Paxar Monarch 9462TM, Monarch 9462 Operating Instructions Manual

TC9462OI Rev. AG 12/07 ©2001 Paxar Americas, Inc. a subsidiary of Avery Dennison Corp.
All rights reserved.

OPERATING
INSTRUCTIONS

The Monarch® 9462™ Single-Station Battery Charger
charges one 7.4V lithium-ion battery at a time for the
following printers:

♦ Sierra Sport2™ 9460™

♦ Sierra Sport3™ 9433™

♦ Monarch® Pathfinder® Ultra® Silver 6032™

♦ Monarch® Pathfinder® Ultra® Gold 6037™

♦ Monarch® Pathfinder® Ultra® Platinum 6039™

Note: You must charge a battery before using it.

WARNINGS

♦ Use only a Paxar-qualified battery. The battery could

be damaged or explode if placed on a different
charger.

♦ Do not charge non-rechargeable batteries in this

charger.

♦ Do not throw the battery in the trash. Dispose

according to your local regulations.

2 Operating Instructions

♦ Do not disassemble, short-circuit, heat above 80°C, or

incinerate the battery. It may explode.

♦ Follow the operating and storage limit specifications

listed at the end of these instructions. Otherwise, the
battery may permanently lose its charge capacity.

Setting Up the Equipment

To set up the equipment:

1. Plug one end of the power supply into a wall
electrical outlet.

2. Plug the other end of the power supply into the back
of the charger.

The Power LED is lit when the charger is set up and
plugged in.