
WARNING
ENG - Before installing make sure the supporting surface will support the combined load of the equipment and
hardware. Screws must be tightly secured. Do not overtighten screws or damage can occur and product may fail.
Never exceed the Maximum Load Capacity. Always use an assistant or mechanical lifting equipment to safely
lift and position equipment. Be careful not to pinch fi ngers when operating the mount. For support please call
customer care at 1-800-865-2112.
ADVERTENCIA
ESP - Antes de instalarlo, asegúrese de que la superfi cie de apoyo sostendrá la carga combinada del equipo y
los fi jadores. Los tornillos se tienen que fi jar fi rmemente. No apriete los tornillos en exceso, ya que se pueden
dañar y el producto podría fallar. Nunca exceda la Capacidad Máxima de Carga. Siempre cuente con la ayuda
de un asistente o utilice un equipo mecánico de izar para levantar y colocar el equipo con más seguridad. Tenga
cuidado de no pincharse los dedos cuando extienda y recoja el soporte contra la pared. Si necesita ayuda, por
favor, llame a Servicio al Cliente de Peerless al 1-800-865-2112.
ADVERTISSEMENT
FRN - Avant de procéder à l’installation, assurez-vous que la surface de support peut soutenir la charge totale de
l’équipement ainsi que des pièces de fi xation. Les vis doivent être serrées au maximum. Ne serrez pas trop les
vis pour éviter tout risque d’endommager le produit et de causer sa défaillance. Ne dépassez jamais la capacité
de charge maximale. Pour lever et positionner l’équipement en toute sécurité, faites-vous toujours aider par une
autre personne ou utilisez un dispositif de levage mécanique. Prenez garde à ne pas vous pincer les doigts en
dépliant le support et en le repliant contre le mur. Pour toute assistance, veuillez contacter le service à la clientèle
au 1-800-865-2112.
ENG
Symbols
ESP
FRN
ENG
ESP
FRN
Símbolos
Symboles
R
Back
Parte trasera
Arrière
ENG
WARNING
ESP
ADVERTENCIA
FRN
ADVERTISSEMENT
To properly tighten screws: Tighten until screw
ENG
head makes contact, then tighten another 1/2
turn. Do not overtighten screws.
ESP
Apriete adecuado de los tornillos: Apriete hasta
que la cabeza del tornillo haga contacto y luego
apriete otra 1/2 vuelta. No apriete de más los
tornillos.
Pour bien serrer les vis : Serrez jusqu’à ce que
FRN
la tête de la vis entre en contact, puis serrez
encore d’un 1/2 tour. Ne serrez pas trop les vis.
1
ENG
Do not overtighten screws.
ESP
No apriete de más los tornillos.
FRN
Ne pas trop serrer les vis.
ENG
Tools Needed for Assembly.
ESP
Herramientas necesarias para el ensamblaje.
FRN
Outils nécessaires au montage.
2
3
+1/2
4
2
2017-02-20 #:220-9014-2 (2017-04-19)

ENG
Parts (Before beginning, make sure you have all parts shown below).
ESP
Piezas (antes de iniciar, asegúrese de tener todas las piezas siguientes).
FRN
Pièces (avant de commencer, assurez-vous d’avoir toutes les pièces illustrées ci-dessous).
Parts List
A overlay 1 180-T1452 180-T1453 180-T1498 180-T1455
B corner bracket 4 180-T1428 180-T1428 180-T1428 180-T1428
C M4 x 10mm self-tapping screw 8 510-D1060 520-D1060 520-D1060 520-D1060
D M6 x 16mm thumb screw 4 560-1397 560-1397 560-1397 560-1397
E 4mm T-wrench 1 560-1718 560-1718 560-1718 560-1718
F 4mm driver bit 1 560-1133 560-1133 560-1133 560-1133
G USB extension cable (not shown) 1 600-0435 600-0435 600-0435 600-0435
PCTO49-100
Part #
PCTO49-100P
Part #
PCTO55-100
Part #
PCTO55-100P
Part #Description Qty
B (4)A (1)
corner bracketoverlay
C (8)
M4 x 10mm
D (4) E (1)
M6 x 16mm
thumb screw
4mm T-wrench
F (1)
4mm driver bit
3
2017-02-20 #:220-9014-2 (2017-04-19)

1
ENG
Cleaning Instructions
It is recommended that both sides of the overlay and the surface of the display be cleaned prior to installation.
Cleaning the Xtreme™ Outdoor Display
1. Do not rub or strike the display with anything hard as this may scratch, mar, or even damage the
screen permanently.
2. Never use ammonia or any product containing ammonia as it will damage the anti-glare coating on
the face of the glass.
3. Only use Isopropyl alcohol to clean the display face.
4. Unplug the power cord before cleaning the display.
Cleaning the Xtreme™ Outdoor PCAP Touch Overlay
1. Do not rub or strike the overlay with anything hard as this may scratch, mar, or even damage the
glass or touch foil permanently.
2. Never use ammonia or any product containing ammonia for cleaning the overlay glass or touch foil
side, as it will damage the anti-glare coating on the face of the glass and the touch foil on the inside
portion of the glass.
3. Only use Isopropyl alcohol to clean the front side of the glass overlay face.
4. Only use a solution of 10% quality dishwashing detergent in distilled water to clean the touch foil
side of the glass.
5. Unplug the overlay USB cord prior to cleaning the overlay.
6. Take extra care when cleaning the inner touch foil side of the overlay. Do not use excessive force
when cleaning the touch foil. Always us a soft lint free cloth and clean from the center of the foil out
to the edges of the interactive sensor.
7. Do not install the touch overlay until the Xtreme Outdoor Display glass and both sides of the
overlay glass have been cleaned.
If the touch overlay requires additional cleaning after installation, unplug the USB cord before
cleaning the overlay. Dust the exterior of the overlay by wiping the screen and the cabinet with a
soft, clean cloth and if the screen requires additional cleaning, use a clean, damp cloth. Do not
use liquid cleaners, aerosol cleaners, or solvents of any kind.
4
2017-02-20 #:220-9014-2 (2017-04-19)

