How it Works
Perlick
Loading...
CC24W
Owner’s Manual
24 pgs4.03 Mb0

Perlick CC24W Owner’s Manual

Installation
& Operation Manual
Wine Column Refrigeration
Model CC24W Series
Model CC24D Series
Model CC24W-1-4R Shown
Form No. Z2487
11.10.2017
DANGER
WARNING
CAUTION
TABLE OF CONTENTS
General Information ................................................................................................................................. 2
Opening/Niche Dimensions ..................................................................................................................... 5
Placement and Alignment of Appliance ................................................................................................... 6
Anti-Tip Bracket ....................................................................................................................................... 7
Installing Door Overlay Panel .................................................................................................................. 9
Door Trim Installation............................................................................................................................. 12
Grill Installation ...................................................................................................................................... 13
Air Filter Installation ............................................................................................................................... 14
PerliQ Digital Control Operation ............................................................................................................ 15
Stainless Steel/Surface Care................................................................................................................. 18
Use and Care Information ..................................................................................................................... 19
Warranty ................................................................................................................................................ 20
GENERAL INFORMATION
Introduction
Congratulations on your purchase of a Perlick commercial wine column refrigerator. This manual has been prepared to assist you in the installation of your column refrigerator and to acquaint you with its operation and maintenance.
We dedicate considerable time to ensure that our products provide the highest level of customer satisfaction. If service is required, your dealer
can provide you with a list of qualied service
agents. For your own protection, never return merchandise for credit without our approval.
We thank you for selecting a Perlick product and assure you of our continuing interest in your satisfaction.
SAFETY
PLEASE READ all instructions completely before attempting to install or operate the unit. Take particular note of the DANGER, WARNING an CAUTION information in the manual. The
information is important for the safe and e󰀩cient
installation, operation and care of your Perlick unit.
Indicates a hazard that WILL result in serious injury or
death if precautions are not followed.
Warranty Registration
To register your product, visit our web site at www.perlick.com. Click on “Commercial”, then “Resources”, then “Use and Care”, and then “Warranty Registration Form”. You must complete and submit this form or the installation date will revert back to the ship date.
Please record the purchase date and the dealer’s name, address and telephone number below.
Model Number: ________________________ Serial Number: _________________________ Purchase Date: _______________________ Dealer Name & Address ______________________________________ ______________________________________ ______________________________________ Phone Number__________________________
NOTE: See page 20 for full warranty details.
Indicates a hazard MAY
cause serious injury or
death if precautions are not followed.
Indicates a hazard where
minor injury or product damage may occur if precautions are not followed.
Read and understand all information in this manual before attempting the installation.
All electrical work must be performed by a qualied technician and
conform to all applicable state and local codes.
Printed in USA 2
IMPORTANT!
WARNING
CAUTION
CAUTION
SITE PREPARATION
When fully stocked, Perlick wine column refrig-
Carefully inspect the cabinet
for hidden damage. If damage is discovered, le
your claim immediately with the transportation company. Perlick is not responsible for damage in transit.
When moving the unit, be
sure to protect finished flooring with appropriate material to avoid damage from moving the appliance.
If unit has been laid on its
back or sides, place unit upright and allow minimum of 24 hours before connecting the
unit. Failure to do so can a󰀨ect the function
and performance of the appliance.
This appliance should be installed in a dry, ventilated indoor location. The ambient temperature of the location must be between 55°F (13°C) and 100°F (43°C) for optimal performance.
eration is very heavy. To ensure safety and pre­vent home damage, the load-bearing capacity
of your oor must be 550 lbs for each CC24W
column being installed.
This product must be installed on a level oor
for safety and optimal performance. The base
must be at to ensure anti-tip brackets properly
function and that the refrigeration system is lev-
el. Any walls and surrounding furniture/xtures need to be securely attached to the oor, wall
studs or concrete prior to installing the column.
To ensure proper performance, the air intake (toe kick) must not be blocked. Perlick refrigera­tion is front-breathing, and covering the intake will cause the system to overheat and fail.
3 Printed in USA
WARNING
CAUTION
CAUTION
DANGER
DANGER
DANGER
WARNING
84"
24"
DANGER
PRIOR TO INSTALLATION
Safety Precautions
Inspect the electrical cord and plug for damage prior
to plugging the unit in.
If service is necessary, repair work must be
performed by a Perlick authorized servicer.
Work done by unqualied individuals could
potentially be dangerous and will void the warranty.
If unit has been laid on its
back or sides, place unit upright and allow minimum of 24 hours before connecting power. Failure to follow this procedure may damage the compressor and void the warranty.
Do not use or store flammable liquids (ie;
gasoline) or vapors near the appliance.
is secured at all times with the door closed until installed. Install as directed using anti-tip brackets provided to prevent tipping.
