Patton electronic 13243D4-001 User Manual

SmartNode™ 4660 & 4670 Series

Multiport BRI/FXS/FXO VoIP
Gateway Router, IAD

Quick Start Guide

This is a Class B device and is intended for use in a light industrial (commercial) or residential environment.
It is not intended for use in a heavy industrial environment.

REGULATORY MODEL NUMBER: 13243D4-001

Part Number: 07MSN4660-QS, Rev. A
Revised: June 5, 2012

Sales Office: [phone]

Technical Support: [phone]

E-mail: [e-mail]

www.patton.com

WARNING

• Do not open the device when the power cord is connected. For systems without a power
switch and without an external power adapter, line voltages are present within the
device when the power cord is connected.

Ne pas ouvrir l'appareil lorsque le cordon d'alimentation est connecté. Pour les
systèmes sans un commutateur de puissance et sans un adaptateur d'alimentation
externe, des tensions de ligne sont présents au sein de l'appareil lorsque le cordon d'ali­mentation est connecté.

• For devices with an external power adapter, the power adapter shall be a listed Limited
Power Source The mains outlet that is utilized to power the device shall be within 10

feet (3 meters) of the device, shall be easily accessible, and protected by a circuit
breaker in compliance with local regulatory requirements.

Pour les appareils avec un adaptateur d'alimentation externe, l'adaptateur d'alimenta­tion doit être une source d'alimentation limitée cotée. La prise de courant qui est utilisé
pour alimenter le dispositif doit être à 10 pieds (3 mètres) de l'appareil, doit être facile­ment accessible, et protégé par un disjoncteur en conformité avec les exigences régle­mentaires locales.

• For AC powered devices, ensure that the power cable used meets all applicable stan­dards for the country in which it is to be installed.

Pour les appareils alimentés par AC, veiller à ce que le câble d'alimentation utilisé
respecte toutes les normes applicables pour le pays dans lequel il doit être installé.

• For AC powered devices which have 3 conductor power plugs (L1, L2 & GND or Hot,
Neutral & Safety/Protective Ground), the wall outlet (or socket) must have an earth
ground.

Pour les appareils alimentés en ca qui ont 3 prises de courant des conducteurs (L1, L2 et
GND ou à chaud, neutre et de la sécurité / de protection au sol), la prise murale (ou
socket) doit avoir une prise de terre.

• For DC powered devices, ensure that the interconnecting cables are rated for proper
voltage, current, anticipated temperature, flammability, and mechanical serviceability.

Pour les appareils alimentés par courant continu, veiller à ce que les câbles d'intercon­nexion sont conçus pour la tension appropriée, courant, température prévue, l'inflamma­bilité et d'entretien mécanique.

• WAN, LAN & PSTN ports (connections) may have hazardous voltages present regardless
of whether the device is powered ON or OFF. PSTN relates to interfaces such as tele­phone lines, FXS, FXO, DSL, xDSL, T1, E1, ISDN, Voice, etc. These are known as “haz­ardous network voltages” and to avoid electric shock use caution when working near
these ports. When disconnecting cables for these ports, detach the far end connection
first.

Ports WAN, LAN et PSTN (connexions) peuvent avoir des tensions dangereuses
présenter indépendamment du fait que l'appareil est allumé ou éteint. PSTN concerne
des interfaces telles que les lignes téléphoniques, FXS, FXO, DSL, xDSL, T1, E1, ISDN,
Voix, etc Ils sont connus comme "tensions dangereuses du réseau" et d'éviter un choc
électrique preuve de prudence lorsque l'on travaille à proximité de ces ports. Lors de la
déconnexion des câbles pour ces ports, détacher la connexion bout en premier.

• Do not work on the device or connect or disconnect cables during periods of lightning
activity

Ne pas travailler sur l'appareil ou de connecter ou déconnecter les câbles pendant les
périodes d'activité de foudre.

2 SmartNode 4660 & 4670 Quick Start Guide

WARNING

CAUTION

This device contains no user serviceable parts. This device can only be
repaired by qualified service personnel.

Cet appareil contient des pièces n'est réparable par l'utilisateur. Ce dis­positif ne peut être réparé par du personnel qualifié.

In accordance with the requirements of council directive 2002/96/EC on Waste of
Electrical and Electronic Equipment (WEEE), ensure that at end-of-life you separate
this product from other waste and scrap and deliver to the WEEE collection system in
your country for recycling.

Electrostatic Discharge (ESD) can damage equipment and impair electrical
circuitry. It occurs when electronic printed circuit cards are improperly
handled and can result in complete or intermittent failures. Do the follow­ing to prevent ESD:

• Always follow ESD prevention procedures when removing and replac­ing cards.

• Wear an ESD-preventive wrist strap, ensuring that it makes good
skin contact. Connect the clip to an unpainted surface of the chassis
frame to safely channel unwanted ESD voltages to ground.

