Microsized
Lap Dog
Tr ainer
Advanced features help
develop good household
habits quickly
Great for dogs big and small
Microsized
Lap Dog Trainer
Advanced features help develop good
behavior quickly in dogs big and small.
This featherweight collar receiver rests easily on your dog’s neck. Innovative
in-set contact probes precisely fit the small necks of toy and other small "lap
dog" breeds. Optional wide set probes for larger dogs are included. This system
also features tone-only training options, for greater training flexibility.
System Includes:
• Miniature, featherweight collar receiver – • Optional in-set contact probes for
smallest on the market today thinner neck sizes
• Compact, lightweight, six-button • 4 levels of stimulation, instantly
transmitter available
• Options for
training – no stimulation required • Test light
• All batteries included • Introduction to Dog Training DVD
• FREE Professional Training Support • Limited Lifetime Warranty
WE CARE. CALL US FIRST. 1-800-826-5527
LIMITED LIFETIME WARRANTY
Invisible Technologies warrants to the original retail purchaser, that Innotek brand products will be free from defects in material and workmanship, under normal use, for a period of one year from the date of the original retail purchase. This Limited Warranty excludes: accidental
damage due to dog chews; lightning damage where an INNOTEK lightning protection component is not in use (in-ground pet fencing systems); or neglect, alteration and misuse.
Invisible Technologies offers several product exchange options during the warranty period. If service is required, call 1-800-826-5527 to discuss the service plan that best serves your needs. Costs are dependent on the processing time and the desired shipping options. Please do
not return this product to your retailer.
After one year from date of original retail purchase, we will repair, replace or upgrade your product at a fixed rate based on the component.
Invisible Technologies, Inc., shall not be liable or responsible for any incidental or consequential damages resulting from the use of the product or caused by any defect, failure or malfunction of the product, whether a claim is based upon warranty, contract, negligence or otherwise.
Extended wear may cause skin irritation. Refer to owner's guide.
GOOD and BAD tone-only • Range to 200 feet
7 62964 18138 5
2400268-1
Quick Start Guide
Step 1
Fit Collar on Dog
Thread the included collar strap through the channels
on the receiver. With the collar turned OFF, place on
dog and adjust to fit. The collar fit should be snug, yet
loose enough to allow one finger to fit between the
strap and the dog’s neck. Fit is important because a
loose collar may cause inconsistent performance. It’s
okay to trim any excess strap length.
Step 2
Power Up
ON
OFF
OPEN
Tr ansmitter: Insert 12v alkaline battery in the transmitter positive (+) side out. Replace metal cap.
Receiver: Your receiver comes ready to go with batteries installed. Activate the collar by turning the
receiver’s battery cover cloc
Step 3
Match Components
Press GOOD Tone button on the transmitter within
30 seconds of turning ON the receiver. The components now work together.
You may wish to set tone mode before working with
your dog. See "Setting/Changing the tone mode."
When not in use, be sure to turn the receiver OF to
extend battery life.
kwise to the ON position.
SD-70 Lap Dog Trainer
Understanding the Transmitter
The handheld device signals the collar receiver to
produce stimulation and/or tone. The transmitter is
water-resistant and should not be immersed in water
or placed in a dishwasher.
Transmitter Buttons:
1-LOW to 4-HIGH. – Select any of 4 stimulation levels instantly. We recommend that you always start
training your dog with the lowest stimulation, and
increase to a higher level if necessary. You will know
when you’ve reached the right level when your dog
responds by twitching his head, neck or shoulders or
by perking up his ears. If the dog vocalizes, you need
to go to a lower level.
You control the length of the stimulation by how long
you press the button. For a short stimulation, press
and release the button. For a longer stimulation, hold
the button down. A maximum of 10 seconds may be
applied before the safety feature to prevent over-correction engages. After 10 seconds, stimulation will be
locked out for another 10 seconds. During the lockout period a solid tone will sound.
