Philips G2G303 Users Manual

G2G303 Instruction

BUTTON OF WIRE CLIP

BATTERY COVER

1． Accessory

Car cigarette adaptor(option)

2． Instructions

a、(1).Press bottom direction button

to open the battery cover, Insert 2
AAA1.5V batteries.(Batteries not
included) close the battery cover; Or
connect cigarette adaptor at one end to
the car cigarette port, the other end to

DC port on the main body.
b、(2).press side stop button and draw out
the inner audio line lightly to proper length then
loose stop button (when you see the red
round of the line, it is the high-point. The length
is about 5inch), Connect product to audio
source(MP3/CD/MD/IPOD and so on). When it
isn’t used, press stop button , the audio line
will draw back to the main body automatically
(Please pull out the jack to prevent your
machine from damage).

３．５ｍｍ　Ｊａｃ

ｋ

DC J a c k

ＬＣＤ　ＤＩＳＰＬＡＹ

UP

DOWN

ON/ OFF

d、Set FM transmitter frequency----press side
function up or down button then adjust the

frequency. With step 0.1MHZ.

e、Turn in the radio to the same channel as the

product to enjoy music

3. Button/Connection Port

a、DC port is for power source connection,

connect cigarette adaptor to car power source.
b、Audio line (Connect to IPOD,MP3,CD,MD and

so on)

c、LCD screen, show the frequency; ranges

between 88.1-107.9MHZthe background light of
LCD will be down after stopping operation for
10seconds then turn into saving power mode..

d、 Stop button----control the audio line。

e、 On/off button---- Turn on/off product by

pressing and holding it for a second.

c、.Press and hold side on/off button for a

second to turn on the machine, three seconds
later,he LCD screen light will be bright and
show the last frequency used.

f、 Up button----pressed once, the frequency

will be up 0.1MHZ

g 、 Down button----pressed once, the

frequency will be down 0.1MHZ.

4． FCC notice

This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications

Any changes or modification not expressly approved by the party responsible could void the user's
authority to operate the device.