• To properly guard against ESD damage and shocks, the wrist strap
and cord must operate effectively. If no wrist strap is available,
ground yourself by touching the metal part of the chassis.

1.0 Power up the SmartNode

1. Connect the SmartNode to a power source using the included power supply and cable.

2. When the Power LED stops blinking and remains lit, the SmartNode is ready to configure.

2.0 Configuring your SmartNode

Refer to the SmartNode 4660 & 4670 Series User Manual available online at www.patton.com/manuals/

SN4660-SN4670.pdf for detailed information about:

•

Installing, configuring, operating, and troubleshooting the SmartNode

•

Warranty, trademark & compliance

SmartNode 4660 & 4670 Quick Start Guide 3

A.0 Customer and Technical Support

Toll-Free VoIP support: call sip:[e-mail] with a VoIP SIP client
Online support: www.patton.com
E-mail support: [e-mail]—answered within 1 business day
Telephone support:

•

Standard: [phone] (USA), Monday–Friday: 8:00 am to 5:00 pm EST (1300 to
2200 UTC/GMT)

•

Alternate: [phone] (Switzerland), Monday–Friday: 9:00 am to 5:30 pm CET (08:00 to 16:30
UTC/GMT)

Fax: [phone] (USA) or [phone] (Switzerland)

4 SmartNode 4660 & 4670 Quick Start Guide

B.0 Appendix—Factory default settings

B.1 SmartNode 4660

Username: administrator

Password: (blank)

IP Address (Eth 0/0): DHCP

Network Mask (Eth 0/0): n/a

IP Address (Eth 0/1-0/3): 192.168.1.1 (DHCP Server)

Network Mask (Eth 0/1-0/3): 255.255.255.0

B.2 SmartNode 4670

Username: administrator

Password: (blank)

IP Address (Eth 0/0-0/3): 192.168.1.1 (DHCP Server)

Network Mask (Eth 0/0-0/3): 255.255.255.0

C.0 Compliance Information

C.1 Compliance

EMC Compliance:

•

FCC Part 15, Class B

•

EN55022, Class B

•

EN55024

Low-Voltage Directive (Safety) Compliance:

•

UL60950-1/CSA C22.2 No. 60950-1

•

IEC/EN 60950-1, 2nd edition

•

AS/NZS 60950-1

PSTN Compliance:

•

ACMA AS/ACIF S043.2:2008

•

ACMA AS/ACIF S003:2008

•

TBR3

SmartNode 4660 & 4670 Quick Start Guide 5

C.2 Radio and TV interference

The SmartNode router generates and uses radio frequency energy, and if not installed and used properly—that
is, in strict accordance with the manufacturer’s instructions—may cause interference to radio and television
reception. The SmartNode router have been tested and found to comply with the limits for a Class B computing
device in accordance with specifications in Subpart B of Part 15 of FCC rules, which are designed to provide rea­sonable protection from such interference in a commercial installation. However, there is no guarantee that
interference will not occur in a particular installation. If the SmartNode router does cause interference to radio or
television reception, which can be determined by disconnecting the unit, the user is encouraged to try to correct
the interference by one or more of the following measures: moving the computing equipment away from the
receiver, re-orienting the receiving antenna and/or plugging the receiving equipment into a different AC outlet
(such that the computing equipment and receiver are on different branches).

C.3 CE Declaration of Conformity

Patton Electronics, Inc declares that this device is in compliance with the essential requirements and other rele­vant provisions of Directive 1999/5/EC. The Declaration of Conformity may be obtained from Patton Electron­ics, Inc at www.patton.com/certifications.

The safety advice in the documentation accompanying this device shall be obeyed. The conformity to the above
directive is indicated by CE mark on the device.

C.4 Authorized European Representative

D R M Green
European Compliance Services Limited.
Oakdene House, Oak Road ,
Watchfield, Swindon, Wilts SN6 8TD, UK

6 SmartNode 4660 & 4670 Quick Start Guide

Copyright statement

Copyright © 2012, Patton Electronics Company. All rights reserved.
The information in this document is subject to change without notice. Patton Electronics assumes no

liability for errors that may appear in this document.

Trademarks statement

The term SmartNode is a trademark of Patton Electronics Company. All other trademarks presented in this docu­ment are the property of their respective owners.

Warranty

For warranty information, refer to the SmartNode 4660 & 4670 Series User Manual available online
at www.patton.com/manuals/SN4660-SN4670.pdf.

SmartNode 4660 & 4670 Quick Start Guide 7

NOTES

____________________________________________________________________

____________________________________________________________________

____________________________________________________________________

____________________________________________________________________

____________________________________________________________________

____________________________________________________________________

____________________________________________________________________

____________________________________________________________________

____________________________________________________________________

____________________________________________________________________

____________________________________________________________________

____________________________________________________________________

____________________________________________________________________

____________________________________________________________________

____________________________________________________________________

____________________________________________________________________

8 SmartNode 4660 & 4670 Quick Start Guide