GOOD Tone Button
Simply press the GOOD tone button when your dog
does something good and follow up immediately with
a favorite treat and plenty of praise.Your dog will
quickly learn to associate the GOOD tone with proper behavior.
BAD Tone Button
The BAD tone followed by the stimulation is used for
inappropriate behavior.Your dog will quickly learn to
associate the BAD tone with inappropriate behavior.
You can then use the BAD tone alone to discourage
misbehaviors.
PROGRAM – used in tandem with buttons on the
transmitter face to change ID Codes or set tone-withcorrection options.
Your transmitter has an LED light:
• Pulsating green light – unit is transmitting
• Pulsating red light – low battery
Changing the ID Code
The SD-70 offers 2,048 ID codes in case you experience problems from other nearby training units. To
change codes:
• Turn the collar off.
• Press and hold the PROGRAM button on the back
of the transmitter.
• Continue pressing PROGRAM, while pressing 1LOW on the face of the transmitter.
• Release only the PROGRAM button, while continuing to press 1-LOW.
• When the LED ceases flashing red-green, release
1-LOW.
• Rematch the components as shown in Quick Start
Step 2.
Setting/Changing the Tone Mode
Your can set the SD-70 to deliver the BAD tone automatically when you push a stimulation button. Three
settings are possible – tone with the stimulation, tone
followed by delayed stimulation or stimulation only.
1. Press and hold the PROGRAM button on the back
of the transmitter.
2. Press and hold one of the following to select the
tone option:
• BUTTON 2 for tone ON with stimulation
• BUTTON 3 for tone OFF with stimulation
• BUTTON 4 for tone with a one-second delay
before stimulation
3. While continuing to hold BUTTON 2, 3, or 4,
release the PROGRAM button. The transmitter light
will stay solid for a couple of seconds, and then go
out.
4. As soon as the solid light goes out, release BUTTON 2, 3, or 4.
Understanding the Receiver
The collar receiver produces stimulation and/or tone.
The receiver is water-resistant and should not be
immersed in water or placed in a dishwasher.
Testing the Receiver
You may wish to test the collar from time to time. To
test:
• Hold the test light provided across the receiver’s
posts
• Press a stimulation button 1-LOW to 4-HIGH.
• Test light will illuminate.
• The intensity of the test light will increase as the
level increases.
Replacing Batteries
To replace batteries, twist the battery cover counterclockwise, to the OPEN position. Lift the cap out,
remove old batteries and insert new batteries with
positive (+) side down toward the battery cap lid.
Changing Posts
Your SD-70 receiver
comes with innovative
inset probes designed
to precisely fit the
smaller necks of toy
and lap-dog breeds.
To change the posts to the in-set design, simply
remove the contact posts, then assemble the in-set
posts using the Phillips head screws provided (see
illustration). Be sure that the post base lifts up and
away from the battery cap on/off switch.
Replacement batteries:
Your SD-70 transmitter uses a 12-volt alkaline battery, and the receiver uses two 3volt Lithium coin cell batteries (CR-2032). These are commonly available where you
bought your training system, or where batteries are sold.
Compliance with U.S. Telecommunications Regulations
This Innotek Remote Training System is designed to meet requirements set forth by
United States country telecommunications authorities. Note that in some countries,
use may be limited due to national frequency planning requirements. The user is
responsible for respecting those rules.
Training Tips
Watch the included DVD to get the basics for training your dog properly with a remote
trainer.
Always praise your dog for good behavior!
Teach him what the commands mean before introducing the collar as a reinforcement
tool.
Keep training sessions brief, about ten minutes of training and then a rest or play
period of at least equal length.
Dogs learn through repetition. You may have better training success if you can elicit
an undesired behavior when you can anticipate it. For example, if the dog misbehaves
and jumps on visitors, have someone come in and out of the front door several times
over a half-hour period. You'll be expecting it and will be ready to teach your dog the
right behavior.
