Paradox NV75M, NV75MX Installation Manual
NV75M/MX
Cover Tamper
Step 1
Step 3
NV75MX
NV75M
Step 2
TMPCOMALMCOM AM
YEL
GRN
123
BLK
RED
(Table 1)
Wall Mount x6
Bracket Adjustment
Screw Opening
Corner Mount
x4
Tamper Screw
Wall/Corner
Wiring Entry x2
1
2
3
4
5
UP - Pet DOWN - Creep
Installation Manual V1.0
16 Meter Indoor Dual
Mironel Optics with Anti-Mask
and Pet Immunity Dual Detector
Wall Mount
General Description
The NV75M/MX is an indoor industry-leading detector
providing superior 16 meter detection with rock solid stability
thanks to the revolutionary dual Mironel Mirror/Fresnel PIR
optics. Combined with Paradox true Pet Immunity and bestin-the industry active Anti-Mask technology (EN Grade 3).
The NV75M/MX provides an unmatched high security
solution for any indoor installation.
Installing the NV75M/MX (Fig. 1)
Please Read
Installation Height:
Pet Immune ON - 2.0m/6.6ft to 2.4m/7.8ft
Pet Immune OFF - 2.0m/6.6ft to 2.8m/9ft (lever down)*
*For installations higher than 2.6m, when needed, tilt
the detector down a few degrees for best detection
results; use of a bracket is recommended.
Power Up (30 sec.):
Powering up the detector takes about 30 seconds,
indicated with green/red flashing; indicates PIR
stabilizing.
Anti-Mask Calibration:
Once detector is stabilized, as mentioned above, open
and close the tamper to initiate. Anti-Mask calibration
may take up to 60 seconds. Keep away from the
detector, at least 2 meters / 6 feet during calibration,
indicated by flashing green/red LED. Once completed,
the detector is ready.
Bracket Mount
Creep Zone/Pet Selection
Remove detector assembly as described in Fig. 1. When
selector is UP, Pet Mode; when DOWN, Creep Zone is
active and there is no Pet Immunity. Above 2.4m Pet
Immune should be OFF (lever down Pet OFF, see
installation height note*.
Dip Switch Settings
Table 1
DIP SWITCH OFF ON (DEFAULT)
1. LED OFF ON
2. EDGE DUAL SINGLE
3. PET IMMUNE OFF ON
paradox.com
+
9m
7m
11m*
13m
16m
Sensitivity Settings
LED Display
Feature LED Status Indicator
Tamper open Green: ON for 0.3 seconds every 30
seconds
PIR sensitivity level
setting
Alarm detection Red: ON for 3 seconds
Booting/Tamper
close
Anti-mask detection Flashes orange rapidly (pre-alarm
Green: Flashes 1-5 times according
to the selected level
Green/Red alternating flashes
for 45 seconds
state) and then constant orange
when in alarm.
NV75M-EI00 04/2016
Programming the NV75MX via Keypad or
1.5m 3m 5.5m 10m
16m
(52 ft)
90˚
1.5m3m5.5m 12m10m12m
16m
(52 ft)
Creep
Zone
0m 60cm
Creep
Zone
60cm
10m5.5m3m1.5m
Creep
Zone
16m
(52 ft)
60cm
12m
Detector 1 Detect or 2 Both Detectors
2.1m
Optimal
2.8m
2.4m
Pet Immune ON
Pet Immune OFF
3m1.5
Z
60
D
1
D
2.1m
Optimal
2.8m
2.4m
2.1m
.8m
m
2.1m
Optimal
2.8m
2.4m
* Read installation height note*
BabyWare
Via Keypad
1. Enter EVO Installer Programming Mode, programming
section 4003.
2. Enter the detector’s 8-digit Serial Number. Enter the
3-digit Section as per Table 2.
Table 2
Section [001]:
Bit Function Status/Description
[1] LED ON: LED ON (default) OFF: LED OFF
Section [002]:
Bit Function Status/Description
[3] Pet
O
N: PET ON (default) OFF: Pet OFF
Immune
[4] Edge O
N: Single (default) OFF: Dual
Section [003]: 000 (Low) to 004 (Max)
Via BabyWare
1. Double-click the serial number of the NV75MX to open
the detector’s programming.
2. Configure the required settings .
Beam Patterns
Technical Specifications
Specification Description
IR Movement
Detection
Optics Two Mirone l Mirror/W Fresnel optics
Coverage 16 meters/52 feet; 90° - complies
Anti-Masking Active IR with Dual detectors,
Pet Immunity Pet up to 50cm will not be detected
Single/Dual Edge Infrared detection requires entry or
Creep Zone Mechanically selectable Creep Zone
Power - Wired
Models
Operating
Temperature
Relative humidity 95% non-condensing
Tamper Dual - Cover and Wall
Dimensions 128 x 62 x 54 mm/ 5.1 x 2.4 x2.1 in
Weight 120 gr/ 0.3 lb
Certifications CE, EN50131-2-2 Grade 3, Class II
2 detectors, 2 dual element sensors,
2 Mironel Optics
with mechanical Pet / Creep Zone
with EN50131-2-2 Grade 3
blocking items up to 30cm and lens
applied materials including clear
lacquer; meets and exceeds
EN50131-2-2 Grade 3.
exit in single-mode; in Dual-edge,
entry and exit is required for both
detectors
detection 1.5m/4ft. (cancels Pet
Immunity when active)
NV75M/NV75MX 23mA
-35º to 50º C (-31º to 122º F)
Top View
Warranty
For complete warranty information on this product, please refer to the Limited Warranty Statement is found on the website: www.paradox.com/terms or
contact your local distributor. Specifications may change without prior notice.
Patents
US, Canadian and international patents may apply. Paradox is a trademark or registered trademark of Paradox Security Systems (Bahamas) Ltd.
paradox.com
2
2.4
cm
Creep
one
etector
Side View
m
etector
NV75M-EI00 04/2016
Loading...