Petsafe Deluxe Big Dog Remote Trainer User Manual
Deluxe
Remote Trainer
Owners Manual
INSTRUCTION MANUAL
Thank you for purchasing your Deluxe Remote Trainer, one of the finest training
systems available for training your dog. Due to the similarities between the Big and
Little dog receivers, both are discussed in this manual. Two simple steps will prepare
your unit for use.
Step I – Insert the batteries in the handheld transmitter and receiver collar.
Step II – Activate the receiver collar.
Please remember to fill out your warranty card before continuing. Either mail the
enclosed card or register online at www.petsafe.net.
Push button
(on/off) switch
LED
Contact
Points
Big Dog Receiver
(BDT-205)
Instantaneous Level
Adjustment Knob
LED
Tone Only
Button
Stimulation
without
Tone Button
Deluxe Hand Held
2
Transmitter (PPT-105)
Little Dog Receiver
(LDT-205)
Step I — Insert Batteries
Receiver for the PDLDT-305 Little Dog Trainer
• Use a small Philips screwdriver to remove the two screws on the receiver.
• Press the battery door up in the direction of the arrows on the door. It will move up
slightly and the door will release.
• Insert two, 3-volt lithium CR2032 batteries per the diagram on the receiver.
• Check to ensure the gasket is in place and clean.
• Replace the battery door.
• Tighten the screws. Do not over tighten.
Press Door Up Pull Door Out
Receiver for the PDBDT-305 Big Dog Trainer
• Use a small Philips screwdriver to remove the two
screws on the receiver.
• Remove the battery door.
• Insert two, 3-volt lithium CR2032 batteries per the
diagram on the battery door.
• Check to ensure o-ring is in place and clean.
• Replace the battery door. Press and snap door into
the receiver.
• Tighten the screws. Do not over tighten.
Hand Held Transmitter for Both Remote Trainers.
• Pull the battery door open at the top.
• Insert the 9V battery according to the diagram in the
transmitter. It will only fit one way.
• Replace the battery door by positioning the bottom
edge and snapping door into place.
• Ensure the receiver collar is not on the dog. Activate the
transmitter by pressing either the
or button.
The transmitter LED will light.
Gasket for the PDLDT
O-Ring for the PDBDT
Positive “+” polarity of battery
3
Loading...