Installation Manual
Additional Digital Cordless Handset
Model No. KX-TGEA20
KX-TGHA20
KX-TGEA20 |
KX-TGHA20 |
Thank you for purchasing a Panasonic product.
This unit is an additional handset compatible with the following series of Panasonic Digital Cordless Phone:
-KX-TGE210/KX-TGE230/KX-TGE240/KX-TGE260/KX-TGE270 (KX-TGEA20)
-KX-TGH260 (KX-TGHA20)
(The corresponding models are subject to change without notice.)
You must register this handset with your base unit before it can be used. This installation manual describes only the steps needed to register and begin using the handset. Please read the base unit’s operating instructions for further details.
Please read this installation manual before using the unit and save it for future reference.
For assistance, visit our Web site: http://www.panasonic.com/help for customers in the U.S.A. or Puerto Rico.
Printed in Malaysia
TGEA _ TGHA20(en) _ 1004 _ ver001.pdf |
1 |
PNQX6369ZA PT1213MG0
2013/10/04 18:56:56
Supplied accessories
Accessory item/Order number |
Quantity |
Charger*1 |
1 |
AC adaptor/PNLV233Z |
1 |
Rechargeable batteries/HHR-4DPA |
2 |
Handset cover*2, *3 |
1 |
Belt clip (KX-TGEA20)*4 |
1 |
*1 KX-TGEA20: PNLC1050ZB KX-TGHA20: PNLC1051ZB
*2 The handset cover comes attached to the handset.
*3 KX-TGEA20: PNYNTGEA20BR (Black), PNYNTGEA20SR (Silver) KX-TGHA20: PNYNTGHA20BR
*4 PNKE1312Z2 (Black), PNKE1312Z1 (Silver)
Note:
RPlease read the base unit’s operating instructions for additional/replacement accessories.
–Optional headsets (KX-TGEA20): KX-TCA60, KX-TCA93, KX-TCA400, KX-TCA430
Connections/Wall mounting
Connect the AC adaptor to the power outlet.
Drive the screws () (not supplied) into the wall, if necessary. ( ) 27.2 mm (11/16 inches)
2
1
1
2For assistance, please visit http://www.panasonic.com/help
TGEA _ TGHA20(en) _ 1004 _ ver001.pdf |
2 |
2013/10/04 |
18:56:56 |
Installation
Note:
RUse only the supplied Panasonic AC adaptor PNLV233.
RThe AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.)
RMake sure that the wall and the fixing method are strong enough to support the weight of the unit.
Battery installation/Battery charging
Important:
RUse the supplied rechargeable batteries. For replacement, we recommend using the Panasonic rechargeable batteries noted on page 2.
RUSE ONLY rechargeable Ni-MH batteries AAA (R03) size (1).
RDo NOT use Alkaline/Manganese/Ni-Cd batteries.
RConfirm correct polarities (, ).
Charge for about 7 hours.
RConfirm “Charging” is displayed (2).
RWhen the batteries are fully charged, “Fully charged” is displayed.
2
1
RModel shown is KX-TGEA20.
Note:
RIf the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (,
) and the charge contacts with a dry cloth and charge again.
Registering a handset to a base unit
1Base unit:
Press and hold MLOCATORN or MHANDSET LOCATORN for about 5 seconds. R Depending on the base unit, a registration tone sounds.
For assistance, please visit http://www.panasonic.com/help |
3 |
TGEA _ TGHA20(en) _ 1004 _ ver001.pdf |
3 |
2013/10/04 |
18:56:56 |
Installation
RIf all registered handsets start ringing, press MLOCATORN or MHANDSET LOCATORN again to stop, then repeat this step.
2Handset:
Place the handset on the base unit or charger, then wait until a long beep sounds and is displayed.
Note:
RIf an error tone sounds, or if is displayed, register the handset according to the base unit’s operating instructions.
Display language
1MMENUN (right soft key) #110
2MbN: Select the desired setting. a MSAVEN a MOFFN
To prevent severe injury and loss of life/property, read this section carefully before using the product to ensure proper and safe operation of your product.
WARNING
Power connection
RCompletely insert the AC adaptor/power plug into the power outlet. Failure to do so may cause electric shock and/or excessive heat resulting in a fire.
RRegularly remove any dust, etc. from the AC adaptor/power plug by pulling it from the power outlet, then wiping with a dry cloth. Accumulated dust may cause an insulation defect from moisture, etc. resulting in a fire.
RUnplug the product from power outlets if it emits smoke, an abnormal smell, or makes an unusual noise. These conditions can cause fire or electric shock. Confirm that smoke has stopped emitting and contact the Panasonic Call Center at 1-800-211- PANA (1-800-211-7262).
Installation
RTo prevent the risk of fire or electrical shock, do not expose the product to rain or any type of moisture.
RDo not place or use this product near automatically controlled devices such as automatic doors and fire alarms. Radio waves emitted from this product may cause such devices to malfunction resulting in an accident.
4For assistance, please visit http://www.panasonic.com/help
TGEA _ TGHA20(en) _ 1004 _ ver001.pdf |
4 |
2013/10/04 |
18:56:56 |