Pentair PG2000 User Manual 2

PG2000

®

Owner's Manual

Specifications:

Electrical: 120 VAC 60 Hz
Operating load: 2 amps
Material: High Strength Plastic
Weight: 20 lbs.
Lamp: 150 Watt Metal-Halide
Lamp Life: 6000 hours
Restrike time: 2-3 minutes

Pentair Water Pool and Spa, Inc.

1620 Hawkins Ave., Sanford, NC 27330 • [phone]
10951 West Los Angeles Ave., Moorpark, CA 93021 • [phone]

Visit us on the Internet at: www.pentairpool.com or www.staritepool.com

Rev. C 7-29-05 1 P/N 840263

IMPORTANT SAFETY INSTRUCTIONS

COLOR

POWER

RF2000 WIRELESS CONTROL

COLOR

POWER

REMOTE SWITCH CONTROL

COLOR

ON

POWER

ON

MANUAL CONTROL

TOGGLE SWITCH POSITIONS

COLOR

OFF

POWER

OFF

READ AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING SYSTEM

Operating the PG2000

Refer to the toggle switch position diagram below for the appropriate switch positions for your particular installation.
The switches are located on the lower right side of the unit. The PG2000 should always operate in manual mode no matter
what type of control system is installed.

NOTE

When cycling system off, then back on, it may take up to 3-4 minutes before the lamp "restrikes" or comes
back on. The lamp must cool down before restriking. All metal halide lamps have this characteristic and this is
a normal function of the PG2000.

CAUTION

PG2000 Illuminator must have good ventilation to operate properly.
Blockage of air flow or air intake will shorten the bulb life and could
damage the unit. Make sure foliage; grass, groundcover, yard debris, etc.
is kept clear of intake vents on back of the unit in order to allow for proper
air flow. Do not install PG2000 Illuminator in an underground utility box or
similar appliance. Damage to the unit due to blocked air vents or poor
ventilation will void the warranty.

Replacing the Bulb.

1. Turn power to unit off.

WARNING

Turn off power before changing bulb. Failure to turn off power
may lead to severe electrical shock, which can result in death
or severe injury.

2. Remove two screws securing outer body and lift outer body
straight up.

WARNING

Bulb socket, and reflector are extremely hot during and following operation.
Allow sufficient time for cooling before touching them, or you may suffer
severe burns.

3. Remove screws (3) at bottom of socket bracket, (see Figure 1.)
and separate socket bracket assembly from reflector.

Remove bulb from socket and insert new bulb. Be sure not to
touch the glass of the bulb.

CAUTION

Remove
Screws

Intake
Vents

Do not touch the bulb with your bare fingers - fingerprints can actually cause
the bulb to overheat and crack. Handle the bulb using sheath provided in
packaging.

4. Reassemble socket bracket and make sure bulb is centered in
reflector.

5. Replace outer body and secure with two screws.

P/N 840263 2 Rev. C 7-29-05

Figure 1.