate storage cover
Safety Information
- This product meets the requirements regarding interference suppression on radio and TV.
- After the product has been repaired, it should function properly and has to meet the safety requirements and legal regulations as officially laid down at this moment.
TECHNICAL INFORMATION
Water Advice
Suitable for tap water use. Advice to mix with equal portion of distilled water or use only distilled water if the tap water is very hard.
Self Clean
When the self clean button is pressed, a sudden release of water into the soleplate loosen scale particles by thermal shock. These particles are then fl ushed out through the steam vents by the water.
Careeza Soleplate
Careeza is a multi-layer chemical substance that gives an excellent gliding effect and better care for the garment.
Vertical Steam
When the iron is kept in a vertical position, the SOS button can be used to iron hanging fabrics such as curtains.
Anti Drip
Water is only released into steam chamber via the tank valve when the soleplate temperature is high enough. If the temperature is too low, the tank valve is closed by means of a bi-metal disc.
Auto-Shut-Off
The power to the heating element is cut off when the iron has been motionless. The “Auto-Off” pilot light starts blinking. When the iron is moved, it is automatically switched on.
Voltage : 220 - 240 V Frequency : 50 - 60 Hz Power : 2000 - 2400 W Dimension (F-box) : 328 (L) x 143 (W) x 181 (H) mm Weight : 1.7 kg (include soleplate cover)
Published by Philips Domestic Appliances and Personal Care Printed in the Netherlands © Copyright reserved Subject to modification
Safety Light
A bright LED built into the water tank stays on as long as the iron is plugged into a power socket. The LED light, obvious from anywhere in the room, remind user that the iron is on.
03/06
DISASSEMBLY ADVICE
GC4250
BACKPLATE 3
BACKPLATE COVER 26
CORDSET 4
BALL SWIVEL 5
Remove Screw A Remove Screws B1, B2
FILLING DOOR 6
INLAY 7
SLIDE UNIT 10
NEEDLE SET 11
TANK SEAL 12
HANDLE 13
SELF CLEAN BUTTONS 14
SPRAY NOZZLE ASSY 15
PUMP ASSY 16
Remove Screw A Remove Backplate 3, 26 Remove Inlay 7 Remove Operation knobs 101, 102 Remove Screws C1, C2 Remove Slide Unit 103, 104 Remove Needle set
105, 106, 107, 108, 109 Remove Screws D1, D2
WATER TANK 18
SOLEPLATE COVER 19
ISOLATION PLUG 20
SOS SEAL 21
DOSING SEAL 22
THERMISTER 2
SOLEPLATE ASSY 23
Remove Screw A Remove Backplate 3, 26 Remove Inlay 7 Remove Operation knobs 101, 102 Remove Screws D1, D2 Remove Handle 13 Remove Screws E1, E2 Remove Water tank 18 Remove Screw F Remove Heat shield Remove Screws G1, G2 Remove Soleplate cover 19
OPERATION KNOBS 8
ELECTRONIC
CONTROLLER 9
Remove Screw A Remove Backplate 3, 26
SAFETY LIGHT REAR CAP 1
SAFETY LIGHT 29
Remove Screw A Remove Backplate 3, 26 Remove Screw J Remove Safety light 29 Remove Inlay 7 Remove Operation knobs 101, 102 Remove Screws D1, D2 Remove Handle 13 Remove Screws E1, E2 Remove Water tank 18 Remove Screw F
REPAIR INSTRUCTIONS
- Due to the high voltage of the iron, ONLY the specified cordsets must be used.
- When replacing thermister assembly (Pos 2), ensure torque applied to the screw is 20 kgfcm. Also, handle the thermister assembly with care so as not to damage it.
- No information about the type number and voltage is stamped onto the typeplate. When replacing the back plate (typeplate is at the bottom), engrave at least the type number & voltage on the typeplate with a sharp object.
- Parts with numbers from 100 and higher cannot be ordered separately, except 101, 102, 117, 118.
OPTIONAL (accessories)
- No specific issues
2-4
Loading...
+ 2 hidden pages