Paxar 9462TM User Manual

OPERATING
INSTRUCTIONS

The Monarch® 9462™ Single-Station Battery Charger
charges one 7.4V lithium-ion battery at a time for the
following printers:

♦ Sierra Sport2™ 9460™

♦ Sierra Sport3™ 9433™

♦ Monarch® Pathfinder® Ultra® Silver 6032™

♦ Monarch® Pathfinder® Ultra® Gold 6037™

♦ Monarch® Pathfinder® Ultra® Platinum 6039™

Note: You must charge a battery before using it.

WARNINGS

♦ Use only a Paxar-qualified battery.The battery could

be damaged or explode if placed on a different
charger.

♦ Do not charge non-rechargeable batteries in this

charger.

♦ Do not throw the battery in the trash. Dispose

according to your local regulations.

TC9462OI Rev. AE 4/06 ©2001 Paxar Americas, Inc. All rights reserved.

♦ Do not disassemble, short-circuit, heat above 80°C, or

incinerate the battery. It may explode.

♦ Follow the operating and storage limit specifications

listed at the end of these instructions. Otherwise, the
battery may permanently lose its charge capacity.

Setting Up the Equipment

To set up the equipment:

1. Plug one end of the power supply into a wall
electrical outlet.

2. Plug the other end of the power supply into the back
of the charger.

The Power LED is lit when the charger is set up and
plugged in.

2 Operating Instructions

Charging the Battery

To charge the battery, insert the battery into the charger,
with the ribbed end sticking out. Charging time can take
up to three hours. It takes approximately 1 hour to reach
the 80% level (where it is now usable). To reach 100%, it
takes approximately 2 hours more.

Reading the Display

♦ Power LED – on (solid). Charger is plugged in.

♦ Charging LED – flashes when you insert the battery;

on (solid) during charging; off when charging is
complete.

♦ Complete LED – flashes when the battery is 80%

charged; on (solid) when the battery is 100% charged.

Operating Instructions 3

Troubleshooting

When an error occurs, the Charging and Complete LEDs
blink together. In this case, repeat the charging process.
If the error still occurs, repeat the process with a new
battery. If there is a still a problem after the second
repeat charge, call Paxar Service.

In between charges, remove the battery, wait for the
lights to stop flashing, then re-insert the battery.

Specifications

Operating Limits:

Temperature

Humidity

Storage Limits:

Temperature

Humidity

32°F to 104°F (0°C to 40°C)

5% to 90% non-condensing

-40°F to 158°F (-40°C to 70°C)

5% to 90% non-condensing

Charger

Length:

Width:

Height:

Input:

Shipping Weight:

3” (76.2 mm)

3.25” (82.55 mm)

3” (76.2 mm)

12 to 16 VDC/14W

1.16 lbs. (.53 kg)

Power Supply

Input:

Output:

Visit www.paxar.com for sales, service, supplies,
information, and telephone numbers for our locations
throughout the world.

Toll Free:

1-800-543-6650 (In the U.S.A.)
1-800-363-7525 (In Canada)

Universal switching power supply, 85 to
264 VAC, 50/60 Hz.

12 VDC/18W max

4 Operating Instructions