Paxar 9462, 9465 User Manual

QUICK REFERENCE

This Quick Reference contains supply loading information and general care and maintenance procedures for the Monarch® Pathfinder® Ultra® Platinum 6039™ printer. For more detailed information, refer to the Operator’s Handbook available on our Web site (www.paxar.com).

Information in this document supercedes information in previous versions. Check our Web site for the latest documentation and release information.

Getting Started

1. Review the printer safety information in the Regulatory Compliance document provided with your printer.

2. Charge the main battery. Use either the Monarch® 9462™ or 9465™ battery charger. Refer to the documentation with those chargers for more information.

Important: You must charge the main battery when you receive the printer,

even if you do not use it right away. Refer to the Operator’s Handbook for important battery safety information.

3. Insert the main battery into the printer.

4. Attach the safety strap found in the documentation package.

5. Load supplies in the printer.

6. Turn on the printer and wait 30 seconds for the desktop to load.

Your System Administrator must have already loaded an application in the printer before you can use it.

Monarch®, Pathfinder® Ultra®, 6039, 9462, and 9465 are trademarks of Paxar Americas, Inc. Paxar® is a trademark of Paxar Corporation. Avery Dennison® is a trademark of Avery Dennison Corporation.

Attaching the Safety Strap

1. Turn the printer upside down, resting its top in the table.

2. Remove the stylus strap from the loop.

3. Take the thin end of the safety strap, and push it through the loop at the

bottom of the printer handle (near the battery compartment).

4. Push the thick end of the safety strap through the thin end’s loop.

5. Pull the strap. It may be necessary to help the thin end’s loop fit over the

plastic piece in the middle of the strap. Pull the strap tight.

6. Attach the stylus strap to the loop as shown.

Changing the Main Battery

Always take the main battery out of the printer when storing the printer and connect the Battery Backup Power.

1. Turn the printer over and press the button on the battery compartment door (at the bottom of the printer’s handle) and slide it open.

Battery Compartment

2. Turn the printer upright, holding your palm beneath the open battery

compartment. Hit the printer on your hand and catch the battery as it slides out.

Main Battery

3. Insert a new battery into the compartment (connector end first).

4. Slide the compartment door shut until it clicks into place.

Charging the Backup Battery

The internal backup battery is a 3.6-volt lithium-ion battery that maintains the printer’s system settings. The backup battery maintains its charge through the main battery or the Battery Backup Power. When fully charged, the backup battery provides seven days of power. To keep the battery fully charged, connect the Backup Battery Power whenever you remove the main battery.

Note: If the printer does not have a main battery or is

not connected to the Battery Backup Power, it loses its charge and the printer’s system settings.

5. Remove the main battery from the battery compartment.

6. Connect the Battery Backup Power as shown.

Loading Supplies

1. Turn on the printer.

2. Press the latch buttons and open the supply cover.

Supply Cover

Latch Buttons

3. Pull back the supply lock tab.

4. Open the spring-loaded supply holder. Spread the supply holder tabs apart

with one hand so it adjusts to the size of your supply roll. You can set it at

1.2”, 1.5”, and 2.0”.

Supply Holder

5. Press the supply lock tab down to lock the supply holder in place.

+ 8 hidden pages