Philips AU2904N, AU2904D Datasheet

Philips Semiconductors Linear Products Product specification

AU2904Low power dual operational amplifier

154

August 31, 1994 853-1633 13721

DESCRIPTION

The AU2904 consists of two independent, high-gain, internally
frequency-compensated operational amplifiers designed specifically
to operate from a single power supply over a wide range of voltages.
Operation from dual power supplies is also possible, and the low
power supply current drain is independent of the magnitude of the
power supply voltage.

FEATURES

•Internally frequency-compensated for unity gain

•Large DC voltage gain: 100dB

•Wide bandwidth (unity gain): 1MHz (temperature-compensated)

•Wide power supply range Single supply: 3V

DC

to 30VDC or dual

supplies: ±1.5V

DC

to ±15V

DC

•Very low supply current drain (400µA): essentially independent of

supply voltage (1mW/op amp at +5V

DC

)

•Low input bias current: 45nA

DC

(temperature-compensated)

•Low input offset voltage: 2mV

DC

and offset current: 5nA

DC

•Differential input voltage range equal to the power supply voltage

•Large output voltage: 0V

DC

to V+-1.5VDC swing

PIN CONFIGURATION

+

D and N Packages

1

2

3

4 5

6

7

8

OUTPUT A

INVERTING INPUT A

NON INV INPUT A

V–

V+

OUTPUT B

INVERTING INPUT B

NON INV INPUT B

A

–

B

–

+ –

Top View

UNIQUE FEATURES

In the linear mode the input common-mode voltage range includes
ground and the output voltage can also swing to ground, even
though operated from only a single power supply voltage.

The unity gain crossover frequency and the input bias current are
temperature-compensated.

ORDERING INFORMATION

DESCRIPTION TEMPERATURE RANGE ORDER CODE DWG #

8-Pin Plastic Dual In-Line Package (DIP)

-40 to +125°C

AU2904N 0404B

8-Pin Plastic Small Outline (SO) Package

-40 to +125°C

AU2904D 0174C

EQUIVALENT SCHEMATIC

INPUTS

+

_

V+

6µA 6µA

OUTPUT

100µA

Q5

Q6

Q7

C

C

Q2

Q3

Q1

Q4

Q8 Q9

Q10

Q11

Q13

50µA

Q12

R

SC

Philips Semiconductors Linear Products Product specification

AU2904Low power dual operational amplifier

August 31, 1994

155

ABSOLUTE MAXIMUM RATINGS

SYMBOL PARAMETER RATING UNIT

V

S

Supply voltage V+ 32 or ±16 V

DC

Differential input voltage 32 V

DC

V

IN

Input voltage -0.3 to +32 V

DC

P

DMAX

Maximum power dissipation,
TA=25°C(still-air)

1

N package 1160 mW
D package 780 mW

Output short-circuit to GND

5

V+<15VDC and TA=25°C Continuous

T

A

Operating ambient temperature range

AU2904 -40 to +125 °C

T

STG

Storage temperature range -65 to +150 °C

T

SOLD

Lead soldering temperature (10sec max) 300 °C

NOTES:

1. Derate above 25°C at the following rates:
N package at 9.3mW/°C
D package at 6.2mW/°C

DC ELECTRICAL CHARACTERISTICS

TA=25°C V+ =+5V, unless otherwise specified.

AU2904

SYMBOL

PARAMETER

TEST CONDITIONS

Min Typ Max

UNIT

RS=0Ω ±2 ±7

VOSOffset voltage

1

RS=0Ω, over temp. ±9

mV

V

OS

Drift RS=0Ω, over temp. 7 µV/°C

I

OS

Offset current IIN(+)-IIN(-) ±5 ±50 nA

Over temp. ±150 nA

I

OS

Drift Over temp. 10 pA/°C

IIN(+) or IIN(-) 45 250

I

BIAS

Input current

2

Over temp., IIN(+) or IIN(-) 40 500

nA

I

BIAS

Drift Over temp. 50 pA/°C

V

CM

Common-mode voltage range

3

V+=30V 0 V+-1.5 V

Over temp., V+=30V 0 V+-2.0 V

CMRR Common-mode rejection ratio V+=30V 65 70 dB
V

OH

Output voltage swing

RL≥2kΩ, V+=30V,

over temp.

26

RL≥10kΩ, V+=30V,

over temp.

27 26

V

V

OL

Output voltage swing RL≥10kΩ, Over temp. 5 20 mV

I

CC

Supply current

RL=∞, V+=30V

R

L

=∞ on all amplifiers,

Over temp., V+=30V

0.5

0.6

1.0

1.2

mA
mA

RL≥2kΩ, V

OUT

±10V,

A

VOL

Large-signal voltage gain V+=15V 25 100

Over temp. 15

PSRR Supply voltage rejection ratio RS=0Ω 65 100 dB

Amplifier-to-amplifier coupling

4

f=1kHz to 20kHz

(input referred)

-120 dB

V

IN+

=+1VDC, V

IN-

=0VDC, V+=15V

DC

20 40

I

OUT

Output current source

Over temp. 10 20

mA

V/mV