PASCO ME-8743 Instruction Manual

®

Swivel Clamp

1. Turn the thumbscrew
counterclockwise to
loosen.

2. Adjust the two halves to
the desired angle.

3. Turn the thumbscrew
clockwise to tighten.

Rod hole

ME-8743

Instruction Manual

012-11085A

*012-11085*

Introduction

The ME-8743 Swivel Clamp is designed to hold
two support rods up to 12.7 mm in diameter. The
clamp can hold the rods at an angle relative to each
other.

See the PASCO catalog or visit the web site at
www.pasco.com for information about support
rods, bases, and other clamps.

Included:

Swivel Clamp (set of 2)

Recommended: Model

120 cm Stainless Steel Rod ME-8741

90 cm Stainless Steel Rod ME-8738

45 cm Stainless Steel Rod ME-8736

Large Rod Base ME-8735

Small “A” Base ME-8976

800-772-8700 www.pasco.com

Operation

The swivel clamp has three thumbscrews. Loosen
or tighten the thumbscrews at either end to adjust
and hold support rods.

• Turn the center thumbscrew counterclockwise
to loosen it.

• Adjust the two halves of the clamp to the
desired angle.

• Turn the center thumbscrew clockwise to
tighten it.

Usage

Use three Swivel Clamps and three rods of equal
length to form an equilateral triangle.

Use two Swivel Clamps to join two shorter rods
into a longer rod.

®

Swivel Clamp Technical Support

Technical Support

For assistance with any PASCO product, contact PASCO at:

Address: PASCO scientific

10101 Foothills Blvd.
Roseville, CA 95747-7100

Phone: [phone] (worldwide)

800-772-8700 (U.S.)

Fax: [phone]

Web: www.pasco.com

Email: [e-mail]

For more information about the Swivel Clamp and the latest revision of this Instruction Manual, visit:

www.pasco.com/go?ME-8743

Limited Warranty For a description of the product warranty, see the PASCO catalog. Copyright The PASCO scientific 012-11085A Swivel Clamp Instruction Manual is copyrighted with all rights reserved. Permission is

granted to non-profit educational institutions for reproduction of any part of this manual, providing the reproductions are used only in their laboratories and classrooms, and are not sold for profit. Reproduction under any other circumstances, without the written con­sent of PASCO scientific, is prohibited. Trademarks PASCO and PASCO scientific are trademarks or registered trademarks of PASCO scientific, in the United States and/or in other countries. All other brands, products, or service names are or may be trademarks or service marks of, and are used to identify, products or services of their respective owners. For more information visit www.pasco.com/legal.

2