Instruction Sheet
for the PASCO
Model WA-9870
Wave Driver Post (2)
Installation Instructions
Introduction
The WA-9870 Wave Driver Post provides a set of two
posts to be glued to any 5 1/4-inch speakers as indicated in Figure 1.
Equipment required but not included:
- Glue; preferrably RTV (black or clear)
Assembling the Plumb Bob
012-08754A
post
RTV placement
1 . Carefully draw an even bead of RTV around the
internal perimeter of the speaker.
2. Allow the RTV to dry according to manufacturer’s
recommendations before setting the post in place.
Assure that the seal around the post is complete.
speaker
Figure 1. Alignment of Post on Speaker
© 2004 PASCO scientific
®
10101 Foothills Blvd. • P.O. Box 619011 • Roseville, CA 95678-9011 USA
Phone (916) 786-3800 • FAX (916) 786-8905 • web: www.pasco.com
better
ways to
teach science
Loading...