Always there to help you
Question?
Contact
Philips
Register your product and get support at
www.philips.com/welcome
CED1800BT
User manual
Contents
1 Safety 2
2 Your car entertainment system 3
Introduction 3
Playable media 3
What's in the box 3
Overview of the main unit 4
Overview of the remote control 5
3 Install the car entertainment system 6
Connect wires 7
Mount into the dashboard 10
4 Get started 11
Prepare the remote control 11
Turn on 11
Use the home menu 12
Set the date and time 12
Adjust the screen brightness 13
Switch display designs 13
5 Play from hard media 14
Load a disc 14
Connect a USB storage device 14
Control play 15
Browse recorded les 16
8 Use Bluetooth devices 19
Activate the Bluetooth function 19
Pair a device 19
Play audio from a connected device 21
Make a call 22
9 Adjust sound 23
Adjust the volume level 23
Mute sound 23
Enable the MAX Sound feature 23
Enable the DBB sound effect 23
Enable the FullSound effect 24
Select a preset sound equalizer 24
Others 24
10 Adjust settings 25
Access system setup menus 25
Adjust general settings 26
View system information 26
Adjust Navigation settings 26
Adjust Bluetooth settings 27
11 Others 28
Play external audio/video input 28
Use rear monitors 28
Use buttons on the steering wheel 29
Set the rear view camera 29
Reset the system 29
Replace the fuse 30
Upgrade the rmware 30
6 Listen to radio 17
Switch to radio mode 17
Set up 17
Tune to a radio station 17
Store radio stations in memory 17
Tune to a preset radio station 18
7 Use the navigation system 18
Insert the map data card 18
Navigate your road trip 19
12 Product information 31
13 Troubleshooting 32
General 32
14 Notice 33
Compliance 33
Care of the environment 33
Trademark notice 33
Copyright 34
1EN
1 Safety
Read and understand all instructions before you
use the device. If damage is caused by failure to
follow instructions, the warranty does not apply.
• Use of controls or adjustments or
performance of procedures other than
herein may result in hazardous radiation
exposure or other unsafe operation.
• The device is designed for negative ground
(earth) 12 V DC operation only.
• To reduce the risk of trafc accidents, do
not watch video when driving.
• To ensure safe driving, adjust the volume to
a safe and comfortable level.
• Improper fuses can cause damage or
re. When you need to change the fuse,
consult a professional.
• Use only the supplied mounting hardware
for a safe and secure installation.
• To avoid short circuits, do not expose the
device, remote control or remote control
batteries to rain or water.
• The device shall not be exposed to
dripping or splashing.
• Do not place any sources of danger on
the device (e.g. liquid lled objects, lighted
candles).
• Never insert objects into the ventilation
slots or other openings on the device.
• Never place any objects other than discs
into the disc tray/slot.
• To avoid exposure to laser radiation, do
not disassemble the device.
• Risk of damage to the screen! Never push,
rub, or strike the screen with any object.
• Never use solvents such as benzene,
thinner, cleaners available commercially, or
anti-static sprays intended for discs.
• Clean the device with soft, damp cloth.
Never use substances such as alcohol,
chemicals or household cleaners on the
device.
• Risk of swallowing coin battery!
• The product/remote control may
contain a coin/button type battery,
which can be swallowed. Keep the
battery out of reach of children at all
times! If swallowed, the battery can
cause serious injury or death. Severe
internal burns can occur within two
hours of ingestion.
• If you suspect that a battery has been
swallowed or placed inside any part
of the body, seek immediate medical
attention.
• When you change the batteries, always
keep all new and used batteries out
of reach of children. Ensure that the
battery compar tment is completely
secure after you replace the battery.
• If the battery compar tment cannot be
completely secured, discontinue use
of the product. Keep out of reach of
children and contact the manufacturer.
2 EN
2 Your car
abc
def
entertainment
system
Congratulations on your purchase, and
welcome to Philips! To fully benet from the
support that Philips offers, register your product
at www.philips.com/welcome.
Introduction
With the car entertainment system, you can
• listen to music,
• watch videos,
• view pictures,
• listen to FM and AM/MW radio,
• make phone calls via Bluetooth, and
• navigate your road trip.
