Pelco CST100 User Manual 2

®

INSTALLATION/OPERATION

CST150/CST100
Camera Setup Tool

C2912M-A (2/05)

Regulatory Notices

The CST150 and CST100 compact field service tools enhance the ease of install of our new Pelco
cameras. Both tools incorporate three menu buttons for accessing the setup menus on 5100 Series
cameras. Both tools also access video through a 2.5 mm service connector on Pelco’s 5100, 3610,
3710, and 3770 Series cameras and the ICS090 Series Camclosure

Radio and Television Interference

This equipment has been tested and found to comply with the limits of a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.

Changes and Modifications not expressly approved by the manufacturer or registrant of this
equipment can void your authority to operate this equipment under Federal Communications
Commission’s rules.

In order to maintain compliance with FCC regulations shielded cables must be used with this
equipment. Operation with non-approved equipment or unshielded cables is likely to result in
interference to radio and television reception.

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.

®

integrated camera system.

2 C2912M-A (2/05)

Description

The CST150 and CST100 compact field service tools enhance the ease of installing our new Pelco
cameras. Both tools incorporate three menu buttons for accessing the setup menus on 5100 Series
cameras. Both tools also access video through a 2.5 mm service connector on Pelco’s 5100, 3610,
3710, and 3770 Series cameras and the ICS090 Series Camclosure

®

integrated camera system.

CST100

BUTTONS

BNC

SERVICE
PLUG

BUTTONS

VIEWFINDER

Figure 1.

CST150

ADJUSTER

CST100 and CST150

Models

CST150 Camera setup tool with 800 x 225 pixel TFT microdisplay
CST100 Camera setup tool with composite video output

Parts List

Qty Description

1 CST150 or CST100 camera setup tool
1 Lanyard (attached) (CST150 only)
1 Adapter cable (CST150 only)
4 AA batteries (CST150 only)

SERVICE
PLUG

BATTERY
COMPARTMENT

LANYARD

C2912M-A (2/05) 3

Setup

SELECTING VIDEO FORMAT (CST150)

A switch for selecting the video format for the microdisplay on the CST150 is located in the battery
compartment.

To select the video format:

1. Remove the battery compartment cover. You may have to use a small screwdriver.

2. Remove the batteries.

3. Use a pen or small screwdriver to move the switch to either NTSC or PAL.

4. Reinstall the batteries. Make sure you orient the batteries according to the + and – symbols in
the compartment for each battery.

5. Reinstall the battery compartment cover.

Figure 2.

4 C2912M-A (2/05)

Video Format Switch