Pelco CV-D2000 User Manual

Release Notes

IPIX IP Cameras Supported on Digital Sentry

Integral Digital Sentry® digital video management systems (DVMS) support certain IPIX® IP camera models. The camera models listed in this document can be used with Digital Sentry IP camera driver 6.8.0.126 and later. Refer to each camera’s table for information about the hardware and software features validated for use on a Digital Sentry system. Any general limitations or special instructions are listed at the beginning of the document, and any model-specific information is listed after each table. For information about the general usage of each camera, refer to the camera manufacturer’s documentation.

To obtain the latest IP camera driver or documentation for use with Digital Sentry, refer to the Pelco Web site at

IPIX CommandView™ Dome CV-D2000

www.pelco.com

Firmware N/A

Supported Resolutions 1600 x 1200

Frames per Second (FPS) 1 to 20

Number of Quality Settings 10

Supported Codec MJPEG

Supported Motion Detection In-Camera

Pan/Tilt/Zoom (PTZ) Yes (solid state)

IPIX CommandView Dome CV-D3000

Firmware N/A

Supported Resolutions 2048 x 1536

FPS 1 to 12

Number of Quality Settings 10

Supported Codec MJPEG

Supported Motion Detection In-Camera

PTZ Yes (solid state)

C1006RN (1/09) Page 1 of 2

IPIX InSight™ IS-N2000

Firmware N/A

Supported Resolutions 1600 x 1200

FPS 1 to 17

Number of Quality Settings 10

Supported Codec MJPEG

Supported Motion Detection In-Camera

PTZ Not available

Contact Information

Pelco Worldwide Headquarters 3500 Pelco Way, Clovis, California 93612 USA

USA & Canada: Tel: (800) 289-9100, Fax: (800) 289-9150 International: Tel: +1(559) 292-1981, Fax: +1(559) 348-1120 www.pelco.com

Document Revision History

Document # Date Comments

C1006RN 1/09 Original version.

Pelco, the Pelco logo, and Digital Sentry are registered trademarks of Pelco, Inc.

CommandView and InSight are trademarks of IPIX Corporation.

Page 2 of 2 C1006RN (1/09)

IPIX is a registered trademark of IPIX Corporation.