Playable media
• Disc
• DVD, Video CD, SVCD, Audio CD,
JPEG Picture CD, MP3-CD, WMA-CD
• DVD-R, DVD-RW, DVD+R, DVD+RW,
CD-R, CD-RW
• USB storage device
• Compatibility: USB 2.0, USB 1.1
• Class support: MSC (Mass Storage
Class)
• Maximum capacity: 32 GB
• Files
• File system: FAT16, FAT32
• Maximum number of folders: 99
• Maximum number of tracks/les: 999
• Maximum level of directory: 8
• Video formats: MPEG1, MPEG2
• Picture format: .jpeg
• .mp3 les
Sampling frequencies: 32 kHz, 44.1 kHz,
48 kHz
Bitrates: 8-320 kbps and variable
bitrates
• .wma les
Versions: V4, V7, V8, V9 (L1 and L2)
Sampling frequencies: 44.1 kHz, 48 kHz
Bitrates: 64-192 kbps and variable
bitrates
• ID3 tag V2.0 or later
• Unsupported les:
AAC, WAV, and PCM les
DRM protected WMA les (.wav, .m4a,
.m4p, .mp4, and .aac)
WMA les in lossless format
What's in the box
Check and identify the contents of the package:
g h
1 Main unit 2 Remote
control
3 ISO male connector
X 2
5 Screw X 4
(M5x8mm)
7 Remote control
battery
4 Rubber
cushion
6 Hexagon
head screw
8 User manual
3EN
Overview of the main unit
l
k
j
i
h
g
a
• Press to eject the disc.
b
• Press to access the navigation system.
• Press and hold to adjust the brightness
of LCD screen.
c
• Press to power on the unit.
• Press and hold to power off the unit.
• Press to mute the speakers or release
them from mute status.
d RESET
• Press to reset the system.
e MAP
• Insert a micro SD card that stores the
digital map data.
f iR sensor
• The sensor that receives infra-red
signals from the remote control.
g AV-IN
• Connect to the audio and video
output sockets of an external player by
a composite AV cable.
a
b
c
d
e
f
h
• Connect to a USB storage device.
i LCD screen
j +/-
• Press to increase or decrease the
volume.
k MIC
• The built-in microphone for phone
calls.
l Disc slot
4 EN
Overview of the remote control
y
x
w
v
u
t
s
r
q
p
o
n
m
a SOURCE
• Press repeatedly to select a source.
b
• Press to eject the disc.
c
• Return to the previous menu or mode.
d VOLUME + / -
• Press to increase or decrease the
volume.
e
• Access the home menu.
f
• Enable or disable the MAX Sound
feature.
g
• Switch to video playback mode.
a
b
c
d
e
f
g
h
i
j
k
l
h
• Enable or disable the FullSound effect.
i DVD AUDIO
• Select an audio language or audio
channel.
j DBB
• Enable or disable the DBB (Dynamic
Bass Boost) sound effect.
k EQ
• Select a preset sound equalizer.
l MUSIC ZONE
• Select a music listening zone.
m
• Turn on or off the screen.
n
• Select an available subtitle.
o TOP MENU
• Access the top menu.
p DVD MENU
• Access the DVD menu.
q
• Switch to music playback mode.
r
• Switch to picture slideshow mode.
s
• Start, pause, or resume the play.
t OK
• Conrm an option.
u / /TRACK -/TRACK +
• Skip to the previous or next track,
chapter, or le.
• For DVD, press and hold to select a
speed for fast backward or forward
search.
v BAND
• Select a tuner band.
w / /PRESET +/PRESET -
• Tune to the previous or next preset
radio station.
• Skip to the previous or next folder.
5EN
x
• Press to power on the system.
• Press and hold to power off the
system.
• Press to mute the speakers or release
them from mute status.
y
• Press to adjust the brightness of the
LCD screen.
3 Install the car
entertainment
system
Always follow the instructions in this chapter in
sequence.
These instructions are for a typical installation.
However, if your car has different requirements,
make the adjustment accordingly. If you have
any question regarding installation kits, consult
your local retailer.
Note
• This system is designed for negative ground (earth) 12V
DC operation only.
• Always install this system in the car dashboard. Other
locations can be dangerous as the rear of the system
heats up during use.
• To avoid short-circuit: before you connect, make sure
that the ignition is off.
• Make sure that you connect the yellow and red power
supply leads after all other leads are connected.
• Make sure that all loose leads are insulated with
electrical tape.
