PASCO ME-9469 User Manual

Instruction Sheet for the PASCO Model ME-9469

012-04990B

2/93

$1.00

ADJUSTABLE END STOP

Hook and pile

Neodymium Magnets

Introduction

The PASCO Model ME-9469 Adjustable End Stop is designed for use as an accessory to any PASCO Dynamics Track or Introductory Dynamics System.

When used with the magnetic Collision Cart or the optional magnets in the Dynamics Cart end caps the End Stop functions as an elastic collision bumper. It becomes an inelastic bumper in experiments where the hook and pile tabs on the cart contact those of the End Stop. The End Stop can also be used as a solid bumper for the ME-9430 Dynamics Cart plunger.

Additional Equipment Required:

• Dynamics Cart Track, such as Model ME-9434 or ME-9435

• Dynamics Cart, such as Model ME-9430

Additional Equipment Recommended:

Inelastic Collision

Solid Bumper

Elastic Collision

Setup procedure

➀ Loosen the thumbscrew of the Adjustable End

Stop.

➁ Align the square nut within the groove on the de-

sired side of the Dynamics Cart Track.

NOTE: The flat side of the square nut must face

the outside of the Dynamics Cart Track as shown.

➂ Locate the End Stop over the desired position and

tighten the thumbscrew.

Magnet 2X

(634-022)

• Collision Cart, such as Model ME-9454

CAUTION: The Adjustable End Stop con-

tains two neodymium magnets. Keep this equipment away from any magnetic media.

Thumb screw

(610-181 +

620-067)

End Stop

(648-04982)

Square nut

(614-054)

Limited Warranty

012-04990B

PASCO scientific warrants this product to be free from defects in materials and workmanship for a period of one year from the date of shipment to the customer. PASCO will repair or replace, at its option, any part of the product which is deemed to be defective in material or workmanship. This warranty does not cover damage to the product caused by abuse or improper use. Determination of whether a product failure is the

result of a manufacturing defect or improper use by the customer shall be made solely by PASCO scientific. Responsibility for the return of equipment for warranty repair belongs to the customer. Equipment must be properly packed to prevent damage and shipped postage or freight prepaid. (Damage caused by improper packing of the equipment for return shipment will not be covered by the warranty.) Shipping costs for returning the equipment, after repair, will be paid by PASCO scientific.