Pella 206C0000 User Manual

Certification Exhibit

FCC ID: SO7-206C0000

IC: 11009A-206C0000

FCC Rule Part: 15.231

IC Radio Standards Specification: RSS-210

ACS Project Number: 13-0411

Manufacturer: Pella Corporation

Model: 206C0000

Manual

5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: [phone]

Insynctive

™

ROLLER SHADE
Installation Instructions

INSYNCTIVE™PRODUCTS NEEDED

ROLLER SHADE (included): ROLLER SHADE can be automatically raised and lowered to improve the

comfort and convenience of your home.

REMOTE (required — sold separately): REMOTE is used to operate ROLLER SHADE, automatically
sending it up or down. One REMOTE can operate a single ROLLER SHADE or multiple ROLLER SHADES.
REMOTE is also used to teach up to three custom setpoints to ROLLER SHADE.

BRIDGE (optional — sold separately): The main control unit for this system, BRIDGE provides the
communication link to/from ROLLER SHADE or your gateway home automation system. If using a home
automation system with Z-Wave, BRIDGE must be located in the same room and not more than 50 feet
away from the Z-Wave gateway.

TOOLS REQUIRED

Measuring Tape
Drill with 3/32” Bit and 1/4” Nut Driver
Pencil
#2 Phillips Head Screwdriver
Flat Head Screwdriver
Level

INSTALLATION AND SETUP INSTRUCTIONS

1. Get Started

 Verify package contents match the packing slip

 If you have not done so, open REMOTE package and install battery

 Verify there are no obstructions in the path the shade will travel such as latches, locks, window

crank, handles, sensors, window mullions, etc.

2. Determine Your Bracket and Roll Direction

 Determine whether you will use and Inside or Outside mount and whether the roll direction will

be Standard or Reverse.