Pelco Calipsa Integration Guide — Uniview user-guide

Calipsa® Uniview Integration

User Guide

Document number:C6744M

Publication date:03/23

C6744M | 03/23 1

Calipsa® Uniview Integration User Guide

Table of Contents

Introduction 3

Uniview 3

Adding a Uniview Camera to Calipsa 3

Creating a Site 3
Adding a Camera 3
Configuring the Device 4
Editing Camera DNS Settings 6
Editing Camera Email Settings 7
Seting up Smart Event Alerting 8

Troubleshooting Questions 9

Adding your Monitoring Station SMTP Details 12

Accessing Calipsa Account Settings 12
Editing Global Configuration 12
Inputting Your Credentials 13

C6744M | 03/23 2

Calipsa® Uniview Integration User Guide

Introduction

This guide covers the steps required to integrate your Uniview cameras with the Calipsa platform. Other
common integration steps, such as configuring your system to send alarms to your gmail account are
also covered.

Uniview

Adding a Uniview Camera to Calipsa

This guide outlines the manual process of configuring aUniview camerato send email alerts to Calipsa
when not connected to a Uniview NVR.

Creating a Site

1. Under Add sites, enter the Site Name.

2. When asked is this a DVR/NVR site, select No.

3. Click Add site.

Adding a Camera

1. Once the site has been created, click add camera in the left-hand tree.

C6744M | 03/23 3

Calipsa® Uniview Integration User Guide

2. Under Camera name, enter the camera's name.

3. Under Notification email,enter theemail address where you would like these alarms to be sent

to e.g., Immix S-number, Gmail address, etc.

4. Click Add camera.

Configuring the Device

1. Under Configuration, click Edit.

C6744M | 03/23 4

Calipsa® Uniview Integration User Guide

2. Under Configure, click on the blue icon to the right of Configuration email. The email address is
now copied to your clipboard.

C6744M | 03/23 5