Pentair Everpure MH User Manual

PERFORMANCE

WATER TREATMENT PRODUCTS

1040 Muirﬁeld Drive • Hanover Park, IL 60133 • 630.307.3000 • FAX 630.307.3030

MH AND MH2 WATER FILTERS

MH Cartridge Part No. EV9613-01 (1-pack)

Part No. EV9613-06 (6-pack)

MH2 Cartridge Part No. EV9613-21 (1-pack)

Part No. EV9613-26 (6-pack)

FEATURES

• Finely polishes treated water to premium quality.

• Reduces chlorine taste and odor.

• Reduces dirt, rust, asbestos ﬁbers, and other particulates including oxidized iron, manganese, and sulﬁdes.

• Reduces parasitic protozoan cysts such as Giardia, Entamoeba, and Cryptosporidium.

• Reduces common earthy, moldy, ﬁshy tastes and odors

• Inhibits limescale build-up in ice machines – As tested by Everpure.

• MH2 cartridges are treated with bacteriostat to effectively reduce the growth of bacteria on the ﬁlter media. Not Performance Tested or Certiﬁed by NSF.

HEALTH CLAIM PERFORMANCE CERTIFIED BY NSF/ANSI*

This system has been tested according to NSF/ANSI 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as speciﬁed in NSF/ANSI 42 and 53.

Substance

Standard 42—Aesthetic Effects

Chlorine 2.0 mg/L ± 10% ≥ 50% 87.8%

Particulate, Class I particles 0.5 to <1 µm

Standard 53—Health Effects

Turbidity

Asbestos

Cyst Minimum 50,000/L 99.95% 99.99% 99.99%

Inﬂuent Challenge

Concentration

at least 10,000

particles/mL

11 ± 1 NTU 0.5 NTU 95.4% 97.2%

107 to 108 ﬁbers/L > 10

micrometers in length

Max. Permissable Product

Water Concentration

Reduction

Requirements

≥ 85% 99.2%

Minimum Reduction

99% 99.87% 99.87%

Average

Reduction

* Tested using ﬂow rate = 1.67 gpm; pressure = 60 psig; pH = 7.5 ± 1;

temp. = 20° ± 3°C

† NTU = Nephelometric Turbidity Units

GENERAL INSTALLATION/OPERATION/MAINTENANCE REQUIREMENTS

• Install vertically with cartridge hanging down

• Use minimum length of tubing possible

• Flush to drain for 5 minutes at full ﬂow

• Replace cartridges when capacity is reached or when ﬂow becomes too slow, but at least annually.

OPERATING SPECIFICATIONS

• Pressure requirement: 10-125 psi (0.7-8.6 bar), non-shock

• Temperature: 35-100° F (2-38° C)

NSF Listed Systems Max. Flow Rate Capacity Space Requirements*

* Includes 21⁄2” clearance under unit for cartridge change

SPECIAL NOTICES

• Installation instructions, parts and service availability, and

• This drinking water system must be maintained according to

• Do not use with water that is microbiologically unsafe, or of

• The contaminants or other substances removed or reduced by

• Check for compliance with state and local laws and regulations.

• Tested under standard laboratory conditions as speciﬁed above.

• To determine NSF Model Name, combine HEAD NAME +

DATA SHEET

QC7I Single - MH 1.67 gpm (6.3 lpm) 9,000 gal (34,050 L) 29" H x 51⁄2" W x 5" D QC7I Single - MH QC7I Twin - MH 3.3 gpm (12.6 lpm) 18,000 gal (68,100 L) 25" H x 11" W x 5" D QC7I Twin - MH QC7I Triple - MH 5.0 gpm (18.9 lpm) 27,000 gal (102,150 L) 25" H x 15" W x 5" D QC7I Triple - MH QC7I Quad - MH 6.6 gpm (25.3 lpm) 36,000 gal (136,200 L) 29" H x 24" W x 5" D QC7I Quad - MH

1.67 gpm (6.3 lpm) 9,000 gal (34,050 L) 29" H x 51⁄2" W x 5" D

3.3 gpm (12.6 lpm) 18,000 gal (68,100 L) 25" H x 11" W x 5" D

5.0 gpm (18.9 lpm) 27,000 gal (102,150 L) 25" H x 15" W x 5" D

6.6 gpm (25.3 lpm) 36,000 gal (136,200 L) 29" H x 24" W x 5" D

standard warranty are included with the product when shipped.

manufacturer’s instructions, including replacement of ﬁlter cartridges.

unknown quality without adequate disinfection before or after the system. Systems certiﬁed for cyst reduction may be used on disinfected waters that may contain ﬁlterable cysts.

this water treatment system are not necessarily in your water.

Actual performance may vary depending on inﬂuent water conditions.

CARTRIDGE NAME. Refer to www.nsf.org to verify certiﬁcation.

System Tested and Certiﬁed by NSF International against NSF/ANSI Standards 42 and 53 for the reduction of:

Standard No. 42 — Aesthetic Effects

Chemical Reduction

Taste and Odor Chlorine

Mechanical Filtration

Particulate Class I: 99.2% reduction of particles one-half micron and larger in size

Standard No. 53 — Health Effects

Mechanical Filtration

Turbidity Cyst Asbestos

Buyer Seller Date