Philips CED320 User Manual

53.5mm

Antenna (Black)

Subwoofer (Blue)

Parking (Green/White)

Camera (Pink)

Rear line out R (Red)

Front line out R (Red)

Rear line out L (White)

Front line out L (White)

Camera in (Yellow)

Video out 2 (Yellow)

Video out 1 (Yellow)

5mm

183 mm

3

2

1

CED320

Register your product and get support at

ENG Quick Start Guide

or to select a folder/track/

to start play.

All rights reserved.

to select an item, then press to star t

For video discs, if a menu appears: press

For discs that contain MP3s, WMAs, or

»

play.

»

JPEGs: , press

or

When the unit is idle for over 5 minutes, it •

goes to standby mode and displays screen

to avoid short-circuit, ensure that bare

wires do not touch each other.

picture, then press

Insert USB device

1 Slide down the USB socket cover.

TINGS], then press SEL on the remote

saver.

Set clock

these measurements:

top of the unit.

Ensure that car dashboard opening is within

Remove the two transport screws on the

2

3

control.

1 Press MENU.

2 Press the navigation buttons to select [SET-

If the unit is not fi xed by sleeve but by •

moval keys.

bend the tabs outward to fi x the sleeve.

Remove the mounting sleeve with the re-

Install the sleeve into the dashboard and

4

5

The unit starts playing from the USB

»

device automatically.

2 Insert the USB device into the USB socket.

3 Select [SYSTEM], then press .

4 Select [TIME MODE], then press .

the supplied screws, skip this step.

Place the rubber cushion over the end of the

6

Insert SD/MMC card

1 Press to open the front panel.

2 Insert the SD or MMC card into the card

.

The time mode options are displayed:

[12 HOUR MODE]

[24 HOUR MODE]

»

5 Sselect a mode, then press SEL.

6 Press to return to previous menu and

sound is heard.

battery.

Reconnect the negative terminal of the car

8

select [TIME ADJUST], then press

»

»

bolt.

Slide the unit into the dashboard until a click

7

The unit starts playing from the SD/MMC

slot.

»

card automatically.

7 Press or to enter clock, then press SEL.

Tune to a radio station

1 Press SOURCE to select Tuner.

2 Press or to select band.

Note

Detach the front panel

The front panel can be detached and taken with

you to deter theft.

[FM] or [AM] is displayed.

»

Before installing the unit, detach the front •

panel.

3 Press or to tune to a radio station

or for 3 seconds.

To search for radio station automatically, •

press

manually.

Play discs

to release the panel.

panel toward the left side to disengage it

from the chassis.

Press

Open the panel, then push the right side

1

Take off the panel and store it in the supplied

2

3

side facing up.

1 Press to open the front panel.

2 Insert the disc into the disc slot with label

carry case to protect it from dir t or damage.

»

»

to TUNER mode automatically.

last stopped.

3 To remove the disc, press the button.

The unit plays the last listened program:

»

DVD, Tuner, USB or SD/MMC Card (if there is

USB device or SD/MMC card connected).

Press the knob to turn on the unit.

Turn on

1

When the disc is ejected, the unit switches

Play resumes from the point where it was

© 2008 Koninklijke Philips Electronics N.V.

After a few seconds, the screen turns on.

»

4 Close the front panel.

knob for

more than 2 seconds.

To turn off the unit, press the •

English

Connect wires: ISO connectors

Caution

Ensure that all loose leads are insulated with

•

dashboard and connect them to the bigger

end of the supplied standard connector.

electrical tape.

connector to the unit.

Pull out the ISO connectors from the car

Connect the other end of supplied standard

1

Do the other connections, if applicable.

2

3

until it is correctly engaged.

Attach the trim plate.2 Insert the left side of the panel in the chassis

Attach the front panel

1

mechanism locks it into place.

Press the right side of the panel until the

Close the front panel.

3

4

Mount in the dashboard

Note

For proper operation of the DVD player, the •

chassis must be mounted within 20 degree

horizontal. Ensure that the unit is mounted

within this limitation.

If the car does not have an on-board drive or

1

If you disconnect the car battery in •

a car that has an on-board drive or

navigation computer, the computer may

lost its memory.

If the car battery is not disconnected, •

navigation computer, disconnect the negative

terminal of the car attery.

4

5

6