LIMITED TWO-YEAR WARRANTY
TWO-YEAR PARTS & LABOR LIMITED WARRANTY
Terms of Peerless-AV®
The Peerless-AV PCAP touch overlay is warrantied to be free of
defects in material and workmanship from the time of purchase
by the original owner. If this product is found and proved to
be defective under the terms and conditions of this warranty,
Peerless-AV will repair or replace defective parts with new and/
or reconditioned parts at no charge for the parts and labor to the
original owner, subject to the terms and conditions of this Limited
Warranty. This Limited Warranty covers failures due to defects in
material and workmanship that occur during normal residential or
commercial use as follows:
• Parts – the warranty period for parts is: two (2) years from
the date of original purchase. During the applicable Limited
Warranty period for parts, defective parts will be replaced at
no charge. Parts used for the replacement will be warranted
for the remainder of the original warranty period for those
parts.
• Labor – the warranty period for labor is: two (2) years from
the date of original purchase. During the applicable Limited
Warranty period for labor, Peerless-AV will provide the labor
for warranty repair at no charge for a period of two (2) years
from the date of original purchase.
• Original owner must provide verifi cation of the date of
purchase when requesting Limited Warranty Services.
A copy of the original Dated Sales Receipt is required
together with the product to obtain service under this Limited
Warranty.
• All repairs must be performed by a Peerless-AV Authorized
Service Provider.
• Customer is responsible for returning (including any
freight and shipping costs) defective unit to a Peerless-AV
Authorized Service Provider. If the product is found to have
no defects, the customer will be responsible for return
shipping costs as well.
THIS LIMITED WARRANTY DOES NOT COVER:
• Labor to uninstall and reinstall the PCAP touch overlay
• Shipping damage.
• Damage caused during customer unpacking, and/or removal
of packing materials.
• Damage due to power surges or lightning strikes.
• Damages which results from fi re, fl ood, lightning, tornado,
hurricane, large hail, extremely gusty winds, sand storms,
vandalism, terrorism or other acts of nature.
• Any unit which has been modifi ed or damaged due to
improper installation or failure to obey the operating
instructions in the User Manual.
• Any failure, loss, damage or personal injury due to accident,
neglect, misuse, abuse, improper orientation, improper
maintenance, improper storage, alteration to the unit, or
failure by the consumer to follow operating instructions
provided by the user manual.
• Any owner other than the original owner.
• Any unit purchased from an unauthorized seller.
• If the original product serial number has been removed,
defaced or tampered with in any way.
• Any packaging or transportation charges incurred in
connection with warranty services.
• Indirect, consequential, or special damages except as
required by federal or state laws.
• Any unit tampered with, modifi ed, adjusted or repaired by
any party other than the Peerless-AV Authorized Service
Provider.
• Any cosmetic damages to the surface or exterior that has
been defaced or faded, or caused by normal wear and tear
or exposure to chemicals, acid rain, large hail or adverse
weather conditions.
• Any damage, scratches or blemishes to the face of the
overlay glass, touch foil on the interior and/or exterior cabinet
due to end-user cleaning.
• Return shipping when no defect is found.
Peerless-AV and its representatives or agents shall in no event be
liable for any general, indirect or consequential damages arising out
of/or caused by the use of /or the inability to use this product.
This warranty is made in lieu of all other warranties, expressed or
implied, and all other liabilities on the part of Peerless-AV. Any other
warranties, including the warranties of merchantability and fi tness
for a particular purpose are hereby disclaimed by Peerless-AV and
its representatives and/or agents.
All warranty inspections and repairs must be performed by PeerlessAV or its authorized service representations.
Customer Care: 800.865.2112 or 630.375.5100
Website: www.peerless-av.com
© 2017 Peerless Industries, Inc. All rights reserved.
Peerless-AV
2300 White Oak Circle
Aurora, IL 60502
Email: tech@peerlessmounts.com
Ph: (800) 865-2112
Fax: (800) 359-6500
www.peerless-av.com
© 2017, Peerless Industries, Inc.
Peerless-AV Europe
Unit 3 Watford Interchange,
Colonial Way, Watford, Herts,
WD24 4WP, United Kingdom
Customer Care
44 (0) 1923 200 100
www.peerless-av.com
© 2017, Peerless Industries, Inc.
Peerless-AV de Mexico
Ave de las Industrias 413
Parque Industrial Escobedo
Escobedo N.L Mexico 66050
Servicio al Cliente
(81) 8384-8300
www.peerless-av.com
© 2017, Peerless Industries, Inc.