Pentax 4600g Quick Start Manual
4600g, 4600r, 4600rp, 4800i
Quick Start Guide
1
Note: Refer to your user’s guide for information
about cleaning your device.
For localized language versions of this document,
go to www.honeywell.com/aidc.
Getting Started
Turn off computer’s power before connecting the
scanner, then power up the computer once the
scanner is fully connected.
USB Connection
2
Keyboard Wedge Connection
Serial (RS-232) Connection
3
Reading Techniques
The view finder
projects an aiming
beam that should
be centered over
the barcode, but
can be positioned
in any direction for
a good read.
Hold the scanner
over the barcode,
pull the trigger, and center the aiming beam on the
barcode.
The aiming beam is smaller when the scanner is
closer to the code and larger when it is farther from
the code. Hold the scanner close to smaller
barcodes, and farther away from large barcodes to
get a proper read.
If the barcode is highly reflective (e.g., laminated),
you may need to tilt the scanner at an angle so the
barcode can be scanned.
Standard Product Defaults
The following barcode resets all standard product
default settings.
Standard Product Defaults
4
Interface
Scan the barcode that describes the PC or interface
you are using.
AT/PS2 Keyboard Wedge
(Default)
RS-232
USB Keyboard (PC)
Emulate External Keyboard
Japan DOS/V
USB Japanese Keyboard (PC)
5
Keyboard Country
Scan the Program Keyboard Country barcode
below, then scan the numeric barcode(s) from
page 10, then the Save barcode to program the
keyboard for your country. As a general rule, the
following characters are not supported by the
scanner for countries other than the United States:
@ | $ # { } [ ] = / ‘ \ < > ~.
Note: For a complete list of country codes, see the
User’s Guide for your product at our website,
www.honeywell.com/aidc.
Country Code Scan Country Code Scan
Belgium 1 Italy 5
Denmark 8 Norway 9
Finland 2 Spain 10
France 3 Switzerland 6
Germany/Austria 4 USA (Default) 0
Great Britain 7
Program Keyboard Country
Save
Loading...