Perlick columns are top heavy. It is important that it
Take special care when
moving to prevent injury.
Installation must comply with all applicable electrical codes. The electrical supply must be located within the shaded area of the illustration below. A separate circuit, servicing only this appliance, is required. A ground fault circuit interrupter (GFCI) is not recommended and may cause interruption of operation. The outlet should be placed in the hatched area dimensioned below.
Electrical Supply 115V, 60Hz., Phase 1, 3.3
amps Service Dedicated 15 amp circuit Power/Cord Type/
Length
NEMA 5-15P w/5’ power cord
5 1/4"
1/2"
3"
ELECTRICAL
4"
3"
OUTLET LOCATION
Electrical
Serious electrocution hazard. Electrical grounding is required. This appliance is equipped with a 3-prong (grounding) polarized plug for your protection against possible shock hazards. Failure to comply with these electrical guidelines may
result in possible death or serious injury, re
or loss of property.
Never use an extension cord to connect the unit to the electrical source. Do not use a two-prong adapter or remove the power cord ground prong.
Printed in USA 4
INSTALLATION
Installation Tools and Materials
• Screwdrivers (standard Phillips.)
• Power Drill
• Drill bits (masonry bits required for concrete
installation)
FACE
• Standard socket, wrench and 1/2” socket
• 2’ and 4’ levels
• Material to protect ooring and surrounding
cabinetry
For Built-In Applications
Opening Dimensions
The depth of each Perlick column is 24” (610) to door face (not including the 3/4” overlay). Allow for
door panel thickness when planning the nished opening depth. A minimum of 4” (102) nished
return is required on all sides of the opening. See below for opening dimensions drawing.
It is important that the side walls of the niche are plumb prior to installation. The minimum thickness of both the side walls and the top wall must be 5/8” (16). The minimum thickness of the toe kick panel must be 1/2” (13). A thickness of 3/4” (19) is recommended.
Framed cabinets will require additional filler material behind the face frame for attaching anti­tip brackets. Refer to the illustration below.
FILLER MATERIAL
5 Printed in USA
CAUTION
WARNING
CAUTION
WARNING
PLACEMENT & ALIGNMENT
Before moving the unit
into position, secure the door closed and
protect any nished ooring.
If the unit has been on its
back, it must stand upright for a minimum of 24 hours before connecting power.
Move the unit near the opening. Plug the power cord into the grounded outlet and roll the unit into position. Push unit into place.
Leveling
Front and rear leveling legs can be adjusted from the front once the unit is positioned.
NOTE: Remove grill to access leveling adjustment access holes.
Once the unit is in position, height adjustment
can be made from the front. Using the hex
driver leveling tool, turn clockwise to raise the unit or counterclockwise to lower. Refer to the illustration below.
When the unit is properly leveled, door adjustments are less likely to be necessary.
Level the unit to the oor,
not surrounding cabinetry. This could a󰀨ect
the operation of the unit, such as door closing.
To reduce the possibility
of the unit tipping forward, the front leveling
legs must be in contact with the oor.
Adjusting front leveling legs.
LEVELING THE UNIT
Adjusting rear leveling legs.
Printed in USA 6
WARNING
CAUTION
ANTI-TIP BRACKET
The anti-tip bracket and supporting hardware is included with your unit. In the case of dual
installation, each individual unit must be outtted
with the included anti-tip brackets.
For drawings of the anti-tip bracket installation on integrated unit, see below. For drawings of the anti-tip bracket installation on freestanding units, see page 8.
glasses and use other necessary protective devices or apparel when installing or working with anchors. Anchors are not recommended for use in lightweight masonry material such as block or brick, or for use in new concrete
which has not had su󰀩cient time to cure. The
use of core drills is not recommended to drill
Always wear safety
holes for anchors.
Verify there are no electrical wires or plumbing in the area which the screws could penetrate.
NOTE: Do not fasten anti-tip brackets to adjacent cabinetry until the cabinet has been leveled.
Anti-Tip Bracket Installation for Built-In Applications
OUTER FRAME
ANTI-TIP
OUTER FRAME
BRACKETS
ANTI-TIP BRACKETS
INSTALLATION WITH OUTER FRAME
ANTI-TIP BRACKETS SIDE
ANTI-TIP BRACKETS
INSTALLATION WITH CABINET WALLS
ANTI-TIP BRACKETS
OUTER FRAME
ANTI-TIP BRACKETS
INSTALLATION WITH OUTER FRAME
DOOR NOT SHOWN
DETAIL P
SCALE 1 : 6
OUTER FRAME
ANTI-TIP BRACKETS
7 Printed in USA
Anti-Tip Application for Freestanding Applications
NOTE: Cabinet must be leveled before securing to wall
with anti-tip bracket.
Printed in USA 8
Loading...
+ 16 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use