• Make sure that the leads do not get caught under
screws iron parts that will move (e.g. seat rail).
• Make sure that all ground (earth) leads are run to a
common ground (earth) point.
• Use only the supplied mounting hardware for a safe
and secure installation.
• Improper fuses can cause damage or re. When you
need to change the fuse, consult a professional.
• When you connect other devices to this system, make
sure that the rating of the car circuit is higher than the
total fuse value of all the connected devices.
• Never connect speaker wires to the metal body or
chassis of the car.
• Never connect speaker wires with stripes to one
another.
6 EN
Connect wires
Note
• Make sure that all loose leads are insulated with
electrical tape.
• Consult a professional to connect wires as instructed
below.
• Before connection, check the car's wiring carefully.
1 Connect the ISO male connectors.
2 Connect other wires if necessar y.
Caution
• To avoid an accident, the driver must not watch video
while driving. By design, this system disallows watching
video during drive. Park your car in a safe place and
engage the parking brake before watching video.
Note
• When the parking brake of your vehicle is not engaged,
the video blocking system is activated. It blocks the
display of front video source only.
• If the system is not properly connected with the
parking brake control module of your vehicle, video
signals will be blocked by the system, with the below
message displayed on the TFT.
ISO male
connectors
a Green strip, black-
edged green strip
b White strip, black-
edged white strip
c Gray strip, black-
edged gray strip
d Purple strip, black-
edged purple strip
e Red strip Ignition key +12V
f Blue strip Motor/electric
g White-edged blue
strip
h Black strip Ground
i Yellow strip The +12V car
Connect to
Rear left speaker
Front left speaker
Front right speaker
Rear right speaker
DC when ON/
ACC
antenna relay
control lead
Amplier relay
control lead
battery which is
energized at all
times
Connectors and
sockets on rear panel
1 For ISO male
connectors
2 REAR OUT R (Red
socket)
3 AV-IN R (Red socket) Right audio
4 AV-IN L (White
socket)
5 REAR OUT L (White
socket)
6 VIDEO IN (Yellow
socket)
External sockets
or connectors
As indicated
above
Rear right
speaker
channel output
socket of an
external player
Left audio
channel output
socket of an
external player
Rear left speaker
Video output
socket of an
external player
7EN
Connectors and
sockets on rear panel
7 VIDEO OUT 1
(Yellow socket)
8 VIDEO OUT 2
(Yellow socket)
9 RADIO ANTENNA
(Black connector)
10 CAMERA IN (Purple
socket)
11 SUB-W OUT (Blue
socket)
12 REVERSE CAMERA
(Purple wire)
13 PARKING BRAKE
(Pink wire)
14 OE SWC IR REMOTE
IN (Brown wire)
15 OE SWC IR REMOTE
IN (Black wire)
16 OE SWC AD LEARN
(White wire)
17 OE SWC AD LEARN
(White wire)
18 OE SWC AD LEARN
(Black wire)
19 External Mic (Black
connector)
20 GPS AERIAL (Black
connector)
External sockets
or connectors
Video input
socket of an
external display
device
Video input
socket of an
external display
device
Radio antenna
Video output
socket of an
external camera
Sub-woofer
Reverse camera
(B+)
Parking brake (-)
OE SWC remote
in
Ground
OE SWC AD
Learn line 1
OE SWC AD
Learn line 2
Ground
External
microphone
GPS smart
antenna
Tip
• The pin arrangement for the ISO connectors depends
on the type of your vehicle. To avoid damage to the
system, connect properly.
8 EN
t
s
r
q
p
o
n
m
l
a
bcde fghijk
9EN
Mount into the dashboard
Note
• Make sure that wires are correctly connected before
you mount the main unit into a car.
• If preset radio stations are lost when the ignition key
is turned OFF and then back ON, reconnect the red
leads crosswise to the yellow ones.
1 If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
• If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
• If the car battery is not disconnected,
to avoid short-circuit, make sure that
bare wires do not touch each other.
2 Make sure that the car dashboard opening
is within these measurements:
5 mm
3 Slide the unit into the dashboard until a
click sound is heard.
4 Reconnect the negative terminal of the car
battery.
182 mm
112 mm
• Since the unit cannot be used if the
dashboard opening's slant angle is
above 20 degrees, make sure that the
horizontal slant of the car dashboard
opening is between 0 and 20 degrees.
10 EN
Loading...