LF9051
ENGLISH
STRUCTURE AND FUNCTIONS
1
Ready Light (Green)
Direction of Laminating
Power Cord
Power Light (Red)
3 Pin Plug
Order laminating pouches separately
Jam Release
(LF9052 & LF9051)
Temperature Control
LF9051
ENGLISH
2
OPERATION GUIDE
1
Switch the power “ON” to start. Wait 4 - 8
minutes for the machine to heat up. Green
light will indicate that the machine is
ready to use.
Select the laminating pouch according to
the size of paper/photo you want to laminate.
Place the paper/photo into the laminating
pouch. Trim/cut excess film off the sides
where necessary.
Insert laminating pouch in the front
of machine
The laminator will feed the laminating
pouch through the heat rollers to the back
of the machine. If the surface of the
laminating pouch is opaque, it means the
film did not melt completely, due to the
machine not being warm enough. Just laminate
the pouch again.
2
4
3
Cold Lamination
- For self adhesive film
Turn the selection switch to “cold”, the green light will indicate that the
machine is ready for use. Wait 40 minutes after using the hot lamination
option before using the cold lamination option. The machine needs time
to cool down.
!
Adjust the temperature according to
the laminating pouche thickness.
ENGLISH
3
SPECIFICATIONS
• Switch the machine off when not in use.
• Do not put sharp or heavy objects on top of the machines.
• If the machine is dusty or dirty, switch the machine off and then wipe
clean with a damp cloth and detergent, do not use any solvents
MAINTENANCE
Voltage (V/Hz)
Preheating time (min)
Max. Laminating
Width (mm)
Max. Laminating
Thickness (mm)
Laminating Speed
(mm/min)
Dimensions (mm)
Roller Quantity
LF9051
240V /50Hz
4 - 6
240
0.6
350
395 X 170 X 100mm
4
Jam Release Switch
Jam Reverse Switch
Up to A4
Paper size
LF9052 LF9055
3 - 5 4 - 6
340 420
0.6 1
350 350
470 X 190 X 100mm 655 X 180 X 113mm
4 4
Up to A3 Up to A2
240V /50Hz 240V /50Hz
ENGLISH
4
ENGLISH
Please make sure to use the correct voltage and not to overload
the power supply.
Ensure the machine is unplugged before moving to another
location, or when not in use.
Do not insert any other material except for the laminating pouches
into the laminator as these objects may cause malfunctions or
damage the laminator.
CAUTION
Dangerous! Don’t put your fingers into or on the laminator while in operation.
Injury or burns may occur.
Solution
BRIEF PROBLEM SHOOTING
Problem
Cause
Lamination jammed
combined with noise and
a burning smell coming
from the machine
While laminating the
machine stops working.
Indicated by the lights
going off.
Check main power
supply, if on, switch the
machine off and wait 30
min before proceeding.
If the problem persists
send the machine
for a service at a
registered service centre.
1. External power
have been switched
off.
2. The machine over
heated and the
heat protection device
cuts the power.
Turn off the power
and pull the lamination
out of the machine using
the Jam Release Switch
(LF9052 &LF9051) or
Jam Reverse (LF9055).
If the problem persists
send the machine for
a service at a registered
service centre.
1. Machine temperature
to high.
2. Excess lamination
adhering to the roller.
3. Lamination pouch
exceeds the standard
thickness.
Loading...