Always end a training session on a positive note. Let the dog have success. This way
he'll look forward to the next session.
Tr aining should be fun for both you and your dog. Never train when you are angry. If
you get frustrated during training, stop and come back to it later.Your dog will learn
better when you are both relaxed.
We recommend your dog be at least six months old before starting a remote training
program. You will be asking your dog to concentrate for periods of time and to remember what you have taught.Young puppies do not necessarily have the required mental
development or attention span for these activities.
The goal of training is to condition your dog to respond to your verbal command
under all situations. You should plan on using the collar for at least four months. A
good rule is, once started with a remote trainer, to regularly have the collar on when
you take the dog out. This will ensure that he will always be imprinted with the correct
response to your commands and that you are always in control.
Ta ke advantage of the FREE Professional Training Support that comes with your
Innotek remote trainer purchase.
Register Your Product:
Your product can be registered on our website at
www.innotek.net
If you cannot solve the problem by following these steps, please call 1-800-826-5527.
IMPORTANT ADVICE
1. Read the complete manual and follow all directions. If you have any questions, please
call 1-800-826-5527.
2. This device is intended for use only on dogs. Never attempt to use it for any purpose
not described in this manual.
3. Never perform set-up procedures while the collar is on your dog.
4. Any collar worn for extended periods can cause a condition similar to bedsores, known
as Pressure Necrosis. To reduce the possibility, you must do the following:
• Never leave the collar on the dog for more than 12 consecutive hours.
• Examine the dog’s neck daily for any signs of a rash or a sore.
• Supervise your dog during the first 2 days of training.
• Check the fit to prevent excessive pressure; you should be able to insert one finger
between the collar strap and your dog’s skin.
• Wash the dog’s neck area and the probes of the collar weekly with a wash cloth.
• If the condition persists beyond 24 hours, see your veterinarian.
5. Do not attempt to dismantle or repair any components of this system; doing so will void
the warranty in full. The computerized circuitry should be serviced only by an authorized
expert.
6. Realize that because dogs have unique temperaments, there is no way of knowing how
your dog will react to the introduction of a training collar system. For the safety of your
dog, a long lead should be used during initial training so you have control of the situation.
7. If you have reason to believe that your dog may pose a danger to others, harm itself,
or react adversely to the collar, do not rely solely on this product to train your dog. If your
dog shows signs of growling, snarling or biting while using the collar, stop immediately.
Aggression in dogs has many causes. We recommend that you consult a knowledgeable
professional dog trainer or animal behaviorist with experience with aggressive dogs if your
dog has shown any of these characteristics.
8. Occasionally, a dog cannot be trained to respond to a training collar. Sometimes even
a properly trained dog may disobey a command.Therefore, Invisible Technologies, its distributors, and dealers cannot guarantee that the system will in all cases keep the customer’s animal from disobeying commands.
FREE Professional Training Support
Additional behavior or training issues? Looking for the best way to
get a well-behaved dog? Just call our FREE Professional Training Support hotline at
800-364-3362 and speak with the professionals
at Dogstar Training.
Visit www.partnersinbehavior.com
Troubleshooting
If the collar appears not to be working, try the following:
• Adjust the collar strap to fit.
• Test the receiver with the test light. If no light, replace the battery.
• If the transmitter LED is out, replace the transmitter battery.
• Rematch the components as shown in the Quick Start Guide.
• Check that the probes are tightened and are the correct spacing.
• Ensure that the probes are touching the dog’s skin.
• If necessary, trim the dog's hair to ensure proper skin contact. Never shave the
dog’s neck.
• Use a stronger stimulation level.
Invisible Technologies, Inc.
1-800-826-5527
www.innotek.net
Innotek, the Innotek logo, and Free Spirit are registered trademarks of Invisible Technologies, Inc.
All other product and service names are the property of their respective owners.
© 2004, Invisible Technologies, Inc.
All rights reserved
Loading...