PASCO ME-8735 User Manual

Instruction Sheet
for the PASCO
Model ME-8735

leveling feet (2)

012-05338A

12/93
$1.00

Large Rod Stand

clamp screws (2)

Introduction

The PASCO Model ME-8735 Large Rod Stand can be
used whenever a sturdy base for your vertical support
rod is needed.

Rods with an outside diameter of 1/4" to 1/2" (6.5mm
to 13mm) may be placed in either the central mounting
hole and/or the alternate mounting hole at the peak of
the stand. They can be secured to the stand with either
of the two clamp screws provided.

The Large Rod Stand can be leveled by turning the
knobs on the leveling feet.

When using the Large Rod Stand keep the following
in mind:

➀ The mass of the Large Rod Stand is approximately 9

lbs. (4 kg). If dropped, the Large Rod Stand may be
damaged, cause damage to other equipment or cause
injury. To prevent personal injury and damage, al­ways carry the Large Rod Stand with a firm grip and
try to setup the Large Rod Stand away from the edge
of any table or work bench whenever possible.

➁ To prevent the Large Rod Stand from tipping or top-

pling over during experiments, be reasonable as you
setup experiments. Always be sure the Large Rod
Stand is able to rest firmly when any possible mo­tion of your experiments occur.

© 1993 PASCO scientific
This instruction sheet written/edited by: Eric Ayars

012-05338A

Equipment Included

One ME-8735 Large Rod Stand complete with two
leveling feet and two clamp screws.

Limited Warranty

PASCO scientific warrants this product to be free from
defects in materials and workmanship for a period of
one year from the date of shipment to the customer.
PASCO will repair or replace, at its option, any part of
the product which is deemed to be defective in material
or workmanship. This warranty does not cover damage
to the product caused by abuse or improper use. Deter­mination of whether a product failure is the result of a
manufacturing defect or improper use by the customer
shall be made solely by PASCO scientific. Responsi­bility for the return of equipment for warranty repair
belongs to the customer. Equipment must be properly
packed to prevent damage and shipped postage or
freight prepaid. (Damage caused by improper packing
of the equipment for return shipment will not be
covered by the warranty.) Shipping costs for returning
the equipment, after repair, will be paid by PASCO
scientific.

Equipment Return

Should the product have to be returned to PASCO
scientific for any reason, notify PASCO scientific by
letter, phone, or fax BEFORE returning the product.
Upon notification, the return authorization and
shipping instructions will be promptly issued.

ä

NOTE: NO EQUIPMENT WILL BE

ACCEPTED FOR RETURN WITHOUT AN
AUTHORIZATION FROM PASCO.

When returning equipment for repair, the units
must be packed properly. Carriers will not accept
responsibility for damage caused by improper
packing. To be certain the unit will not be
damaged in shipment, observe the following rules:

➀ The packing carton must be strong enough for the

item shipped.

➁ Make certain there are at least two inches of

packing material between any point on the
apparatus and the inside walls of the carton.

➂ Make certain that the packing material cannot shift

in the box or become compressed, allowing the
instrument come in contact with the packing
carton.

Address: PASCO scientific

10101 Foothills Blvd.
Roseville, CA 95747-7100

Phone: [phone]
FAX: [phone]
email: [e-mail]
web: www.pasco.com

2